void setup() {
Serial.begin(115200);
delay(10);
setup_wifi();
client.setServer(mqtt_server, 1883);
Wire.begin(SDA, SCL); //sda,scl
Serial.println("Sensor Test");
if (!bmp.begin())
{
Serial.print("Ooops, no BMP180 detected ... Check your wiring or I2C ADDR!");
while (1);
}
else {
Serial.println("BMP180 ready.");
delay(1000);
}
/* OTA code */
ArduinoOTA.onStart([]() {
Serial.println("Start");
});
ArduinoOTA.onEnd([]() {
Serial.println("\nEnd");
});
ArduinoOTA.onProgress([](unsigned int progress, unsigned int total) {
Serial.printf("Progress: %u%%\r", (progress / (total / 100)));
});
ArduinoOTA.onError([](ota_error_t error) {
Serial.printf("Error[%u]: ", error);
if (error == OTA_AUTH_ERROR) Serial.println("Auth Failed");
else if (error == OTA_BEGIN_ERROR) Serial.println("Begin Failed");
else if (error == OTA_CONNECT_ERROR) Serial.println("Connect Failed");
else if (error == OTA_RECEIVE_ERROR) Serial.println("Receive Failed");
else if (error == OTA_END_ERROR) Serial.println("End Failed");
});
ArduinoOTA.begin();
// Set up mDNS responder:
// - first argument is the domain name, in this example
// the fully-qualified domain name is "esp8266.local"
// - second argument is the IP address to advertise
// we send our IP address on the WiFi network
if (!MDNS.begin(hostname, WiFi.localIP())) {
Serial.println("Error setting up MDNS responder!");
while(1) {
delay(1000);
}
}
Serial.print("mDNS responder started: ");
Serial.print(hostname);
Serial.println(".local");
httpUpdater.setup(&httpServer);
httpServer.begin();
MDNS.addService("http", "tcp", 80);
}
void setup()
{
Serial.begin(115200);
pinMode(BUTTON_PIN, INPUT);
if (digitalRead(BUTTON_PIN) == 0)
{
Serial.println("Factory Reset");
}
WiFiManager wifi;
wifi.autoConnect(DEVICE_NAME);
if (!mdns.begin(DEVICE_NAME, WiFi.localIP()))
{
Serial.println("Error setting up MDNS responder!");
}
else
{
Serial.println("mDNS responder started");
}
// Start TCP (HTTP) server
server.begin();
Serial.println("TCP server started");
Serial.println("Listening on port 8266");
Serial.print("Sketch size: ");
Serial.println(ESP.getSketchSize());
Serial.print("Free size: ");
Serial.println(ESP.getFreeSketchSpace());
server.on("/", handle_root);
server.on("/on", handle_on);
server.on("/off", handle_off);
httpUpdater.setup(&server);
state = OFF;
Serial.println("State: OFF");
pinMode(LED_PIN, OUTPUT);
}