int board_init(void)
{
//Please keep CONFIG_AML_V2_FACTORY_BURN at first place of board_init
#ifdef CONFIG_AML_V2_FACTORY_BURN
aml_try_factory_usb_burning(0, gd->bd);
#endif// #ifdef CONFIG_AML_V2_FACTORY_BURN
/*for LED*/
//clear pinmux
clrbits_le32(AO_RTI_PIN_MUX_REG, ((1<<3)|(1<<4)));
clrbits_le32(AO_RTI_PIN_MUX_REG2, ((1<<1)|(1<<31)));
//set output mode
clrbits_le32(P_AO_GPIO_O_EN_N, (1<<13));
//set output 1
setbits_le32(P_AO_GPIO_O_EN_N, (1<<29));
/*Power on GPIOAO_2 for VCC_5V*/
clrbits_le32(P_AO_GPIO_O_EN_N, ((1<<2)|(1<<18)));
#ifdef CONFIG_USB_DWC_OTG_HCD
board_usb_init(&g_usb_config_gx_skt_a,BOARD_USB_MODE_HOST);
board_usb_init(&g_usb_config_gx_skt_b,BOARD_USB_MODE_HOST);
board_usb_init(&g_usb_config_gx_skt_h,BOARD_USB_MODE_CHARGER);
#endif /*CONFIG_USB_DWC_OTG_HCD*/
#ifdef CONFIG_AML_VPU
vpu_probe();
#endif
#ifdef CONFIG_AML_HDMITX20
hdmi_tx_set_hdmi_5v();
hdmi_tx_init();
#endif
#ifdef CONFIG_AML_NAND
extern int amlnf_init(unsigned char flag);
amlnf_init(0);
#endif
return 0;
}
int board_late_init(void){
int ret;
//update env before anyone using it
run_command("get_rebootmode; echo reboot_mode=${reboot_mode}; "\
"if test ${reboot_mode} = factory_reset; then "\
"defenv_reserv aml_dt;setenv upgrade_step 2;save; fi;", 0);
run_command("if itest ${upgrade_step} == 1; then "\
"defenv_reserv; setenv upgrade_step 2; saveenv; fi;", 0);
/*add board late init function here*/
ret = run_command("store dtb read $dtb_mem_addr", 1);
if (ret) {
printf("%s(): [store dtb read $dtb_mem_addr] fail\n", __func__);
#ifdef CONFIG_DTB_MEM_ADDR
char cmd[64];
printf("load dtb to %x\n", CONFIG_DTB_MEM_ADDR);
sprintf(cmd, "store dtb read %x", CONFIG_DTB_MEM_ADDR);
ret = run_command(cmd, 1);
if (ret) {
printf("%s(): %s fail\n", __func__, cmd);
}
#endif
}
#ifdef CONFIG_AML_VPU
vpu_probe();
#endif
/* after */
run_command("cvbs init;hdmitx hpd", 0);
run_command("vout output $outputmode", 0);
#ifdef CONFIG_AML_V2_FACTORY_BURN
aml_try_factory_sdcard_burning(0, gd->bd);
#endif// #ifdef CONFIG_AML_V2_FACTORY_BURN
return 0;
}
static int do_vpu_enable(cmd_tbl_t *cmdtp, int flag, int argc, char * const argv[])
{
vpu_probe();
return 0;
}