/**
* \brief Initialize the EPD hardware setting
*/
void EPD_display_hardware_init(void) {
EPD_initialize_gpio();
EPD_Vcc_turn_off();
epd_spi_init();
initialize_temperature();
EPD_cs_low();
EPD_pwm_low();
EPD_rst_low();
EPD_discharge_low();
EPD_border_low();
//initialize_EPD_timer();
}
/**
* \brief Initialize the temperature sensor
*/
void initialize_temperature(void) {
/** not used at present */
#if 0
struct adc_config adc_cfg = {
/* System clock division factor is 16 */
.prescal = ADC_PRESCAL_DIV16,
/* The APB clock is used */
.clksel = ADC_CLKSEL_APBCLK,
/* Max speed is 150K */
.speed = ADC_SPEED_150K,
/* ADC Reference voltage is VCC/2 */
.refsel =ADC_REFSEL_4,
/* Enables the Startup time */
.start_up = CONFIG_ADC_STARTUP
};
struct adc_seq_config adc_seq_cfg = {
/* Select Vref for shift cycle */
.zoomrange = ADC_ZOOMRANGE_0,
/* Pad Ground */
.muxneg = ADC_MUXNEG_1,
/* Temperature sensor */
.muxpos = EPD_Temperature_Sensor_ADC,
/* Enables the internal voltage sources */
.internal =ADC_INTERNAL_2,
/* Disables the ADC gain error reduction */
.gcomp = ADC_GCOMP_DIS,
/* Disables the HWLA mode */
.hwla = ADC_HWLA_DIS,
.gain=ADC_GAIN_1X,
/* 12-bits resolution */
.res = ADC_RES_12_BIT,
/* Enables the single-ended mode */
.bipolar = ADC_BIPOLAR_SINGLEENDED
};
struct adc_ch_config adc_ch_cfg = {
.seq_cfg = &adc_seq_cfg,
/* Internal Timer Max Counter */
.internal_timer_max_count = 60,
/* Window monitor mode is off */
.window_mode = 0,
.low_threshold = 0,
.high_threshold = 0,
};
adc_init(&g_adc_inst, ADCIFE, &adc_cfg);
adc_enable(&g_adc_inst);
adc_ch_set_config(&g_adc_inst, &adc_ch_cfg);
adc_set_callback(&g_adc_inst, ADC_SEQ_SEOC, adcife_read_conv_result, ADCIFE_IRQn, 1);
adc_configure_trigger(&g_adc_inst,ADC_TRIG_SW);
adc_configure_gain(&g_adc_inst, ADC_GAIN_1X);
#endif
}
/**
* \brief Initialize the EPD hardware setting
*/
void EPD_display_hardware_init (void) {
EPD_initialize_gpio();
EPD_Vcc_turn_off();
epd_spi_init();
initialize_temperature();
EPD_cs_low();
EPD_pwm_low();
EPD_rst_low();
EPD_discharge_low();
EPD_border_low();
//initialize_EPD_timer();
}
/**
* \brief Initialize SPI
*/
void epd_spi_attach (void) {
EPD_flash_cs_high();
EPD_cs_high();
epd_spi_init();
}
