/*
* The general purpose timer ticks at 1MHz independent if
* the rest of the system
*/
static void sibyte_set_mode(enum clock_event_mode mode,
struct clock_event_device *evt)
{
unsigned int cpu = smp_processor_id();
void __iomem *cfg, *init;
cfg = IOADDR(A_SCD_TIMER_REGISTER(cpu, R_SCD_TIMER_CFG));
init = IOADDR(A_SCD_TIMER_REGISTER(cpu, R_SCD_TIMER_INIT));
switch (mode) {
case CLOCK_EVT_MODE_PERIODIC:
__raw_writeq(0, cfg);
__raw_writeq((V_SCD_TIMER_FREQ / HZ) - 1, init);
__raw_writeq(M_SCD_TIMER_ENABLE | M_SCD_TIMER_MODE_CONTINUOUS,
cfg);
break;
case CLOCK_EVT_MODE_ONESHOT:
/* Stop the timer until we actually program a shot */
case CLOCK_EVT_MODE_SHUTDOWN:
__raw_writeq(0, cfg);
break;
case CLOCK_EVT_MODE_UNUSED: /* shuddup gcc */
case CLOCK_EVT_MODE_RESUME:
;
}
}
static int sibyte_set_periodic(struct clock_event_device *evt)
{
unsigned int cpu = smp_processor_id();
void __iomem *cfg, *init;
cfg = IOADDR(A_SCD_TIMER_REGISTER(cpu, R_SCD_TIMER_CFG));
init = IOADDR(A_SCD_TIMER_REGISTER(cpu, R_SCD_TIMER_INIT));
__raw_writeq(0, cfg);
__raw_writeq((V_SCD_TIMER_FREQ / HZ) - 1, init);
__raw_writeq(M_SCD_TIMER_ENABLE | M_SCD_TIMER_MODE_CONTINUOUS, cfg);
return 0;
}
static int sibyte_next_event(unsigned long delta, struct clock_event_device *cd)
{
unsigned int cpu = smp_processor_id();
void __iomem *cfg, *init;
cfg = IOADDR(A_SCD_TIMER_REGISTER(cpu, R_SCD_TIMER_CFG));
init = IOADDR(A_SCD_TIMER_REGISTER(cpu, R_SCD_TIMER_INIT));
__raw_writeq(0, cfg);
__raw_writeq(delta - 1, init);
__raw_writeq(M_SCD_TIMER_ENABLE, cfg);
return 0;
}
void sb1250_time_init(void)
{
int cpu = smp_processor_id();
int irq = K_INT_TIMER_0+cpu;
/* Only have 4 general purpose timers */
if (cpu > 3) {
BUG();
}
if (!cpu) {
/* Use our own gettimeoffset() routine */
do_gettimeoffset = sb1250_gettimeoffset;
}
sb1250_mask_irq(cpu, irq);
/* Map the timer interrupt to ip[4] of this cpu */
bus_writeq(IMR_IP4_VAL,
IOADDR(A_IMR_REGISTER(cpu, R_IMR_INTERRUPT_MAP_BASE) +
(irq << 3)));
/* the general purpose timer ticks at 1 Mhz independent if the rest of the system */
/* Disable the timer and set up the count */
bus_writeq(0, IOADDR(A_SCD_TIMER_REGISTER(cpu, R_SCD_TIMER_CFG)));
#ifdef CONFIG_SIMULATION
bus_writeq(50000 / HZ,
IOADDR(A_SCD_TIMER_REGISTER(cpu, R_SCD_TIMER_INIT)));
#else
bus_writeq(1000000/HZ,
IOADDR(A_SCD_TIMER_REGISTER(cpu, R_SCD_TIMER_INIT)));
#endif
/* Set the timer running */
bus_writeq(M_SCD_TIMER_ENABLE | M_SCD_TIMER_MODE_CONTINUOUS,
IOADDR(A_SCD_TIMER_REGISTER(cpu, R_SCD_TIMER_CFG)));
sb1250_unmask_irq(cpu, irq);
sb1250_steal_irq(irq);
/*
* This interrupt is "special" in that it doesn't use the request_irq
* way to hook the irq line. The timer interrupt is initialized early
* enough to make this a major pain, and it's also firing enough to
* warrant a bit of special case code. sb1250_timer_interrupt is
* called directly from irq_handler.S when IP[4] is set during an
* interrupt
*/
}
static cycle_t bcm1480_hpt_read(void)
{
/* We assume this function is called xtime_lock held. */
unsigned long count =
__raw_readq(IOADDR(A_SCD_TIMER_REGISTER(0, R_SCD_TIMER_CNT)));
return (jiffies + 1) * (BCM1480_HPT_VALUE / HZ) - count;
}
/*
* We use our own do_gettimeoffset() instead of the generic one,
* because the generic one does not work for SMP case.
* In addition, since we use general timer 0 for system time,
* we can get accurate intra-jiffy offset without calibration.
*/
unsigned long sb1250_gettimeoffset(void)
{
unsigned long count =
bus_readq(IOADDR(A_SCD_TIMER_REGISTER(0, R_SCD_TIMER_CNT)));
return 1000000/HZ - count;
}
/*
* We use our own do_gettimeoffset() instead of the generic one,
* because the generic one does not work for SMP case.
* In addition, since we use general timer 0 for system time,
* we can get accurate intra-jiffy offset without calibration.
*/
unsigned long sb1250_gettimeoffset(void)
{
unsigned long count =
in64(KSEG1 + A_SCD_TIMER_REGISTER(0, R_SCD_TIMER_CNT));
return 1000000/HZ - count;
}
void __init sb1250_clocksource_init(void)
{
struct clocksource *cs = &bcm1250_clocksource;
/* Setup hpt using timer #3 but do not enable irq for it */
__raw_writeq(0,
IOADDR(A_SCD_TIMER_REGISTER(SB1250_HPT_NUM,
R_SCD_TIMER_CFG)));
__raw_writeq(SB1250_HPT_VALUE,
IOADDR(A_SCD_TIMER_REGISTER(SB1250_HPT_NUM,
R_SCD_TIMER_INIT)));
__raw_writeq(M_SCD_TIMER_ENABLE | M_SCD_TIMER_MODE_CONTINUOUS,
IOADDR(A_SCD_TIMER_REGISTER(SB1250_HPT_NUM,
R_SCD_TIMER_CFG)));
<<<<<<< HEAD
void __init sb1250_clocksource_init(void)
{
struct clocksource *cs = &bcm1250_clocksource;
__raw_writeq(0,
IOADDR(A_SCD_TIMER_REGISTER(SB1250_HPT_NUM,
R_SCD_TIMER_CFG)));
__raw_writeq(SB1250_HPT_VALUE,
IOADDR(A_SCD_TIMER_REGISTER(SB1250_HPT_NUM,
R_SCD_TIMER_INIT)));
__raw_writeq(M_SCD_TIMER_ENABLE | M_SCD_TIMER_MODE_CONTINUOUS,
IOADDR(A_SCD_TIMER_REGISTER(SB1250_HPT_NUM,
R_SCD_TIMER_CFG)));
clocksource_register_hz(cs, V_SCD_TIMER_FREQ);
}
static cycle_t sb1250_hpt_read(struct clocksource *cs)
{
unsigned int count;
count = G_SCD_TIMER_CNT(__raw_readq(IOADDR(A_SCD_TIMER_REGISTER(SB1250_HPT_NUM, R_SCD_TIMER_CNT))));
return SB1250_HPT_VALUE - count;
}
static int sibyte_shutdown(struct clock_event_device *evt)
{
unsigned int cpu = smp_processor_id();
void __iomem *cfg;
cfg = IOADDR(A_SCD_TIMER_REGISTER(cpu, R_SCD_TIMER_CFG));
/* Stop the timer until we actually program a shot */
__raw_writeq(0, cfg);
return 0;
}
void bcm1480_time_init(void)
{
int cpu = smp_processor_id();
int irq = K_BCM1480_INT_TIMER_0+cpu;
/* Only have 4 general purpose timers */
if (cpu > 3) {
BUG();
}
bcm1480_mask_irq(cpu, irq);
/* Map the timer interrupt to ip[4] of this cpu */
__raw_writeq(IMR_IP4_VAL, IOADDR(A_BCM1480_IMR_REGISTER(cpu, R_BCM1480_IMR_INTERRUPT_MAP_BASE_H)
+ (irq<<3)));
/* the general purpose timer ticks at 1 Mhz independent of the rest of the system */
/* Disable the timer and set up the count */
__raw_writeq(0, IOADDR(A_SCD_TIMER_REGISTER(cpu, R_SCD_TIMER_CFG)));
__raw_writeq(
BCM1480_HPT_VALUE/HZ
, IOADDR(A_SCD_TIMER_REGISTER(cpu, R_SCD_TIMER_INIT)));
/* Set the timer running */
__raw_writeq(M_SCD_TIMER_ENABLE|M_SCD_TIMER_MODE_CONTINUOUS,
IOADDR(A_SCD_TIMER_REGISTER(cpu, R_SCD_TIMER_CFG)));
bcm1480_unmask_irq(cpu, irq);
bcm1480_steal_irq(irq);
/*
* This interrupt is "special" in that it doesn't use the request_irq
* way to hook the irq line. The timer interrupt is initialized early
* enough to make this a major pain, and it's also firing enough to
* warrant a bit of special case code. bcm1480_timer_interrupt is
* called directly from irq_handler.S when IP[4] is set during an
* interrupt
*/
}
static irqreturn_t sibyte_counter_handler(int irq, void *dev_id)
{
unsigned int cpu = smp_processor_id();
struct clock_event_device *cd = dev_id;
void __iomem *cfg;
unsigned long tmode;
if (cd->mode == CLOCK_EVT_MODE_PERIODIC)
tmode = M_SCD_TIMER_ENABLE | M_SCD_TIMER_MODE_CONTINUOUS;
else
tmode = 0;
/* ACK interrupt */
cfg = IOADDR(A_SCD_TIMER_REGISTER(cpu, R_SCD_TIMER_CFG));
____raw_writeq(tmode, cfg);
cd->event_handler(cd);
return IRQ_HANDLED;
}
void sb1250_timer_interrupt(struct pt_regs *regs)
{
int cpu = smp_processor_id();
int irq = K_INT_TIMER_0+cpu;
/* Reset the timer */
out64(M_SCD_TIMER_ENABLE|M_SCD_TIMER_MODE_CONTINUOUS,
KSEG1 + A_SCD_TIMER_REGISTER(cpu, R_SCD_TIMER_CFG));
/*
* CPU 0 handles the global timer interrupt job
*/
if (cpu == 0) {
ll_timer_interrupt(irq, regs);
}
/*
* every CPU should do profiling and process accouting
*/
ll_local_timer_interrupt(irq, regs);
}
void bcm1480_timer_interrupt(void)
{
int cpu = smp_processor_id();
int irq = K_BCM1480_INT_TIMER_0 + cpu;
/* Reset the timer */
__raw_writeq(M_SCD_TIMER_ENABLE|M_SCD_TIMER_MODE_CONTINUOUS,
IOADDR(A_SCD_TIMER_REGISTER(cpu, R_SCD_TIMER_CFG)));
if (cpu == 0) {
/*
* CPU 0 handles the global timer interrupt job
*/
ll_timer_interrupt(irq);
}
else {
/*
* other CPUs should just do profiling and process accounting
*/
ll_local_timer_interrupt(irq);
}
}
void sb1250_timer_interrupt(struct pt_regs *regs)
{
extern asmlinkage void ll_local_timer_interrupt(int irq, struct pt_regs *regs);
int cpu = smp_processor_id();
int irq = K_INT_TIMER_0 + cpu;
/* Reset the timer */
__bus_writeq(M_SCD_TIMER_ENABLE | M_SCD_TIMER_MODE_CONTINUOUS,
IOADDR(A_SCD_TIMER_REGISTER(cpu, R_SCD_TIMER_CFG)));
/*
* CPU 0 handles the global timer interrupt job
*/
if (cpu == 0) {
ll_timer_interrupt(irq, regs);
}
if (cpu != 0) {
/*
* every CPU should do profiling and process accouting
*/
ll_local_timer_interrupt(irq, regs);
}
}
