/**
* Deliver datagram as raw data
*
* @v intf Data transfer interface
* @v data Data
* @v len Length of data
* @v meta Data transfer metadata
* @ret rc Return status code
*/
int xfer_deliver_raw_meta ( struct interface *intf, const void *data,
size_t len, struct xfer_metadata *meta ) {
struct io_buffer *iobuf;
iobuf = xfer_alloc_iob ( intf, len );
if ( ! iobuf )
return -ENOMEM;
memcpy ( iob_put ( iobuf, len ), data, len );
return xfer_deliver ( intf, iobuf, meta );
}
/**
* Seek to position
*
* @v intf Data transfer interface
* @v offset Offset to new position
* @ret rc Return status code
*/
int xfer_seek ( struct interface *intf, off_t offset ) {
struct io_buffer *iobuf;
struct xfer_metadata meta = {
.flags = XFER_FL_ABS_OFFSET,
.offset = offset,
};
DBGC ( INTF_COL ( intf ), "INTF " INTF_FMT " seek to %ld\n",
INTF_DBG ( intf ), offset );
/* Allocate and send a zero-length data buffer */
iobuf = xfer_alloc_iob ( intf, 0 );
if ( ! iobuf )
return -ENOMEM;
return xfer_deliver ( intf, iobuf, &meta );
}
/**
* UDP WRITE
*
* @v pxenv_udp_write Pointer to a struct s_PXENV_UDP_WRITE
* @v s_PXENV_UDP_WRITE::ip Destination IP address
* @v s_PXENV_UDP_WRITE::gw Relay agent IP address, or 0.0.0.0
* @v s_PXENV_UDP_WRITE::src_port Source UDP port, or 0
* @v s_PXENV_UDP_WRITE::dst_port Destination UDP port
* @v s_PXENV_UDP_WRITE::buffer_size Length of the UDP payload
* @v s_PXENV_UDP_WRITE::buffer Address of the UDP payload
* @ret #PXENV_EXIT_SUCCESS Packet was transmitted successfully
* @ret #PXENV_EXIT_FAILURE Packet could not be transmitted
* @ret s_PXENV_UDP_WRITE::Status PXE status code
* @err #PXENV_STATUS_UDP_CLOSED UDP connection is not open
* @err #PXENV_STATUS_UNDI_TRANSMIT_ERROR Could not transmit packet
*
* Transmits a single UDP packet. A valid IP and UDP header will be
* prepended to the payload in s_PXENV_UDP_WRITE::buffer; the buffer
* should not contain precomputed IP and UDP headers, nor should it
* contain space allocated for these headers. The first byte of the
* buffer will be transmitted as the first byte following the UDP
* header.
*
* If s_PXENV_UDP_WRITE::gw is 0.0.0.0, normal IP routing will take
* place. See the relevant @ref pxe_routing "implementation note" for
* more details.
*
* If s_PXENV_UDP_WRITE::src_port is 0, port 2069 will be used.
*
* You must have opened a UDP connection with pxenv_udp_open() before
* calling pxenv_udp_write().
*
* On x86, you must set the s_PXE::StatusCallout field to a nonzero
* value before calling this function in protected mode. You cannot
* call this function with a 32-bit stack segment. (See the relevant
* @ref pxe_x86_pmode16 "implementation note" for more details.)
*
* @note Etherboot currently ignores the s_PXENV_UDP_WRITE::gw
* parameter.
*
*/
PXENV_EXIT_t pxenv_udp_write ( struct s_PXENV_UDP_WRITE *pxenv_udp_write ) {
struct sockaddr_in dest;
struct xfer_metadata meta = {
.src = ( struct sockaddr * ) &pxe_udp.local,
.dest = ( struct sockaddr * ) &dest,
.netdev = pxe_netdev,
};
size_t len;
struct io_buffer *iobuf;
userptr_t buffer;
int rc;
DBG ( "PXENV_UDP_WRITE" );
/* Construct destination socket address */
memset ( &dest, 0, sizeof ( dest ) );
dest.sin_family = AF_INET;
dest.sin_addr.s_addr = pxenv_udp_write->ip;
dest.sin_port = pxenv_udp_write->dst_port;
/* Set local (source) port. PXE spec says source port is 2069
* if not specified. Really, this ought to be set at UDP open
* time but hey, we didn't design this API.
*/
pxe_udp.local.sin_port = pxenv_udp_write->src_port;
if ( ! pxe_udp.local.sin_port )
pxe_udp.local.sin_port = htons ( 2069 );
/* FIXME: we ignore the gateway specified, since we're
* confident of being able to do our own routing. We should
* probably allow for multiple gateways.
*/
/* Allocate and fill data buffer */
len = pxenv_udp_write->buffer_size;
iobuf = xfer_alloc_iob ( &pxe_udp.xfer, len );
if ( ! iobuf ) {
DBG ( " out of memory\n" );
pxenv_udp_write->Status = PXENV_STATUS_OUT_OF_RESOURCES;
return PXENV_EXIT_FAILURE;
}
buffer = real_to_user ( pxenv_udp_write->buffer.segment,
pxenv_udp_write->buffer.offset );
copy_from_user ( iob_put ( iobuf, len ), buffer, 0, len );
DBG ( " %04x:%04x+%x %d->%s:%d\n", pxenv_udp_write->buffer.segment,
pxenv_udp_write->buffer.offset, pxenv_udp_write->buffer_size,
ntohs ( pxenv_udp_write->src_port ),
inet_ntoa ( dest.sin_addr ),
ntohs ( pxenv_udp_write->dst_port ) );
/* Transmit packet */
if ( ( rc = xfer_deliver ( &pxe_udp.xfer, iobuf, &meta ) ) != 0 ) {
DBG ( "PXENV_UDP_WRITE could not transmit: %s\n",
strerror ( rc ) );
pxenv_udp_write->Status = PXENV_STATUS ( rc );
return PXENV_EXIT_FAILURE;
}
pxenv_udp_write->Status = PXENV_STATUS_SUCCESS;
return PXENV_EXIT_SUCCESS;
}
/**
* UDP READ
*
* @v pxenv_udp_read Pointer to a struct s_PXENV_UDP_READ
* @v s_PXENV_UDP_READ::dest_ip Destination IP address, or 0.0.0.0
* @v s_PXENV_UDP_READ::d_port Destination UDP port, or 0
* @v s_PXENV_UDP_READ::buffer_size Size of the UDP payload buffer
* @v s_PXENV_UDP_READ::buffer Address of the UDP payload buffer
* @ret #PXENV_EXIT_SUCCESS A packet has been received
* @ret #PXENV_EXIT_FAILURE No packet has been received
* @ret s_PXENV_UDP_READ::Status PXE status code
* @ret s_PXENV_UDP_READ::src_ip Source IP address
* @ret s_PXENV_UDP_READ::dest_ip Destination IP address
* @ret s_PXENV_UDP_READ::s_port Source UDP port
* @ret s_PXENV_UDP_READ::d_port Destination UDP port
* @ret s_PXENV_UDP_READ::buffer_size Length of UDP payload
* @err #PXENV_STATUS_UDP_CLOSED UDP connection is not open
* @err #PXENV_STATUS_FAILURE No packet was ready to read
*
* Receive a single UDP packet. This is a non-blocking call; if no
* packet is ready to read, the call will return instantly with
* s_PXENV_UDP_READ::Status==PXENV_STATUS_FAILURE.
*
* If s_PXENV_UDP_READ::dest_ip is 0.0.0.0, UDP packets addressed to
* any IP address will be accepted and may be returned to the caller.
*
* If s_PXENV_UDP_READ::d_port is 0, UDP packets addressed to any UDP
* port will be accepted and may be returned to the caller.
*
* You must have opened a UDP connection with pxenv_udp_open() before
* calling pxenv_udp_read().
*
* On x86, you must set the s_PXE::StatusCallout field to a nonzero
* value before calling this function in protected mode. You cannot
* call this function with a 32-bit stack segment. (See the relevant
* @ref pxe_x86_pmode16 "implementation note" for more details.)
*
* @note The PXE specification (version 2.1) does not state that we
* should fill in s_PXENV_UDP_READ::dest_ip and
* s_PXENV_UDP_READ::d_port, but Microsoft Windows' NTLDR program
* expects us to do so, and will fail if we don't.
*
*/
PXENV_EXIT_t pxenv_udp_read ( struct s_PXENV_UDP_READ *pxenv_udp_read ) {
struct in_addr dest_ip_wanted = { .s_addr = pxenv_udp_read->dest_ip };
struct in_addr dest_ip;
uint16_t d_port_wanted = pxenv_udp_read->d_port;
uint16_t d_port;
/* Try receiving a packet */
pxe_udp.pxenv_udp_read = pxenv_udp_read;
step();
if ( pxe_udp.pxenv_udp_read ) {
/* No packet received */
DBG2 ( "PXENV_UDP_READ\n" );
pxe_udp.pxenv_udp_read = NULL;
goto no_packet;
}
dest_ip.s_addr = pxenv_udp_read->dest_ip;
d_port = pxenv_udp_read->d_port;
DBG ( "PXENV_UDP_READ" );
/* Filter on destination address and/or port */
if ( dest_ip_wanted.s_addr &&
( dest_ip_wanted.s_addr != dest_ip.s_addr ) ) {
DBG ( " wrong IP %s", inet_ntoa ( dest_ip ) );
DBG ( " (wanted %s)\n", inet_ntoa ( dest_ip_wanted ) );
goto no_packet;
}
if ( d_port_wanted && ( d_port_wanted != d_port ) ) {
DBG ( " wrong port %d", htons ( d_port ) );
DBG ( " (wanted %d)\n", htons ( d_port_wanted ) );
goto no_packet;
}
DBG ( " %04x:%04x+%x %s:", pxenv_udp_read->buffer.segment,
pxenv_udp_read->buffer.offset, pxenv_udp_read->buffer_size,
inet_ntoa ( *( ( struct in_addr * ) &pxenv_udp_read->src_ip ) ));
DBG ( "%d<-%s:%d\n", ntohs ( pxenv_udp_read->s_port ),
inet_ntoa ( *( ( struct in_addr * ) &pxenv_udp_read->dest_ip ) ),
ntohs ( pxenv_udp_read->d_port ) );
pxenv_udp_read->Status = PXENV_STATUS_SUCCESS;
return PXENV_EXIT_SUCCESS;
no_packet:
pxenv_udp_read->Status = PXENV_STATUS_FAILURE;
return PXENV_EXIT_FAILURE;
}
/**
* Deliver datagram as I/O buffer without metadata
*
* @v intf Data transfer interface
* @v iobuf Datagram I/O buffer
* @ret rc Return status code
*/
int xfer_deliver_iob ( struct interface *intf, struct io_buffer *iobuf ) {
return xfer_deliver ( intf, iobuf, &dummy_metadata );
}