static void dwc_ether_halt (struct eth_device *dev)
{
struct dw_eth_dev *priv = dev->priv;
mac_reset(dev);
priv->tx_currdescnum = priv->rx_currdescnum = 0;
}
static int dw_eth_init(struct eth_device *dev, bd_t *bis)
{
struct dw_eth_dev *priv = dev->priv;
struct eth_mac_regs *mac_p = priv->mac_regs_p;
struct eth_dma_regs *dma_p = priv->dma_regs_p;
u32 conf;
if (priv->phy_configured != 1)
configure_phy(dev);
/* Print link status only once */
if (!priv->link_printed) {
printf("ENET Speed is %d Mbps - %s duplex connection\n",
priv->speed, (priv->duplex == HALF) ? "HALF" : "FULL");
priv->link_printed = 1;
}
/* Reset ethernet hardware */
if (mac_reset(dev) < 0)
return -1;
/* Resore the HW MAC address as it has been lost during MAC reset */
dw_write_hwaddr(dev);
writel(FIXEDBURST | PRIORXTX_41 | BURST_16,
&dma_p->busmode);
writel(readl(&dma_p->opmode) | FLUSHTXFIFO | STOREFORWARD |
TXSECONDFRAME, &dma_p->opmode);
conf = FRAMEBURSTENABLE | DISABLERXOWN;
if (priv->speed != 1000)
conf |= MII_PORTSELECT;
if ((priv->interface != PHY_INTERFACE_MODE_MII) &&
(priv->interface != PHY_INTERFACE_MODE_GMII)) {
if (priv->speed == 100)
conf |= FES_100;
}
if (priv->duplex == FULL)
conf |= FULLDPLXMODE;
writel(conf, &mac_p->conf);
descs_init(dev);
/*
* Start/Enable xfer at dma as well as mac level
*/
writel(readl(&dma_p->opmode) | RXSTART, &dma_p->opmode);
writel(readl(&dma_p->opmode) | TXSTART, &dma_p->opmode);
writel(readl(&mac_p->conf) | RXENABLE | TXENABLE, &mac_p->conf);
return 0;
}
static int dw_eth_init(struct eth_device *dev, bd_t *bis)
{
struct dw_eth_dev *priv = dev->priv;
struct eth_mac_regs *mac_p = priv->mac_regs_p;
struct eth_dma_regs *dma_p = priv->dma_regs_p;
u32 conf;
if (priv->phy_configured != 1)
configure_phy(dev);
/* Reset ethernet hardware */
if (mac_reset(dev) < 0)
return -1;
/* Resore the HW MAC address as it has been lost during MAC reset */
dw_write_hwaddr(dev);
writel(FIXEDBURST | PRIORXTX_41 | BURST_16,
&dma_p->busmode);
writel(FLUSHTXFIFO | readl(&dma_p->opmode), &dma_p->opmode);
writel(STOREFORWARD | TXSECONDFRAME, &dma_p->opmode);
conf = FRAMEBURSTENABLE | DISABLERXOWN;
if (priv->speed != SPEED_1000M)
conf |= MII_PORTSELECT;
if (priv->duplex == FULL_DUPLEX)
conf |= FULLDPLXMODE;
writel(conf, &mac_p->conf);
descs_init(dev);
/*
* Start/Enable xfer at dma as well as mac level
*/
writel(readl(&dma_p->opmode) | RXSTART, &dma_p->opmode);
writel(readl(&dma_p->opmode) | TXSTART, &dma_p->opmode);
writel(readl(&mac_p->conf) | RXENABLE | TXENABLE, &mac_p->conf);
return 0;
}
static int dwc_ether_init(struct eth_device *dev)
{
struct dw_eth_dev *priv = dev->priv;
struct eth_mac_regs *mac_p = priv->mac_regs_p;
struct eth_dma_regs *dma_p = priv->dma_regs_p;
if (mac_reset(dev) < 0)
return -1;
/* HW MAC address is lost during MAC reset */
dev->set_ethaddr(dev, priv->macaddr);
writel(FIXEDBURST | PRIORXTX_41 | BURST_16, &dma_p->busmode);
writel(FLUSHTXFIFO | readl(&dma_p->opmode), &dma_p->opmode);
writel(STOREFORWARD | TXSECONDFRAME, &dma_p->opmode);
writel(FRAMEBURSTENABLE | DISABLERXOWN, &mac_p->conf);
return 0;
}
/**
* @brief Resets the MAC layer
*
* The MLME-RESET.request primitive allows the next higher layer to request
* that the MLME performs a reset operation.
*
* @param m Pointer to the MLME_RESET.request given by the NHLE
*/
void mlme_reset_request(uint8_t *m)
{
mlme_reset_req_t *mrr
= (mlme_reset_req_t *)BMM_BUFFER_POINTER((buffer_t *)m);
/* Wakeup the radio */
mac_trx_wakeup();
/* Start MAC reset functionality */
uint8_t status = mac_reset(mrr->SetDefaultPIB);
/* Set radio to sleep if allowed */
mac_sleep_trans();
/*
* As this is a mlme_reset request, all the requests, data (whether
* direct
* or indirect), incoming frames are removed from the queues
*/
flush_queues();
send_reset_conf((buffer_t *)m, status);
} /* mlme_reset_request() */
void mac_bang(int irq, void *vector, struct pt_regs *p)
{
printk(KERN_INFO "Resetting ...\n");
mac_reset();
}
int main (int argc, char *argv[])
{
int r;
char **optarg;
int run, nomon;
unsigned drive;
char *cfg;
ini_sct_t *sct;
cfg = NULL;
run = 0;
nomon = 0;
pce_log_init();
pce_log_add_fp (stderr, 0, MSG_INF);
par_cfg = ini_sct_new (NULL);
if (par_cfg == NULL) {
return (1);
}
ini_str_init (&par_ini_str);
while (1) {
r = pce_getopt (argc, argv, &optarg, opts);
if (r == GETOPT_DONE) {
break;
}
if (r < 0) {
return (1);
}
switch (r) {
case '?':
print_help();
return (0);
case 'V':
print_version();
return (0);
case 'b':
par_disk_delay_valid |= 1;
par_disk_delay[0] = (unsigned) strtoul (optarg[0], NULL, 0);
break;
case 'B':
drive = strtoul (optarg[0], NULL, 0);
if ((drive < 1) || (drive >= SONY_DRIVES)) {
fprintf (stderr, "%s: bad drive number (%u)\n",
argv[0], drive
);
return (1);
}
drive -= 1;
par_disk_delay_valid |= 1U << drive;
par_disk_delay[drive] = (unsigned) strtoul (optarg[1], NULL, 0);
break;
case 'c':
cfg = optarg[0];
break;
case 'd':
pce_path_set (optarg[0]);
break;
case 'i':
if (ini_read_str (par_cfg, optarg[0])) {
fprintf (stderr,
"%s: error parsing ini string (%s)\n",
argv[0], optarg[0]
);
return (1);
}
break;
case 'I':
ini_str_add (&par_ini_str, optarg[0], "\n", NULL);
break;
case 'l':
pce_log_add_fname (optarg[0], MSG_DEB);
break;
case 'p':
ini_str_add (&par_ini_str, "cpu.model = \"",
optarg[0], "\"\n"
);
break;
case 'q':
pce_log_set_level (stderr, MSG_ERR);
break;
case 'r':
run = 1;
break;
case 'R':
nomon = 1;
break;
case 's':
ini_str_add (&par_ini_str, "cpu.speed = ",
optarg[0], "\n"
);
break;
case 't':
par_terminal = optarg[0];
break;
case 'v':
pce_log_set_level (stderr, MSG_DEB);
break;
case 0:
fprintf (stderr, "%s: unknown option (%s)\n",
argv[0], optarg[0]
);
return (1);
default:
return (1);
}
}
mac_log_banner();
if (pce_load_config (par_cfg, cfg)) {
return (1);
}
sct = ini_next_sct (par_cfg, NULL, "macplus");
if (sct == NULL) {
sct = par_cfg;
}
if (ini_str_eval (&par_ini_str, sct, 1)) {
return (1);
}
atexit (mac_atexit);
#ifdef PCE_ENABLE_SDL
SDL_Init (0);
#endif
pce_path_ini (sct);
signal (SIGINT, &sig_int);
signal (SIGSEGV, &sig_segv);
signal (SIGTERM, &sig_term);
pce_console_init (stdin, stdout);
par_sim = mac_new (sct);
mon_init (&par_mon);
mon_set_cmd_fct (&par_mon, mac_cmd, par_sim);
mon_set_msg_fct (&par_mon, mac_set_msg, par_sim);
mon_set_get_mem_fct (&par_mon, par_sim->mem, mem_get_uint8);
mon_set_set_mem_fct (&par_mon, par_sim->mem, mem_set_uint8);
mon_set_memory_mode (&par_mon, 0);
cmd_init (par_sim, cmd_get_sym, cmd_set_sym);
mac_cmd_init (par_sim, &par_mon);
mac_reset (par_sim);
if (nomon) {
while (par_sim->brk != PCE_BRK_ABORT) {
mac_run (par_sim);
}
}
else if (run) {
mac_run (par_sim);
if (par_sim->brk != PCE_BRK_ABORT) {
pce_puts ("\n");
}
}
else {
pce_puts ("type 'h' for help\n");
}
if (par_sim->brk != PCE_BRK_ABORT) {
mon_run (&par_mon);
}
mac_del (par_sim);
#ifdef PCE_ENABLE_SDL
SDL_Quit();
#endif
mon_free (&par_mon);
pce_console_done();
pce_log_done();
return (0);
}
