/*
* Wait for a DMA transfer to complete. This is a "limited busy-wait",
* and all locking issues are left to the caller.
*/
static int sscape_wait_dma_unsafe(unsigned io_base, enum GA_REG reg, unsigned timeout)
{
while (!(sscape_read_unsafe(io_base, reg) & 0x01) && (timeout != 0)) {
udelay(100);
--timeout;
} /* while */
return (sscape_read_unsafe(io_base, reg) & 0x01);
}
/*
* Upload a byte-stream into the SoundScape using DMA channel A.
*/
static int upload_dma_data(struct soundscape *s,
const unsigned char __user *data,
size_t size)
{
unsigned long flags;
struct snd_dma_buffer dma;
int ret;
if (!get_dmabuf(&dma, PAGE_ALIGN(size)))
return -ENOMEM;
spin_lock_irqsave(&s->lock, flags);
/*
* Reset the board ...
*/
sscape_write_unsafe(s->io_base, GA_HMCTL_REG, sscape_read_unsafe(s->io_base, GA_HMCTL_REG) & 0x3f);
/*
* Enable the DMA channels and configure them ...
*/
sscape_write_unsafe(s->io_base, GA_DMACFG_REG, 0x50);
sscape_write_unsafe(s->io_base, GA_DMAA_REG, (s->chip->dma1 << 4) | DMA_8BIT);
sscape_write_unsafe(s->io_base, GA_DMAB_REG, 0x20);
/*
* Take the board out of reset ...
*/
sscape_write_unsafe(s->io_base, GA_HMCTL_REG, sscape_read_unsafe(s->io_base, GA_HMCTL_REG) | 0x80);
/*
* Upload the user's data (firmware?) to the SoundScape
* board through the DMA channel ...
*/
while (size != 0) {
unsigned long len;
/*
* Apparently, copying to/from userspace can sleep.
* We are therefore forbidden from holding any
* spinlocks while we copy ...
*/
spin_unlock_irqrestore(&s->lock, flags);
/*
* Remember that the data that we want to DMA
* comes from USERSPACE. We have already verified
* the userspace pointer ...
*/
len = min(size, dma.bytes);
len -= __copy_from_user(dma.area, data, len);
data += len;
size -= len;
/*
* Grab that spinlock again, now that we've
* finished copying!
*/
spin_lock_irqsave(&s->lock, flags);
snd_dma_program(s->chip->dma1, dma.addr, len, DMA_MODE_WRITE);
sscape_start_dma_unsafe(s->io_base, GA_DMAA_REG);
if (!sscape_wait_dma_unsafe(s->io_base, GA_DMAA_REG, 5000)) {
/*
* Don't forget to release this spinlock we're holding ...
*/
spin_unlock_irqrestore(&s->lock, flags);
snd_printk(KERN_ERR "sscape: DMA upload has timed out\n");
ret = -EAGAIN;
goto _release_dma;
}
} /* while */
set_host_mode_unsafe(s->io_base);
/*
* Boot the board ... (I think)
*/
sscape_write_unsafe(s->io_base, GA_HMCTL_REG, sscape_read_unsafe(s->io_base, GA_HMCTL_REG) | 0x40);
spin_unlock_irqrestore(&s->lock, flags);
/*
* If all has gone well, then the board should acknowledge
* the new upload and tell us that it has rebooted OK. We
* give it 5 seconds (max) ...
*/
ret = 0;
if (!obp_startup_ack(s, 5)) {
snd_printk(KERN_ERR "sscape: No response from on-board processor after upload\n");
ret = -EAGAIN;
} else if (!host_startup_ack(s, 5)) {
snd_printk(KERN_ERR "sscape: SoundScape failed to initialise\n");
ret = -EAGAIN;
}
_release_dma:
/*
* NOTE!!! We are NOT holding any spinlocks at this point !!!
*/
sscape_write(s, GA_DMAA_REG, (s->ic_type == IC_ODIE ? 0x70 : 0x40));
free_dmabuf(&dma);
return ret;
}
/*
* Tell the SoundScape to activate the AD1845 chip (I think).
* The AD1845 detection fails if we *don't* do this, so I
* think that this is a good idea ...
*/
static inline void activate_ad1845_unsafe(unsigned io_base)
{
sscape_write_unsafe(io_base, GA_HMCTL_REG, (sscape_read_unsafe(io_base, GA_HMCTL_REG) & 0xcf) | 0x10);
sscape_write_unsafe(io_base, GA_CDCFG_REG, 0x80);
}
/*
* Tell the SoundScape to begin a DMA tranfer using the given channel.
* All locking issues are left to the caller.
*/
static inline void sscape_start_dma_unsafe(unsigned io_base, enum GA_REG reg)
{
sscape_write_unsafe(io_base, reg, sscape_read_unsafe(io_base, reg) | 0x01);
sscape_write_unsafe(io_base, reg, sscape_read_unsafe(io_base, reg) & 0xfe);
}
/*
* Perform certain arcane port-checks to see whether there
* is a SoundScape board lurking behind the given ports.
*/
static int __devinit detect_sscape(struct soundscape *s)
{
unsigned long flags;
unsigned d;
int retval = 0;
int codec = s->wss_base;
spin_lock_irqsave(&s->lock, flags);
/*
* The following code is lifted from the original OSS driver,
* and as I don't have a datasheet I cannot really comment
* on what it is doing...
*/
if ((inb(HOST_CTRL_IO(s->io_base)) & 0x78) != 0)
goto _done;
d = inb(ODIE_ADDR_IO(s->io_base)) & 0xf0;
if ((d & 0x80) != 0)
goto _done;
if (d == 0) {
s->codec_type = 1;
s->ic_type = IC_ODIE;
} else if ((d & 0x60) != 0) {
s->codec_type = 2;
s->ic_type = IC_OPUS;
} else
goto _done;
outb(0xfa, ODIE_ADDR_IO(s->io_base));
if ((inb(ODIE_ADDR_IO(s->io_base)) & 0x9f) != 0x0a)
goto _done;
outb(0xfe, ODIE_ADDR_IO(s->io_base));
if ((inb(ODIE_ADDR_IO(s->io_base)) & 0x9f) != 0x0e)
goto _done;
outb(0xfe, ODIE_ADDR_IO(s->io_base));
d = inb(ODIE_DATA_IO(s->io_base));
if (s->type != SSCAPE_VIVO && (d & 0x9f) != 0x0e)
goto _done;
d = sscape_read_unsafe(s->io_base, GA_HMCTL_REG) & 0x3f;
sscape_write_unsafe(s->io_base, GA_HMCTL_REG, d | 0xc0);
if (s->type == SSCAPE_VIVO)
codec += 4;
/* wait for WSS codec */
for (d = 0; d < 500; d++) {
if ((inb(codec) & 0x80) == 0)
break;
spin_unlock_irqrestore(&s->lock, flags);
msleep(1);
spin_lock_irqsave(&s->lock, flags);
}
snd_printd(KERN_INFO "init delay = %d ms\n", d);
/*
* SoundScape successfully detected!
*/
retval = 1;
_done:
spin_unlock_irqrestore(&s->lock, flags);
return retval;
}
