PERIDOT(ペリドット)はPhysicaloidに対応したArduinoフォームファクタのFPGA基板です。 Physicaloidライブラリを利用することで、AndroidやGoogle Chromeからのフィジカルコンピューティングを可能にします。
'PERIDOT' is a FPGA board Arduino form factor corresponding to the Physicaloid. By taking advantage of Physicaloid library, allowing you to physical computing from Google Chrome and Android.
-
Android/Chromeからのコンフィグレーション
-
USBシリアルインターフェース経由でのFPGA内部へのアクセス
-
ALTERA CycloneIV E (EP4CE6E22C8N)搭載
-
64Mbit SDRAM (up to 133MHz)搭載
-
28本のユーザーI/O
-
スタンドアロン動作をサポート
-
USB給電のみで動作OK (過電流保護回路搭載)
-
Arduinoシールドの流用可能(動作条件あり)
-
オープンソース (クリエイティブコモンズ・CC BY 2.1)
-
Configuration from the Android / Chrome.
-
Provides access to the FPGA inside of a USB serial interface via.
-
ALTERA CycloneIV E(EP4CE6E22C8N)
-
64Mbit SDRAM (up to 133MHz)
-
User I/O of the 28 pins
-
Support a stand-alone operation.
-
Only USB power supply (On-board overcurrent protection).
-
Possible diversion of Arduino shield (Due or later).
-
Open-source (Creative Commons, CC BY 2.1)
-
Manual RESET Key システム全体のマニュアルリセットを行います。
-
JTAG Connector FPGAのJTAGピンが配置されています。
-
Config MODE Selector ボードのコンフィグモードを切り替えます。スタンドアロンで動作させる場合はAS側に、ホストからPhysicaloidライブラリでコンフィグを行う場合はPS側にセットします。
-
Power supply and RESET シールドへの電源供給とリセット信号が出力されます。電源は3.3V/100mA、USB 5V/100mAが使用できます。最大電流はUSBホストで制限されます。
-
Digital I/O FPGAのI/Oピンが配置されています。3.3Vを超える電圧を印加しないで下さい。
-
Manual RESET Key Manual reset of the entire system.
-
JTAG Connector JTAG pins of the FPGA are located.
-
Config MODE Selector Switching configuration mode of the board. Set the AS side when operating in a stand-alone. Set PS side when performing configuration in Physicaloid library from the host.
-
Power supply and RESET It outputs a reset signal and power supply to the shield. Power can be used 3.3V/100mA, USB 5V/100mA. Maximum current is limited by the USB host.
-
Digital I/O I/O pins of the FPGA are located. Do not apply a voltage of more than 3.3V.
(*1) ASDIはスタンドアロンモードでのみ有効になります。 (*2) スタンドアロンモードではリコンフィグキーになります。
(*1) ASDI is only available in stand-alone mode. (*2) It becomes the reconfiguration key in stand-alone mode.
PERIDOT Hardware is released under the Creative Commons,CC BY 2.1 JP