Based on Repetier-Firmware - the fast and user friendly firmware.
The firmware is compiled and downloaded with Arduino V 1.0.5 or later.
- Current stable release.
For documentation please visit http://www.repetier.com/documentation/repetier-firmware/
This variant of the Repetier-firmware has been optimized for the use with the Renkforce RF1000 3D Printer of Conrad Electronic SE. The firmware adds functionality which is not available within the standard Repetier-firmware and uses the settings which match the available hardware.
The main differences to the standard Repetier-firmware are:
- Support for the RF1000 motherboard.
- Support for the RF1000 feature controller (= 6 additional hardware buttons).
- Support for motor current control via the TI DRV8711.
- Support for an external watchdog via the TI TPS382x.
- Printing can be paused/continued via a hardware button.
- Heat bed scan and Z-compensation via the built-in strain gauge of the extruder.
- Automatic emergency pause in case the strain gauge delivers too high measurements.
- Additional M-codes have been defined in order to control the RF1000-specific functionality.
- There is no support for the ArduinoDUE.
See changelog.txt