/*******************************************************************************
* Function Name: BLEIOT_UART_UartGetByte
********************************************************************************
*
* Summary:
* Retrieves the next data element from the receive buffer, returns the
* received byte and error condition.
* - The RX software buffer is disabled: returns the data element retrieved
* from the RX FIFO. Undefined data will be returned if the RX FIFO is
* empty.
* - The RX software buffer is enabled: returns data element from the
* software receive buffer.
*
* Parameters:
* None
*
* Return:
* Bits 7-0 contain the next data element from the receive buffer and
* other bits contain the error condition.
*
* Side Effects:
* The errors bits may not correspond with reading characters due to RX FIFO
* and software buffer usage.
* RX software buffer is disabled: The internal software buffer overflow
* is not returned as status by this function.
* Check SCB_rxBufferOverflow to capture that error condition.
*
*******************************************************************************/
uint32 BLEIOT_UART_UartGetByte(void)
{
uint32 rxData;
uint32 tmpStatus;
#if (BLEIOT_UART_CHECK_RX_SW_BUFFER)
{
BLEIOT_UART_DisableInt();
}
#endif
if (0u != BLEIOT_UART_SpiUartGetRxBufferSize())
{
/* Enables interrupt to receive more bytes: at least one byte is in
* buffer.
*/
#if (BLEIOT_UART_CHECK_RX_SW_BUFFER)
{
BLEIOT_UART_EnableInt();
}
#endif
/* Get received byte */
rxData = BLEIOT_UART_SpiUartReadRxData();
}
else
{
/* Reads a byte directly from RX FIFO: underflow is raised in the case
* of empty. Otherwise the first received byte will be read.
*/
rxData = BLEIOT_UART_RX_FIFO_RD_REG;
/* Enables interrupt to receive more bytes.
* The RX_NOT_EMPTY interrupt is cleared by the interrupt routine
* in case the byte was received and read by code above.
*/
#if (BLEIOT_UART_CHECK_RX_SW_BUFFER)
{
BLEIOT_UART_EnableInt();
}
#endif
}
/* Get and clear RX error mask */
tmpStatus = (BLEIOT_UART_GetRxInterruptSource() & BLEIOT_UART_INTR_RX_ERR);
BLEIOT_UART_ClearRxInterruptSource(BLEIOT_UART_INTR_RX_ERR);
/* Puts together data and error status:
* MP mode and accept address: 9th bit is set to notify mark.
*/
rxData |= ((uint32) (tmpStatus << 8u));
return (rxData);
}
/*******************************************************************************
* Function Name: BLEIOT_UART_ScbModeEnableIntr
********************************************************************************
*
* Summary:
* Enables an interrupt for a specific mode.
*
* Parameters:
* None
*
* Return:
* None
*
*******************************************************************************/
static void BLEIOT_UART_ScbEnableIntr(void)
{
#if (BLEIOT_UART_SCB_IRQ_INTERNAL)
/* Enable interrupt in NVIC */
#if (BLEIOT_UART_SCB_MODE_UNCONFIG_CONST_CFG)
if (0u != BLEIOT_UART_scbEnableIntr)
{
BLEIOT_UART_EnableInt();
}
#else
BLEIOT_UART_EnableInt();
#endif /* (BLEIOT_UART_SCB_MODE_UNCONFIG_CONST_CFG) */
#endif /* (BLEIOT_UART_SCB_IRQ_INTERNAL) */
}
