/*
* FPGA Manager to program the FPGA. This is the interface used by FPGA driver.
* Return 0 for sucess, non-zero for error.
*/
int socfpga_load(Altera_desc *desc, const void *rbf_data, size_t rbf_size)
{
unsigned long status;
if ((uint32_t)rbf_data & 0x3) {
puts("FPGA: Unaligned data, realign to 32bit boundary.\n");
return -EINVAL;
}
/* Prior programming the FPGA, all bridges need to be shut off */
/* Disable all signals from hps peripheral controller to fpga */
writel(0, &sysmgr_regs->fpgaintfgrp_module);
/* Disable all signals from FPGA to HPS SDRAM */
#define SDR_CTRLGRP_FPGAPORTRST_ADDRESS 0x5080
writel(0, SOCFPGA_SDR_ADDRESS + SDR_CTRLGRP_FPGAPORTRST_ADDRESS);
/* Disable all axi bridge (hps2fpga, lwhps2fpga & fpga2hps) */
socfpga_bridges_reset(1);
/* Unmap the bridges from NIC-301 */
writel(0x1, SOCFPGA_L3REGS_ADDRESS);
/* Initialize the FPGA Manager */
status = fpgamgr_program_init();
if (status)
return status;
/* Write the RBF data to FPGA Manager */
fpgamgr_program_write(rbf_data, rbf_size);
/* Ensure the FPGA entering config done */
status = fpgamgr_program_poll_cd();
if (status)
return status;
/* Ensure the FPGA entering init phase */
status = fpgamgr_program_poll_initphase();
if (status)
return status;
/* Ensure the FPGA entering user mode */
return fpgamgr_program_poll_usermode();
}
void board_init_f(ulong dummy)
{
const struct cm_config *cm_default_cfg = cm_get_default_config();
unsigned long sdram_size;
unsigned long reg;
int ret;
/*
* First C code to run. Clear fake OCRAM ECC first as SBE
* and DBE might triggered during power on
*/
reg = readl(&sysmgr_regs->eccgrp_ocram);
if (reg & SYSMGR_ECC_OCRAM_SERR)
writel(SYSMGR_ECC_OCRAM_SERR | SYSMGR_ECC_OCRAM_EN,
&sysmgr_regs->eccgrp_ocram);
if (reg & SYSMGR_ECC_OCRAM_DERR)
writel(SYSMGR_ECC_OCRAM_DERR | SYSMGR_ECC_OCRAM_EN,
&sysmgr_regs->eccgrp_ocram);
memset(__bss_start, 0, __bss_end - __bss_start);
socfpga_sdram_remap_zero();
debug("Freezing all I/O banks\n");
/* freeze all IO banks */
sys_mgr_frzctrl_freeze_req();
/* Put everything into reset but L4WD0. */
socfpga_per_reset_all();
if (!socfpga_is_booting_from_fpga()) {
/* Put FPGA bridges into reset too. */
socfpga_bridges_reset(1);
}
socfpga_per_reset(SOCFPGA_RESET(SDR), 0);
socfpga_per_reset(SOCFPGA_RESET(UART0), 0);
socfpga_per_reset(SOCFPGA_RESET(OSC1TIMER0), 0);
timer_init();
debug("Reconfigure Clock Manager\n");
/* reconfigure the PLLs */
if (cm_basic_init(cm_default_cfg))
hang();
/* Enable bootrom to configure IOs. */
sysmgr_config_warmrstcfgio(1);
/* configure the IOCSR / IO buffer settings */
if (scan_mgr_configure_iocsr())
hang();
sysmgr_config_warmrstcfgio(0);
/* configure the pin muxing through system manager */
sysmgr_config_warmrstcfgio(1);
sysmgr_pinmux_init();
sysmgr_config_warmrstcfgio(0);
/* De-assert reset for peripherals and bridges based on handoff */
reset_deassert_peripherals_handoff();
socfpga_bridges_reset(0);
debug("Unfreezing/Thaw all I/O banks\n");
/* unfreeze / thaw all IO banks */
sys_mgr_frzctrl_thaw_req();
#ifdef CONFIG_DEBUG_UART
socfpga_per_reset(SOCFPGA_RESET(UART0), 0);
debug_uart_init();
#endif
ret = spl_early_init();
if (ret) {
debug("spl_early_init() failed: %d\n", ret);
hang();
}
/* enable console uart printing */
preloader_console_init();
if (sdram_mmr_init_full(0xffffffff) != 0) {
puts("SDRAM init failed.\n");
hang();
}
debug("SDRAM: Calibrating PHY\n");
/* SDRAM calibration */
if (sdram_calibration_full() == 0) {
puts("SDRAM calibration failed.\n");
hang();
}
sdram_size = sdram_calculate_size();
debug("SDRAM: %ld MiB\n", sdram_size >> 20);
/* Sanity check ensure correct SDRAM size specified */
if (get_ram_size(0, sdram_size) != sdram_size) {
puts("SDRAM size check failed!\n");
hang();
}
if (!socfpga_is_booting_from_fpga())
socfpga_bridges_reset(1);
}
void board_init_f(ulong dummy)
{
#ifndef CONFIG_SOCFPGA_VIRTUAL_TARGET
const struct cm_config *cm_default_cfg = cm_get_default_config();
#endif
unsigned long sdram_size;
unsigned long reg;
/*
* First C code to run. Clear fake OCRAM ECC first as SBE
* and DBE might triggered during power on
*/
reg = readl(&sysmgr_regs->eccgrp_ocram);
if (reg & SYSMGR_ECC_OCRAM_SERR)
writel(SYSMGR_ECC_OCRAM_SERR | SYSMGR_ECC_OCRAM_EN,
&sysmgr_regs->eccgrp_ocram);
if (reg & SYSMGR_ECC_OCRAM_DERR)
writel(SYSMGR_ECC_OCRAM_DERR | SYSMGR_ECC_OCRAM_EN,
&sysmgr_regs->eccgrp_ocram);
memset(__bss_start, 0, __bss_end - __bss_start);
socfpga_nic301_slave_ns();
/* Configure ARM MPU SNSAC register. */
setbits_le32(&scu_regs->sacr, 0xfff);
/* Remap SDRAM to 0x0 */
writel(0x1, &nic301_regs->remap); /* remap.mpuzero */
writel(0x1, &pl310->pl310_addr_filter_start);
#ifndef CONFIG_SOCFPGA_VIRTUAL_TARGET
debug("Freezing all I/O banks\n");
/* freeze all IO banks */
sys_mgr_frzctrl_freeze_req();
/* Put everything into reset but L4WD0. */
socfpga_per_reset_all();
/* Put FPGA bridges into reset too. */
socfpga_bridges_reset(1);
socfpga_per_reset(SOCFPGA_RESET(SDR), 0);
socfpga_per_reset(SOCFPGA_RESET(UART0), 0);
socfpga_per_reset(SOCFPGA_RESET(OSC1TIMER0), 0);
timer_init();
debug("Reconfigure Clock Manager\n");
/* reconfigure the PLLs */
cm_basic_init(cm_default_cfg);
/* Enable bootrom to configure IOs. */
sysmgr_config_warmrstcfgio(1);
/* configure the IOCSR / IO buffer settings */
if (scan_mgr_configure_iocsr())
hang();
sysmgr_config_warmrstcfgio(0);
/* configure the pin muxing through system manager */
sysmgr_config_warmrstcfgio(1);
sysmgr_pinmux_init();
sysmgr_config_warmrstcfgio(0);
#endif /* CONFIG_SOCFPGA_VIRTUAL_TARGET */
/* De-assert reset for peripherals and bridges based on handoff */
reset_deassert_peripherals_handoff();
socfpga_bridges_reset(0);
debug("Unfreezing/Thaw all I/O banks\n");
/* unfreeze / thaw all IO banks */
sys_mgr_frzctrl_thaw_req();
/* enable console uart printing */
preloader_console_init();
if (sdram_mmr_init_full(0xffffffff) != 0) {
puts("SDRAM init failed.\n");
hang();
}
debug("SDRAM: Calibrating PHY\n");
/* SDRAM calibration */
if (sdram_calibration_full() == 0) {
puts("SDRAM calibration failed.\n");
hang();
}
sdram_size = sdram_calculate_size();
debug("SDRAM: %ld MiB\n", sdram_size >> 20);
/* Sanity check ensure correct SDRAM size specified */
if (get_ram_size(0, sdram_size) != sdram_size) {
puts("SDRAM size check failed!\n");
hang();
}
socfpga_bridges_reset(1);
/* Configure simple malloc base pointer into RAM. */
gd->malloc_base = CONFIG_SYS_TEXT_BASE + (1024 * 1024);
}