Beispiel #1
0
// perform pre-arm checks and set ap.pre_arm_check flag
//  return true if the checks pass successfully
bool Copter::pre_arm_checks(bool display_failure)
{
    // exit immediately if already armed
    if (motors.armed()) {
        return true;
    }

    // check if motor interlock and Emergency Stop aux switches are used
    // at the same time.  This cannot be allowed.
    if (check_if_auxsw_mode_used(AUXSW_MOTOR_INTERLOCK) && check_if_auxsw_mode_used(AUXSW_MOTOR_ESTOP)){
        if (display_failure) {
            gcs_send_text(MAV_SEVERITY_CRITICAL,"PreArm: Interlock/E-Stop Conflict");
        }
        return false;
    }

    // check if motor interlock aux switch is in use
    // if it is, switch needs to be in disabled position to arm
    // otherwise exit immediately.  This check to be repeated,
    // as state can change at any time.
    if (ap.using_interlock && ap.motor_interlock_switch) {
        if (display_failure) {
            gcs_send_text(MAV_SEVERITY_CRITICAL,"PreArm: Motor Interlock Enabled");
        }
        return false;
    }

    // exit immediately if we've already successfully performed the pre-arm check
    if (ap.pre_arm_check) {
        // run gps checks because results may change and affect LED colour
        // no need to display failures because arm_checks will do that if the pilot tries to arm
        pre_arm_gps_checks(false);
        return true;
    }

    // succeed if pre arm checks are disabled
    if (g.arming_check == ARMING_CHECK_NONE) {
        set_pre_arm_check(true);
        set_pre_arm_rc_check(true);
        return true;
    }

    return barometer_checks(display_failure)
        & rc_calibration_checks(display_failure)
        & compass_checks(display_failure)
        & gps_checks(display_failure)
        & fence_checks(display_failure)
        & ins_checks(display_failure)
        & board_voltage_checks(display_failure)
        & parameter_checks(display_failure)
        & pilot_throttle_checks(display_failure);
}
Beispiel #2
0
bool AP_Arming::pre_arm_checks(bool report) 
{
    bool ret = true;
    if (armed || require == NONE) {
        // if we are already armed or don't need any arming checks
        // then skip the checks
        return true;
    }

    ret &= hardware_safety_check(report);
    ret &= barometer_checks(report);
    ret &= ins_checks(report);
    ret &= compass_checks(report);
    ret &= gps_checks(report);
    ret &= battery_checks(report);
    ret &= airspeed_checks(report);
    ret &= manual_transmitter_checks(report);

    return ret;
}
Beispiel #3
0
bool AP_Arming::pre_arm_checks(bool report)
{
#if !APM_BUILD_TYPE(APM_BUILD_ArduCopter)
    if (armed || require == NONE) {
        // if we are already armed or don't need any arming checks
        // then skip the checks
        return true;
    }
#endif

    return hardware_safety_check(report)
        &  barometer_checks(report)
        &  ins_checks(report)
        &  compass_checks(report)
        &  gps_checks(report)
        &  battery_checks(report)
        &  logging_checks(report)
        &  manual_transmitter_checks(report)
        &  board_voltage_checks(report);
}