static void iosf_write_port(uint32_t cr, int reg, uint32_t val)
{
cr |= IOSF_REG(reg) | IOSF_BYTE_EN;
write_iosf_reg(MDR_REG, val);
write_iosf_reg(MCRX_REG, IOSF_REG_UPPER(reg));
write_iosf_reg(MCR_REG, cr);
}
/* Common sequences for all the port accesses. */
static uint32_t iosf_read_port(uint32_t cr, int reg)
{
cr |= IOSF_REG(reg) | IOSF_BYTE_EN;
write_iosf_reg(MCRX_REG, IOSF_REG_UPPER(reg));
write_iosf_reg(MCR_REG, cr);
return read_iosf_reg(MDR_REG);
}
static void setup_mmconfig(void)
{
uint32_t reg;
/* Set up the MMCONF range. The register lives in the BUNIT. The
* IO variant of the config access needs to be used initially to
* properly configure as the IOSF access registers live in PCI
* config space. */
reg = 0;
/* Clear the extended register. */
pci_io_write_config32(IOSF_PCI_DEV, MCRX_REG, reg);
reg = CONFIG_MMCONF_BASE_ADDRESS | 1;
pci_io_write_config32(IOSF_PCI_DEV, MDR_REG, reg);
reg = IOSF_OPCODE(IOSF_OP_WRITE_BUNIT) | IOSF_PORT(IOSF_PORT_BUNIT) |
IOSF_REG(BUNIT_MMCONF_REG) | IOSF_BYTE_EN;
pci_io_write_config32(IOSF_PCI_DEV, MCR_REG, reg);
}
/* This sequence signals the PUNIT to start running. */
void punit_init(void)
{
uint32_t reg;
uint8_t rid;
const struct device *dev;
const struct soc_intel_baytrail_config *cfg = NULL;
rid = pci_read_config8(IOSF_PCI_DEV, REVID);
dev = dev_find_slot(0, PCI_DEVFN(SOC_DEV, SOC_FUNC));
if (dev)
cfg = dev->chip_info;
reg = iosf_punit_read(SB_BIOS_CONFIG);
/* Write bits 17:16 of SB_BIOS_CONFIG in the PUNIT. */
reg |= SB_BIOS_CONFIG_PERF_MODE | SB_BIOS_CONFIG_PDM_MODE;
/* Configure VR low power mode for C0 and above. */
if (rid >= RID_C_STEPPING_START && cfg != NULL &&
(cfg->vnn_ps2_enable || cfg->vcc_ps2_enable)) {
printk(BIOS_DEBUG, "Enabling VR PS2 mode: ");
if (cfg->vnn_ps2_enable) {
reg |= SB_BIOS_CONFIG_PS2_EN_VNN;
printk(BIOS_DEBUG, "VNN ");
}
if (cfg->vcc_ps2_enable) {
reg |= SB_BIOS_CONFIG_PS2_EN_VCC;
printk(BIOS_DEBUG, "VCC ");
}
printk(BIOS_DEBUG, "\n");
}
iosf_punit_write(SB_BIOS_CONFIG, reg);
/* Write bits 1:0 of BIOS_RESET_CPL in the PUNIT. */
reg = BIOS_RESET_CPL_ALL_DONE | BIOS_RESET_CPL_RESET_DONE;
pci_write_config32(IOSF_PCI_DEV, MDR_REG, reg);
reg = IOSF_OPCODE(IOSF_OP_WRITE_PMC) | IOSF_PORT(IOSF_PORT_PMC) |
IOSF_REG(BIOS_RESET_CPL) | IOSF_BYTE_EN_0;
pci_write_config32(IOSF_PCI_DEV, MCR_REG, reg);
}
