/*******************************************************************************
* Initialize the gic, configure the CLCD and zero out variables needed by the
* secondaries to boot up correctly.
******************************************************************************/
void bl31_platform_setup()
{
unsigned int reg_val;
/* Initialize the gic cpu and distributor interfaces */
gic_setup();
/*
* TODO: Configure the CLCD before handing control to
* linux. Need to see if a separate driver is needed
* instead.
*/
mmio_write_32(VE_SYSREGS_BASE + V2M_SYS_CFGDATA, 0);
mmio_write_32(VE_SYSREGS_BASE + V2M_SYS_CFGCTRL,
(1ull << 31) | (1 << 30) | (7 << 20) | (0 << 16));
/* Enable and initialize the System level generic timer */
mmio_write_32(SYS_CNTCTL_BASE + CNTCR_OFF, CNTCR_FCREQ(0) | CNTCR_EN);
/* Allow access to the System counter timer module */
reg_val = (1 << CNTACR_RPCT_SHIFT) | (1 << CNTACR_RVCT_SHIFT);
reg_val |= (1 << CNTACR_RFRQ_SHIFT) | (1 << CNTACR_RVOFF_SHIFT);
reg_val |= (1 << CNTACR_RWVT_SHIFT) | (1 << CNTACR_RWPT_SHIFT);
mmio_write_32(SYS_TIMCTL_BASE + CNTACR_BASE(0), reg_val);
mmio_write_32(SYS_TIMCTL_BASE + CNTACR_BASE(1), reg_val);
reg_val = (1 << CNTNSAR_NS_SHIFT(0)) | (1 << CNTNSAR_NS_SHIFT(1));
mmio_write_32(SYS_TIMCTL_BASE + CNTNSAR, reg_val);
/* Intialize the power controller */
fvp_pwrc_setup();
/* Topologies are best known to the platform. */
plat_setup_topology();
}
static void sq_configure_sys_timer(void)
{
unsigned int reg_val;
reg_val = (1 << CNTACR_RPCT_SHIFT) | (1 << CNTACR_RVCT_SHIFT);
reg_val |= (1 << CNTACR_RFRQ_SHIFT) | (1 << CNTACR_RVOFF_SHIFT);
reg_val |= (1 << CNTACR_RWVT_SHIFT) | (1 << CNTACR_RWPT_SHIFT);
mmio_write_32(SQ_SYS_TIMCTL_BASE +
CNTACR_BASE(PLAT_SQ_NSTIMER_FRAME_ID), reg_val);
reg_val = (1 << CNTNSAR_NS_SHIFT(PLAT_SQ_NSTIMER_FRAME_ID));
mmio_write_32(SQ_SYS_TIMCTL_BASE + CNTNSAR, reg_val);
}
/*******************************************************************************
* Configures access to the system counter timer module.
******************************************************************************/
void arm_configure_sys_timer(void)
{
#ifdef ARM_SYS_TIMCTL_BASE
unsigned int reg_val;
reg_val = (1 << CNTACR_RPCT_SHIFT) | (1 << CNTACR_RVCT_SHIFT);
reg_val |= (1 << CNTACR_RFRQ_SHIFT) | (1 << CNTACR_RVOFF_SHIFT);
reg_val |= (1 << CNTACR_RWVT_SHIFT) | (1 << CNTACR_RWPT_SHIFT);
mmio_write_32(ARM_SYS_TIMCTL_BASE + CNTACR_BASE(PLAT_ARM_NSTIMER_FRAME_ID), reg_val);
reg_val = (1 << CNTNSAR_NS_SHIFT(PLAT_ARM_NSTIMER_FRAME_ID));
mmio_write_32(ARM_SYS_TIMCTL_BASE + CNTNSAR, reg_val);
#endif
}
/*******************************************************************************
* MTK_platform handler called when an affinity instance has just been powered on after
* being turned off earlier. The level and mpidr determine the affinity
* instance. The 'state' arg. allows the platform to decide whether the cluster
* was turned off prior to wakeup and do what's necessary to setup it up
* correctly.
******************************************************************************/
int mt_affinst_on_finish(unsigned long mpidr,
unsigned int afflvl,
unsigned int state)
{
int rc = PSCI_E_SUCCESS;
unsigned long linear_id, cpu_setup;
mailbox_t *mt_mboxes;
unsigned int gicd_base, gicc_base, ectlr;
switch (afflvl) {
case MPIDR_AFFLVL2:
if (state == PSCI_STATE_OFF) {
// __asm__ __volatile__ ("1: b 1b \n\t");
}
gicd_base = mt_get_cfgvar(CONFIG_GICD_ADDR);
gic_pcpu_distif_setup(gicd_base);
break;
case MPIDR_AFFLVL1:
/* Enable coherency if this cluster was off */
if (state == PSCI_STATE_OFF) {
enable_scu(mpidr);
mt_cci_setup();
trace_power_flow(mpidr, CLUSTER_UP);
}
break;
case MPIDR_AFFLVL0:
/*
* Ignore the state passed for a cpu. It could only have
* been off if we are here.
*/
workaround_836870(mpidr);
/*
* Turn on intra-cluster coherency if the MTK_platform flavour supports
* it.
*/
cpu_setup = mt_get_cfgvar(CONFIG_CPU_SETUP);
if (cpu_setup) {
ectlr = read_cpuectlr();
ectlr |= CPUECTLR_SMP_BIT;
write_cpuectlr(ectlr);
}
/* Zero the jump address in the mailbox for this cpu */
mt_mboxes = (mailbox_t *) (MBOX_OFF);
linear_id = platform_get_core_pos(mpidr);
mt_mboxes[linear_id].value = 0;
flush_dcache_range((unsigned long) &mt_mboxes[linear_id],
sizeof(unsigned long));
gicc_base = mt_get_cfgvar(CONFIG_GICC_ADDR);
/* Enable the gic cpu interface */
gic_cpuif_setup(gicc_base);
//gic_cpu_restore();
#if 0 //fixme,
/* Allow access to the System counter timer module */
reg_val = (1 << CNTACR_RPCT_SHIFT) | (1 << CNTACR_RVCT_SHIFT);
reg_val |= (1 << CNTACR_RFRQ_SHIFT) | (1 << CNTACR_RVOFF_SHIFT);
reg_val |= (1 << CNTACR_RWVT_SHIFT) | (1 << CNTACR_RWPT_SHIFT);
mmio_write_32(SYS_TIMCTL_BASE + CNTACR_BASE(0), reg_val);
mmio_write_32(SYS_TIMCTL_BASE + CNTACR_BASE(1), reg_val);
reg_val = (1 << CNTNSAR_NS_SHIFT(0)) |
(1 << CNTNSAR_NS_SHIFT(1));
mmio_write_32(SYS_TIMCTL_BASE + CNTNSAR, reg_val);
#endif
enable_ns_access_to_cpuectlr();
trace_power_flow(mpidr, CPU_UP);
break;
default:
assert(0);
}
return rc;
}
/*******************************************************************************
* FVP handler called when an affinity instance has just been powered on after
* being turned off earlier. The level and mpidr determine the affinity
* instance. The 'state' arg. allows the platform to decide whether the cluster
* was turned off prior to wakeup and do what's necessary to setup it up
* correctly.
******************************************************************************/
int fvp_affinst_on_finish(unsigned long mpidr,
unsigned int afflvl,
unsigned int state)
{
int rc = PSCI_E_SUCCESS;
unsigned long linear_id, cpu_setup, cci_setup;
mailbox *fvp_mboxes;
unsigned int gicd_base, gicc_base, reg_val, ectlr;
switch (afflvl) {
case MPIDR_AFFLVL1:
/* Enable coherency if this cluster was off */
if (state == PSCI_STATE_OFF) {
/*
* This CPU might have woken up whilst the
* cluster was attempting to power down. In
* this case the FVP power controller will
* have a pending cluster power off request
* which needs to be cleared by writing to the
* PPONR register. This prevents the power
* controller from interpreting a subsequent
* entry of this cpu into a simple wfi as a
* power down request.
*/
fvp_pwrc_write_pponr(mpidr);
cci_setup = platform_get_cfgvar(CONFIG_HAS_CCI);
if (cci_setup) {
cci_enable_coherency(mpidr);
}
}
break;
case MPIDR_AFFLVL0:
/*
* Ignore the state passed for a cpu. It could only have
* been off if we are here.
*/
/*
* Turn on intra-cluster coherency if the FVP flavour supports
* it.
*/
cpu_setup = platform_get_cfgvar(CONFIG_CPU_SETUP);
if (cpu_setup) {
ectlr = read_cpuectlr();
ectlr |= CPUECTLR_SMP_BIT;
write_cpuectlr(ectlr);
}
/*
* Clear PWKUPR.WEN bit to ensure interrupts do not interfere
* with a cpu power down unless the bit is set again
*/
fvp_pwrc_clr_wen(mpidr);
/* Zero the jump address in the mailbox for this cpu */
fvp_mboxes = (mailbox *) (TZDRAM_BASE + MBOX_OFF);
linear_id = platform_get_core_pos(mpidr);
fvp_mboxes[linear_id].value = 0;
flush_dcache_range((unsigned long) &fvp_mboxes[linear_id],
sizeof(unsigned long));
gicd_base = platform_get_cfgvar(CONFIG_GICD_ADDR);
gicc_base = platform_get_cfgvar(CONFIG_GICC_ADDR);
/* Enable the gic cpu interface */
gic_cpuif_setup(gicc_base);
/* TODO: This setup is needed only after a cold boot */
gic_pcpu_distif_setup(gicd_base);
/* Allow access to the System counter timer module */
reg_val = (1 << CNTACR_RPCT_SHIFT) | (1 << CNTACR_RVCT_SHIFT);
reg_val |= (1 << CNTACR_RFRQ_SHIFT) | (1 << CNTACR_RVOFF_SHIFT);
reg_val |= (1 << CNTACR_RWVT_SHIFT) | (1 << CNTACR_RWPT_SHIFT);
mmio_write_32(SYS_TIMCTL_BASE + CNTACR_BASE(0), reg_val);
mmio_write_32(SYS_TIMCTL_BASE + CNTACR_BASE(1), reg_val);
reg_val = (1 << CNTNSAR_NS_SHIFT(0)) |
(1 << CNTNSAR_NS_SHIFT(1));
mmio_write_32(SYS_TIMCTL_BASE + CNTNSAR, reg_val);
break;
default:
assert(0);
}
return rc;
}
