static int iwl_pci_resume(struct device *device)
{
struct pci_dev *pdev = to_pci_dev(device);
struct iwl_trans *trans = pci_get_drvdata(pdev);
struct iwl_trans_pcie *trans_pcie = IWL_TRANS_GET_PCIE_TRANS(trans);
bool hw_rfkill;
/* Before you put code here, think about WoWLAN. You cannot check here
* whether WoWLAN is enabled or not, and your code will run even if
* WoWLAN is enabled - the NIC may be alive.
*/
/*
* We disable the RETRY_TIMEOUT register (0x41) to keep
* PCI Tx retries from interfering with C3 CPU state.
*/
pci_write_config_byte(pdev, PCI_CFG_RETRY_TIMEOUT, 0x00);
if (!trans->op_mode)
return 0;
/*
* Enable rfkill interrupt (in order to keep track of
* the rfkill status)
*/
iwl_enable_rfkill_int(trans);
hw_rfkill = iwl_is_rfkill_set(trans);
mutex_lock(&trans_pcie->mutex);
iwl_trans_pcie_rf_kill(trans, hw_rfkill);
mutex_unlock(&trans_pcie->mutex);
return 0;
}
static int iwl_pci_resume(struct device *device)
{
struct pci_dev *pdev = to_pci_dev(device);
struct iwl_trans *trans = pci_get_drvdata(pdev);
bool hw_rfkill;
/* Before you put code here, think about WoWLAN. You cannot check here
* whether WoWLAN is enabled or not, and your code will run even if
* WoWLAN is enabled - the NIC may be alive.
*/
/*
* We disable the RETRY_TIMEOUT register (0x41) to keep
* PCI Tx retries from interfering with C3 CPU state.
*/
pci_write_config_byte(pdev, PCI_CFG_RETRY_TIMEOUT, 0x00);
if (!trans->op_mode)
return 0;
/*
* On suspend, ict is disabled, and the interrupt mask
* gets cleared. Reconfigure them both in case of d0i3
* image. Otherwise, only enable rfkill interrupt (in
* order to keep track of the rfkill status)
*/
if (trans->wowlan_d0i3) {
iwl_pcie_reset_ict(trans);
iwl_enable_interrupts(trans);
} else {
iwl_enable_rfkill_int(trans);
}
hw_rfkill = iwl_is_rfkill_set(trans);
iwl_trans_pcie_rf_kill(trans, hw_rfkill);
return 0;
}
irqreturn_t iwl_pcie_irq_handler(int irq, void *dev_id)
{
struct iwl_trans *trans = dev_id;
struct iwl_trans_pcie *trans_pcie = IWL_TRANS_GET_PCIE_TRANS(trans);
struct isr_statistics *isr_stats = &trans_pcie->isr_stats;
u32 inta = 0;
u32 handled = 0;
lock_map_acquire(&trans->sync_cmd_lockdep_map);
spin_lock(&trans_pcie->irq_lock);
/* dram interrupt table not set yet,
* use legacy interrupt.
*/
if (likely(trans_pcie->use_ict))
inta = iwl_pcie_int_cause_ict(trans);
else
inta = iwl_pcie_int_cause_non_ict(trans);
if (iwl_have_debug_level(IWL_DL_ISR)) {
IWL_DEBUG_ISR(trans,
"ISR inta 0x%08x, enabled 0x%08x(sw), enabled(hw) 0x%08x, fh 0x%08x\n",
inta, trans_pcie->inta_mask,
iwl_read32(trans, CSR_INT_MASK),
iwl_read32(trans, CSR_FH_INT_STATUS));
if (inta & (~trans_pcie->inta_mask))
IWL_DEBUG_ISR(trans,
"We got a masked interrupt (0x%08x)\n",
inta & (~trans_pcie->inta_mask));
}
inta &= trans_pcie->inta_mask;
/*
* Ignore interrupt if there's nothing in NIC to service.
* This may be due to IRQ shared with another device,
* or due to sporadic interrupts thrown from our NIC.
*/
if (unlikely(!inta)) {
IWL_DEBUG_ISR(trans, "Ignore interrupt, inta == 0\n");
/*
* Re-enable interrupts here since we don't
* have anything to service
*/
if (test_bit(STATUS_INT_ENABLED, &trans->status))
iwl_enable_interrupts(trans);
spin_unlock(&trans_pcie->irq_lock);
lock_map_release(&trans->sync_cmd_lockdep_map);
return IRQ_NONE;
}
if (unlikely(inta == 0xFFFFFFFF || (inta & 0xFFFFFFF0) == 0xa5a5a5a0)) {
/*
* Hardware disappeared. It might have
* already raised an interrupt.
*/
IWL_WARN(trans, "HARDWARE GONE?? INTA == 0x%08x\n", inta);
spin_unlock(&trans_pcie->irq_lock);
goto out;
}
/* Ack/clear/reset pending uCode interrupts.
* Note: Some bits in CSR_INT are "OR" of bits in CSR_FH_INT_STATUS,
*/
/* There is a hardware bug in the interrupt mask function that some
* interrupts (i.e. CSR_INT_BIT_SCD) can still be generated even if
* they are disabled in the CSR_INT_MASK register. Furthermore the
* ICT interrupt handling mechanism has another bug that might cause
* these unmasked interrupts fail to be detected. We workaround the
* hardware bugs here by ACKing all the possible interrupts so that
* interrupt coalescing can still be achieved.
*/
iwl_write32(trans, CSR_INT, inta | ~trans_pcie->inta_mask);
if (iwl_have_debug_level(IWL_DL_ISR))
IWL_DEBUG_ISR(trans, "inta 0x%08x, enabled 0x%08x\n",
inta, iwl_read32(trans, CSR_INT_MASK));
spin_unlock(&trans_pcie->irq_lock);
/* Now service all interrupt bits discovered above. */
if (inta & CSR_INT_BIT_HW_ERR) {
IWL_ERR(trans, "Hardware error detected. Restarting.\n");
/* Tell the device to stop sending interrupts */
iwl_disable_interrupts(trans);
isr_stats->hw++;
iwl_pcie_irq_handle_error(trans);
handled |= CSR_INT_BIT_HW_ERR;
goto out;
}
if (iwl_have_debug_level(IWL_DL_ISR)) {
/* NIC fires this, but we don't use it, redundant with WAKEUP */
if (inta & CSR_INT_BIT_SCD) {
IWL_DEBUG_ISR(trans,
"Scheduler finished to transmit the frame/frames.\n");
isr_stats->sch++;
}
/* Alive notification via Rx interrupt will do the real work */
if (inta & CSR_INT_BIT_ALIVE) {
IWL_DEBUG_ISR(trans, "Alive interrupt\n");
isr_stats->alive++;
}
}
/* Safely ignore these bits for debug checks below */
inta &= ~(CSR_INT_BIT_SCD | CSR_INT_BIT_ALIVE);
/* HW RF KILL switch toggled */
if (inta & CSR_INT_BIT_RF_KILL) {
bool hw_rfkill;
hw_rfkill = iwl_is_rfkill_set(trans);
IWL_WARN(trans, "RF_KILL bit toggled to %s.\n",
hw_rfkill ? "disable radio" : "enable radio");
isr_stats->rfkill++;
iwl_trans_pcie_rf_kill(trans, hw_rfkill);
if (hw_rfkill) {
set_bit(STATUS_RFKILL, &trans->status);
if (test_and_clear_bit(STATUS_SYNC_HCMD_ACTIVE,
&trans->status))
IWL_DEBUG_RF_KILL(trans,
"Rfkill while SYNC HCMD in flight\n");
wake_up(&trans_pcie->wait_command_queue);
} else {
clear_bit(STATUS_RFKILL, &trans->status);
}
handled |= CSR_INT_BIT_RF_KILL;
}
/* Chip got too hot and stopped itself */
if (inta & CSR_INT_BIT_CT_KILL) {
IWL_ERR(trans, "Microcode CT kill error detected.\n");
isr_stats->ctkill++;
handled |= CSR_INT_BIT_CT_KILL;
}
/* Error detected by uCode */
if (inta & CSR_INT_BIT_SW_ERR) {
IWL_ERR(trans, "Microcode SW error detected. "
" Restarting 0x%X.\n", inta);
isr_stats->sw++;
iwl_pcie_irq_handle_error(trans);
handled |= CSR_INT_BIT_SW_ERR;
}
/* uCode wakes up after power-down sleep */
if (inta & CSR_INT_BIT_WAKEUP) {
IWL_DEBUG_ISR(trans, "Wakeup interrupt\n");
iwl_pcie_rxq_check_wrptr(trans);
iwl_pcie_txq_check_wrptrs(trans);
isr_stats->wakeup++;
handled |= CSR_INT_BIT_WAKEUP;
}
/* All uCode command responses, including Tx command responses,
* Rx "responses" (frame-received notification), and other
* notifications from uCode come through here*/
if (inta & (CSR_INT_BIT_FH_RX | CSR_INT_BIT_SW_RX |
CSR_INT_BIT_RX_PERIODIC)) {
IWL_DEBUG_ISR(trans, "Rx interrupt\n");
if (inta & (CSR_INT_BIT_FH_RX | CSR_INT_BIT_SW_RX)) {
handled |= (CSR_INT_BIT_FH_RX | CSR_INT_BIT_SW_RX);
iwl_write32(trans, CSR_FH_INT_STATUS,
CSR_FH_INT_RX_MASK);
}
if (inta & CSR_INT_BIT_RX_PERIODIC) {
handled |= CSR_INT_BIT_RX_PERIODIC;
iwl_write32(trans,
CSR_INT, CSR_INT_BIT_RX_PERIODIC);
}
/* Sending RX interrupt require many steps to be done in the
* the device:
* 1- write interrupt to current index in ICT table.
* 2- dma RX frame.
* 3- update RX shared data to indicate last write index.
* 4- send interrupt.
* This could lead to RX race, driver could receive RX interrupt
* but the shared data changes does not reflect this;
* periodic interrupt will detect any dangling Rx activity.
*/
/* Disable periodic interrupt; we use it as just a one-shot. */
iwl_write8(trans, CSR_INT_PERIODIC_REG,
CSR_INT_PERIODIC_DIS);
/*
* Enable periodic interrupt in 8 msec only if we received
* real RX interrupt (instead of just periodic int), to catch
* any dangling Rx interrupt. If it was just the periodic
* interrupt, there was no dangling Rx activity, and no need
* to extend the periodic interrupt; one-shot is enough.
*/
if (inta & (CSR_INT_BIT_FH_RX | CSR_INT_BIT_SW_RX))
iwl_write8(trans, CSR_INT_PERIODIC_REG,
CSR_INT_PERIODIC_ENA);
isr_stats->rx++;
local_bh_disable();
iwl_pcie_rx_handle(trans);
local_bh_enable();
}
/* This "Tx" DMA channel is used only for loading uCode */
if (inta & CSR_INT_BIT_FH_TX) {
iwl_write32(trans, CSR_FH_INT_STATUS, CSR_FH_INT_TX_MASK);
IWL_DEBUG_ISR(trans, "uCode load interrupt\n");
isr_stats->tx++;
handled |= CSR_INT_BIT_FH_TX;
/* Wake up uCode load routine, now that load is complete */
trans_pcie->ucode_write_complete = true;
wake_up(&trans_pcie->ucode_write_waitq);
}
if (inta & ~handled) {
IWL_ERR(trans, "Unhandled INTA bits 0x%08x\n", inta & ~handled);
isr_stats->unhandled++;
}
if (inta & ~(trans_pcie->inta_mask)) {
IWL_WARN(trans, "Disabled INTA bits 0x%08x were pending\n",
inta & ~trans_pcie->inta_mask);
}
/* Re-enable all interrupts */
/* only Re-enable if disabled by irq */
if (test_bit(STATUS_INT_ENABLED, &trans->status))
iwl_enable_interrupts(trans);
/* Re-enable RF_KILL if it occurred */
else if (handled & CSR_INT_BIT_RF_KILL)
iwl_enable_rfkill_int(trans);
out:
lock_map_release(&trans->sync_cmd_lockdep_map);
return IRQ_HANDLED;
}
