static void jz_stop_ohc(struct platform_device *dev)
{
printk(KERN_DEBUG __FILE__
": stopping JZ OHCI USB Controller\n");
#ifdef CONFIG_SOC_JZ4750
__cpm_suspend_uhcphy();
#endif
__cpm_stop_uhc();
}
static int jz_pm_do_sleep(void)
{
unsigned long delta;
unsigned long nfcsr = REG_EMC_NFCSR;
unsigned long opcr = REG_CPM_OPCR;
unsigned long imr = REG_INTC_IMR;
unsigned long sadc = REG_SADC_ENA;
unsigned long sleep_gpio_save[7*(GPIO_PORT_NUM-1)];
printk("Put CPU into sleep mode.\n");
/* Preserve current time */
delta = xtime.tv_sec - REG_RTC_RSR;
/* Disable nand flash */
REG_EMC_NFCSR = ~0xff;
/* stop sadc */
REG_SADC_ENA &= ~0x7;
while((REG_SADC_ENA & 0x7) != 0);
udelay(100);
/*stop udc and usb*/
__cpm_suspend_uhcphy();
__cpm_suspend_udcphy();
/* Sleep on-board modules */
jz_board_do_sleep(sleep_gpio_save);
/* Mask all interrupts */
REG_INTC_IMSR = 0xffffffff;
/* Just allow following interrupts to wakeup the system.
* Note: modify this according to your system.
*/
/* enable RTC alarm */
__intc_unmask_irq(IRQ_RTC);
#if 0
/* make system wake up after n seconds by RTC alarm */
unsigned int v, n;
n = 10;
while (!__rtc_write_ready());
__rtc_enable_alarm();
while (!__rtc_write_ready());
__rtc_enable_alarm_irq();
while (!__rtc_write_ready());
v = __rtc_get_second();
while (!__rtc_write_ready());
__rtc_set_alarm_second(v+n);
#endif
/* WAKEUP key */
__gpio_as_irq_rise_edge(GPIO_WAKEUP);
__gpio_unmask_irq(GPIO_WAKEUP);
__intc_unmask_irq(IRQ_GPIO0 - (GPIO_WAKEUP/32)); /* unmask IRQ_GPIOn depends on GPIO_WAKEUP */
/* disable externel clock Oscillator in sleep mode */
__cpm_disable_osc_in_sleep();
/* select 32K crystal as RTC clock in sleep mode */
__cpm_select_rtcclk_rtc();
/* Enter SLEEP mode */
REG_CPM_LCR &= ~CPM_LCR_LPM_MASK;
REG_CPM_LCR |= CPM_LCR_LPM_SLEEP;
__asm__(".set\tmips3\n\t"
"wait\n\t"
".set\tmips0");
/* Restore to IDLE mode */
REG_CPM_LCR &= ~CPM_LCR_LPM_MASK;
REG_CPM_LCR |= CPM_LCR_LPM_IDLE;
/* Restore nand flash control register */
REG_EMC_NFCSR = nfcsr;
/* Restore interrupts */
REG_INTC_IMSR = imr;
REG_INTC_IMCR = ~imr;
/* Restore sadc */
REG_SADC_ENA = sadc;
/* Resume on-board modules */
jz_board_do_resume(sleep_gpio_save);
/* Restore Oscillator and Power Control Register */
REG_CPM_OPCR = opcr;
/* Restore current time */
xtime.tv_sec = REG_RTC_RSR + delta;
return 0;
}
