static void stm32_transmit_chars_pio(struct uart_port *port)
{
struct stm32_port *stm32_port = to_stm32_port(port);
struct stm32_usart_offsets *ofs = &stm32_port->info->ofs;
struct circ_buf *xmit = &port->state->xmit;
unsigned int isr;
int ret;
if (stm32_port->tx_dma_busy) {
stm32_clr_bits(port, ofs->cr3, USART_CR3_DMAT);
stm32_port->tx_dma_busy = false;
}
ret = readl_relaxed_poll_timeout_atomic(port->membase + ofs->isr,
isr,
(isr & USART_SR_TXE),
10, 100000);
if (ret)
dev_err(port->dev, "tx empty not set\n");
stm32_set_bits(port, ofs->cr1, USART_CR1_TXEIE);
writel_relaxed(xmit->buf[xmit->tail], port->membase + ofs->tdr);
xmit->tail = (xmit->tail + 1) & (UART_XMIT_SIZE - 1);
port->icount.tx++;
}
static void stm32_tx_dma_complete(void *arg)
{
struct uart_port *port = arg;
struct stm32_port *stm32port = to_stm32_port(port);
struct stm32_usart_offsets *ofs = &stm32port->info->ofs;
unsigned int isr;
int ret;
ret = readl_relaxed_poll_timeout_atomic(port->membase + ofs->isr,
isr,
(isr & USART_SR_TC),
10, 100000);
if (ret)
dev_err(port->dev, "terminal count not set\n");
if (ofs->icr == UNDEF_REG)
stm32_clr_bits(port, ofs->isr, USART_SR_TC);
else
stm32_set_bits(port, ofs->icr, USART_CR_TC);
stm32_clr_bits(port, ofs->cr3, USART_CR3_DMAT);
stm32port->tx_dma_busy = false;
/* Let's see if we have pending data to send */
stm32_transmit_chars(port);
}
static int stm32_qspi_tx_poll(struct stm32_qspi *qspi,
const struct spi_mem_op *op)
{
void (*tx_fifo)(u8 *val, void __iomem *addr);
u32 len = op->data.nbytes, sr;
u8 *buf;
int ret;
if (op->data.dir == SPI_MEM_DATA_IN) {
tx_fifo = stm32_qspi_read_fifo;
buf = op->data.buf.in;
} else {
tx_fifo = stm32_qspi_write_fifo;
buf = (u8 *)op->data.buf.out;
}
while (len--) {
ret = readl_relaxed_poll_timeout_atomic(qspi->io_base + QSPI_SR,
sr, (sr & SR_FTF), 1,
STM32_FIFO_TIMEOUT_US);
if (ret) {
dev_err(qspi->dev, "fifo timeout (len:%d stat:%#x)\n",
len, sr);
return ret;
}
tx_fifo(buf++, qspi->io_base + QSPI_DR);
}
return 0;
}
static int stm32_qspi_wait_nobusy(struct stm32_qspi *qspi)
{
u32 sr;
return readl_relaxed_poll_timeout_atomic(qspi->io_base + QSPI_SR, sr,
!(sr & SR_BUSY), 1,
STM32_BUSY_TIMEOUT_US);
}
static int stm32_rtc_wait_sync(struct stm32_rtc *rtc)
{
const struct stm32_rtc_registers *regs = &rtc->data->regs;
unsigned int isr = readl_relaxed(rtc->base + regs->isr);
isr &= ~STM32_RTC_ISR_RSF;
writel_relaxed(isr, rtc->base + regs->isr);
/*
* Wait for RSF to be set to ensure the calendar registers are
* synchronised, it takes around 2 rtc_ck clock cycles
*/
return readl_relaxed_poll_timeout_atomic(rtc->base + regs->isr,
isr,
(isr & STM32_RTC_ISR_RSF),
10, 100000);
}
static int stm32_rtc_enter_init_mode(struct stm32_rtc *rtc)
{
const struct stm32_rtc_registers *regs = &rtc->data->regs;
unsigned int isr = readl_relaxed(rtc->base + regs->isr);
if (!(isr & STM32_RTC_ISR_INITF)) {
isr |= STM32_RTC_ISR_INIT;
writel_relaxed(isr, rtc->base + regs->isr);
/*
* It takes around 2 rtc_ck clock cycles to enter in
* initialization phase mode (and have INITF flag set). As
* slowest rtc_ck frequency may be 32kHz and highest should be
* 1MHz, we poll every 10 us with a timeout of 100ms.
*/
return readl_relaxed_poll_timeout_atomic(
rtc->base + regs->isr,
isr, (isr & STM32_RTC_ISR_INITF),
10, 100000);
}
return 0;
}
static int stm32_qspi_send(struct spi_mem *mem, const struct spi_mem_op *op)
{
struct stm32_qspi *qspi = spi_controller_get_devdata(mem->spi->master);
struct stm32_qspi_flash *flash = &qspi->flash[mem->spi->chip_select];
u32 ccr, cr, addr_max;
int timeout, err = 0;
dev_dbg(qspi->dev, "cmd:%#x mode:%d.%d.%d.%d addr:%#llx len:%#x\n",
op->cmd.opcode, op->cmd.buswidth, op->addr.buswidth,
op->dummy.buswidth, op->data.buswidth,
op->addr.val, op->data.nbytes);
err = stm32_qspi_wait_nobusy(qspi);
if (err)
goto abort;
addr_max = op->addr.val + op->data.nbytes + 1;
if (op->data.dir == SPI_MEM_DATA_IN) {
if (addr_max < qspi->mm_size &&
op->addr.buswidth)
qspi->fmode = CCR_FMODE_MM;
else
qspi->fmode = CCR_FMODE_INDR;
} else {
qspi->fmode = CCR_FMODE_INDW;
}
cr = readl_relaxed(qspi->io_base + QSPI_CR);
cr &= ~CR_PRESC_MASK & ~CR_FSEL;
cr |= FIELD_PREP(CR_PRESC_MASK, flash->presc);
cr |= FIELD_PREP(CR_FSEL, flash->cs);
writel_relaxed(cr, qspi->io_base + QSPI_CR);
if (op->data.nbytes)
writel_relaxed(op->data.nbytes - 1,
qspi->io_base + QSPI_DLR);
else
qspi->fmode = CCR_FMODE_INDW;
ccr = qspi->fmode;
ccr |= FIELD_PREP(CCR_INST_MASK, op->cmd.opcode);
ccr |= FIELD_PREP(CCR_IMODE_MASK,
stm32_qspi_get_mode(qspi, op->cmd.buswidth));
if (op->addr.nbytes) {
ccr |= FIELD_PREP(CCR_ADMODE_MASK,
stm32_qspi_get_mode(qspi, op->addr.buswidth));
ccr |= FIELD_PREP(CCR_ADSIZE_MASK, op->addr.nbytes - 1);
}
if (op->dummy.buswidth && op->dummy.nbytes)
ccr |= FIELD_PREP(CCR_DCYC_MASK,
op->dummy.nbytes * 8 / op->dummy.buswidth);
if (op->data.nbytes) {
ccr |= FIELD_PREP(CCR_DMODE_MASK,
stm32_qspi_get_mode(qspi, op->data.buswidth));
}
writel_relaxed(ccr, qspi->io_base + QSPI_CCR);
if (op->addr.nbytes && qspi->fmode != CCR_FMODE_MM)
writel_relaxed(op->addr.val, qspi->io_base + QSPI_AR);
err = stm32_qspi_tx(qspi, op);
/*
* Abort in:
* -error case
* -read memory map: prefetching must be stopped if we read the last
* byte of device (device size - fifo size). like device size is not
* knows, the prefetching is always stop.
*/
if (err || qspi->fmode == CCR_FMODE_MM)
goto abort;
/* wait end of tx in indirect mode */
err = stm32_qspi_wait_cmd(qspi, op);
if (err)
goto abort;
return 0;
abort:
cr = readl_relaxed(qspi->io_base + QSPI_CR) | CR_ABORT;
writel_relaxed(cr, qspi->io_base + QSPI_CR);
/* wait clear of abort bit by hw */
timeout = readl_relaxed_poll_timeout_atomic(qspi->io_base + QSPI_CR,
cr, !(cr & CR_ABORT), 1,
STM32_ABT_TIMEOUT_US);
writel_relaxed(FCR_CTCF, qspi->io_base + QSPI_FCR);
if (err || timeout)
dev_err(qspi->dev, "%s err:%d abort timeout:%d\n",
__func__, err, timeout);
return err;
}