static struct mem_timings *setup_clock(void)
{
struct mem_timings *mem = get_mem_timings();
struct arm_clk_ratios *arm_ratios = get_arm_clk_ratios();
if (!mem) {
die("Unable to auto-detect memory timings\n");
}
system_clock_init(mem, arm_ratios);
return mem;
}
void main(void)
{
struct mem_timings *mem;
struct arm_clk_ratios *arm_ratios;
int ret;
void *entry;
clock_set_rate(PERIPH_ID_SPI1, 50000000); /* set spi clock to 50Mhz */
/* Clock must be initialized before console_init, otherwise you may need
* to re-initialize serial console drivers again. */
mem = get_mem_timings();
arm_ratios = get_arm_clk_ratios();
system_clock_init(mem, arm_ratios);
console_init();
/*
* FIXME: Do necessary I2C init so low-level PMIC code doesn't need to.
* Also, we should only call power_init() on cold boot.
*/
power_init();
if (!mem) {
printk(BIOS_CRIT, "Unable to auto-detect memory timings\n");
while(1);
}
printk(BIOS_SPEW, "man: 0x%x type: 0x%x, div: 0x%x, mhz: 0x%x\n",
mem->mem_manuf,
mem->mem_type,
mem->mpll_mdiv,
mem->frequency_mhz);
ret = ddr3_mem_ctrl_init(mem, DMC_INTERLEAVE_SIZE);
if (ret) {
printk(BIOS_ERR, "Memory controller init failed, err: %x\n",
ret);
while(1);
}
/* Set up MMU and caches */
mmu_setup_by_mva(CONFIG_SYS_SDRAM_BASE, CONFIG_DRAM_SIZE_MB);
initialize_s5p_mshc();
graphics();
entry = cbfs_load_stage(CBFS_DEFAULT_MEDIA, "fallback/coreboot_ram");
printk(BIOS_INFO, "entry is 0x%p, leaving romstage.\n", entry);
stage_exit(entry);
}
