This is a firmware project for the STM32 microcontroller.
\Libraries # STM32 Standard Peripheral Library
\CMSIS
\STM32F10x_StdPeriph_Drive
Makefile
debug.c # Functions used for debbuging ( turn on/off corresponding
debug.h # LED or send data to Hyperterminal )
enc28j60.c # Driver for ENC28J60 module
enc28j60.h
gpio.c # Functions for init and work with GPIO ports
gpio.h
ip_arp_udp_tcp.c # TCP/IP stack driver
ip_arp_udp_tcp.h
spi.c # Functions for init and work with SPI1
spi.h
simple_server.c # HTTP server
simple_server.h
net.h # TCP/IP flags
timer.c # Functions for init and work with TIM2
timer.h
usart.c # Functions for init and work with USART1
usart.h
startup_stm32f10x_hd.c # Board startup file
stm32f103vet6.ld # Linker script
main.c # Main entry function
Makefile # Makefile of project
This project runs on STM32 Development Board ( STM32F103VET6 ) and can be easily tailored to any other STM32 Development Board. In addition to the board, the following components are also used: ENC28J60 Ethernet LAN Network Module, USB 2.0 to TTL UART 6PIN CP2102 Module and Infrared PIR Motion Sensor Detector Module.
-
STM32F103VET6
- CP2102 module connected to corresponding USART1 pins on board
- MOSI, MOSI and CLK pins of ENC28J60 module connected to corresponding SPI1 pins on board
- CS and RESET pins of ENC28J60 module connected to GPIOA Pin 4 and PIN 3 of board
- PIR sensor connected to GPIOA Pin 1
-
Hyperterminal configuration:
- Word Length = 8 Bits
- One Stop Bit
- No parity
- BaudRate = 115200 baud
- flow control: None
To compile the project first run Makefile in Libraries folder and then
run Makefile in main project folder. To burn the project firmware to a
board using usart bootloader you can use tool stm32flash.
Example:
stm32flash -w presence_detector.bin -v -g 0x0 /dev/ttyUSB0
- Tomislav Denis
- Tomislav Grbin
- Krunoslav Zaher