/**
* @brief Main program
* @param None
* @retval None
*/
int main()
{
int i;
/*System clock configuration*/
SystemInit();
/* Configure UART2 */
S_UART_Init(115200);
conf.scl = I2C_PA_9;
conf.sda = I2C_PA_10;
I2C_Init(&conf);
//============ Write ==============
I2C_Write(&conf, 0xa0, &Transmit_Data[0], MAX_SIZE);
delay_function(4000);
//========= Read =============
//Write memory address
I2C_Write(&conf, 0xA0, &Transmit_Data[0], 1);
delay_function(4000);
//Read data
I2C_Read(&conf, 0xA0, &Recv_Data[0], MAX_SIZE - 1);
printf("Recv data : ");
for(i=0; i<MAX_SIZE - 1; i++)
{
printf("0x%x ", Recv_Data[i]);
}
printf("\r\n");
}
void main(void) {
WDTCTL = WDTPW + WDTHOLD;
P2DIR |= BIT0;
for(;;){
P2OUT |= BIT0;
delay_function();
P2OUT = 0;
delay_function();
delay++;
}
}
/**
* @brief Main program
* @param None
* @retval None
*/
int main()
{
int i;
/*System clock configuration*/
SystemInit();
// *(volatile uint32_t *)(0x41001014) = 0x0060100; //clock setting 48MHz
/* CLK OUT Set */
// PAD_AFConfig(PAD_PA,GPIO_Pin_2, PAD_AF2); // PAD Config - CLKOUT used 3nd Function
/* UART0 and UART1 configuration*/
UART_StructInit(&UART_InitStructure);
/* Configure UART1 */
UART_Init(UART1,&UART_InitStructure);
conf.scl = I2C_PA_9;
conf.sda = I2C_PA_10;
I2C_Init(&conf);
//============ Write ==============
I2C_Write(&conf, 0xa0, &Transmit_Data[0], MAX_SIZE);
delay_function(4000);
//========= Read =============
//Write memory address
I2C_Write(&conf, 0xA0, &Transmit_Data[0], 1);
delay_function(4000);
//Read data
I2C_Read(&conf, 0xA0, &Recv_Data[0], MAX_SIZE - 1);
printf("Recv data : ");
for(i=0; i<MAX_SIZE - 1; i++)
{
printf("0x%x ", Recv_Data[i]);
}
printf("\r\n");
}
