int board_late_init(void)
{
setup_board_eeprom_env();
u8 val;
/*
* DEV_CTRL.DEV_ON = 1 please - else palmas switches off in 8 seconds
* This is the POWERHOLD-in-Low behavior.
*/
palmas_i2c_write_u8(TPS65903X_CHIP_P1, 0xA0, 0x1);
/*
* Default FIT boot on HS devices. Non FIT images are not allowed
* on HS devices.
*/
if (get_device_type() == HS_DEVICE)
env_set("boot_fit", "1");
/*
* Set the GPIO7 Pad to POWERHOLD. This has higher priority
* over DEV_CTRL.DEV_ON bit. This can be reset in case of
* PMIC Power off. So to be on the safer side set it back
* to POWERHOLD mode irrespective of the current state.
*/
palmas_i2c_read_u8(TPS65903X_CHIP_P1, TPS65903X_PRIMARY_SECONDARY_PAD2,
&val);
val = val | TPS65903X_PAD2_POWERHOLD_MASK;
palmas_i2c_write_u8(TPS65903X_CHIP_P1, TPS65903X_PRIMARY_SECONDARY_PAD2,
val);
omap_die_id_serial();
omap_set_fastboot_vars();
am57x_idk_lcd_detect();
#if !defined(CONFIG_SPL_BUILD)
board_ti_set_ethaddr(2);
#endif
return 0;
}
int board_late_init(void)
{
#if !defined(CONFIG_SPL_BUILD) && defined(CONFIG_TI_I2C_BOARD_DETECT)
int rc;
rc = ti_i2c_eeprom_am_get(CONFIG_EEPROM_BUS_ADDRESS,
CONFIG_EEPROM_CHIP_ADDRESS);
if (rc)
printf("ti_i2c_eeprom_init failed %d\n", rc);
board_ti_set_ethaddr(1);
#endif
#ifdef CONFIG_ENV_VARS_UBOOT_RUNTIME_CONFIG
if (board_is_k2g_gp())
env_set("board_name", "66AK2GGP\0");
else if (board_is_k2g_g1())
env_set("board_name", "66AK2GG1\0");
else if (board_is_k2g_ice())
env_set("board_name", "66AK2GIC\0");
#endif
return 0;
}
