/*
* Minimal set of commands to read WPSR from SPI.
* Don't use this code outside romstage -- it trashes the opmenu table.
* Returns 0 on success, < 0 on failure.
*/
int early_spi_read_wpsr(u8 *sr)
{
int retry;
/* No address associated with rdsr */
SPIBAR8(SPIBAR_OPTYPE) = 0x0;
/* Setup opcode[0] = read wpsr */
SPIBAR8(SPIBAR_OPMENU_LOWER) = 0x5;
/* Start transaction */
SPIBAR16(SPIBAR_SSFC) = SPIBAR_SSFC_DATA | SPIBAR_SSFC_GO;
/* Wait for error / complete status */
for (retry = SPI_RETRY; retry; retry--) {
u16 status = SPIBAR16(SPIBAR_SSFS);
if (status & SPIBAR_SSFS_ERROR) {
printk(BIOS_ERR, "SPI rdsr failed\n");
return -1;
} else if (status & SPIBAR_SSFS_DONE) {
break;
}
udelay(SPI_DELAY);
}
*sr = SPIBAR32(SPIBAR_FDATA(0)) & 0xff;
return 0;
}
static void set_spi_speed(void)
{
u32 fdod;
u8 ssfc;
/* Observe SPI Descriptor Component Section 0 */
SPIBAR32(SPIBAR_FDOC) = 0x1000;
/* Extract the Write/Erase SPI Frequency from descriptor */
fdod = SPIBAR32(SPIBAR_FDOD);
fdod >>= 24;
fdod &= 7;
/* Set Software Sequence frequency to match */
ssfc = SPIBAR8(SPIBAR_SSFC + 2);
ssfc &= ~7;
ssfc |= fdod;
SPIBAR8(SPIBAR_SSFC + 2) = ssfc;
}
