/*
* RetryTransferPacket
*
* Retry sending a TRANSFER_PACKET.
*
* Return TRUE iff the packet is complete.
* (if so the status in pkt->irp is the final status).
*/
BOOLEAN RetryTransferPacket(PTRANSFER_PACKET Pkt)
{
BOOLEAN packetDone;
TracePrint((TRACE_LEVEL_INFORMATION, TRACE_FLAG_GENERAL, "retrying failed transfer (pkt=%ph, op=%s)", Pkt, DBGGETSCSIOPSTR(Pkt->Srb)));
NT_ASSERT(Pkt->NumRetries > 0 || Pkt->RetryHistory);
Pkt->NumRetries--;
//
// If this is the last retry, then turn off disconnect, sync transfer,
// and tagged queuing. On all other retries, leave the original settings.
//
if ( 0 == Pkt->NumRetries ) {
/*
* Tone down performance on the retry.
* This increases the chance for success on the retry.
* We've seen instances of drives that fail consistently but then start working
* once this scale-down is applied.
*/
SrbSetSrbFlags(Pkt->Srb, SRB_FLAGS_DISABLE_DISCONNECT);
SrbSetSrbFlags(Pkt->Srb, SRB_FLAGS_DISABLE_SYNCH_TRANSFER);
SrbClearSrbFlags(Pkt->Srb, SRB_FLAGS_QUEUE_ACTION_ENABLE);
SrbSetRequestTag(Pkt->Srb, SP_UNTAGGED);
}
if (Pkt->Irp->IoStatus.Status == STATUS_INSUFFICIENT_RESOURCES) {
PCDB pCdb = SrbGetCdb(Pkt->Srb);
UCHAR cdbOpcode = 0;
BOOLEAN isReadWrite = FALSE;
PFUNCTIONAL_DEVICE_EXTENSION fdoExtension = Pkt->Fdo->DeviceExtension;
PCLASS_PRIVATE_FDO_DATA fdoData = fdoExtension->PrivateFdoData;
if (pCdb) {
cdbOpcode = pCdb->CDB10.OperationCode;
isReadWrite = IS_SCSIOP_READWRITE(cdbOpcode);
}
if ((Pkt->DriverUsesStartIO) &&
( (cdbOpcode == SCSIOP_WRITE6 ) ||
(cdbOpcode == SCSIOP_WRITE ) ||
(cdbOpcode == SCSIOP_WRITE12) ||
(cdbOpcode == SCSIOP_WRITE16) )) {
/* don't retry writes in super-low-memory conditions if the
* driver must serialize against StartIO. This is because
* some write methods used in such drivers cannot accept
* random-sized writes. (i.e CD-RW in packet writing mode)
* Reads, however, are always safe to split up.
*/
SET_FLAG(fdoData->TrackingFlags, TRACKING_FORWARD_PROGRESS_PATH1);
packetDone = TRUE;
}
else if (Pkt->InLowMemRetry || !isReadWrite){
/*
* This should never happen under normal circumstances.
* The memory manager guarantees that at least four pages will
* be available to allow forward progress in the port driver.
* So a one-page transfer should never fail with insufficient resources.
*
* However, it is possible to get in here with virtual storage
* or thin provisioned storage for example.
* A single sector write can trigger an allocation request and
* presently a forward progress guarantee is not provided.
* VHD also may have some limitations in forward progress guarantee.
* And USB too might also fall into this category.
*/
SET_FLAG(fdoData->TrackingFlags, TRACKING_FORWARD_PROGRESS_PATH2);
packetDone = TRUE;
}
else {
/*
* We are in low-memory stress.
* Start the low-memory retry state machine, which tries to
* resend the packet in little one-page chunks.
*/
SET_FLAG(fdoData->TrackingFlags, TRACKING_FORWARD_PROGRESS_PATH3);
InitLowMemRetry(Pkt,
Pkt->BufPtrCopy,
Pkt->BufLenCopy,
Pkt->TargetLocationCopy);
StepLowMemRetry(Pkt);
packetDone = FALSE;
}
}
else {
/*
* Retry the packet by simply resending it after a delay.
* Put the packet back in the pending queue and
* schedule a timer to retry the transfer.
*
* Do not call SetupReadWriteTransferPacket again because:
* (1) The minidriver may have set some bits
* in the SRB that it needs again and
* (2) doing so would reset numRetries.
*
* BECAUSE we do not call SetupReadWriteTransferPacket again,
* we have to reset a couple fields in the SRB that
* some miniports overwrite when they fail an SRB.
*/
SrbSetDataBuffer(Pkt->Srb, Pkt->BufPtrCopy);
SrbSetDataTransferLength(Pkt->Srb, Pkt->BufLenCopy);
TransferPacketQueueRetryDpc(Pkt);
packetDone = FALSE;
}
return packetDone;
}
/*
* RetryTransferPacket
*
* Retry sending a TRANSFER_PACKET.
*
* Return TRUE iff the packet is complete.
* (if so the status in pkt->irp is the final status).
*/
BOOLEAN NTAPI RetryTransferPacket(PTRANSFER_PACKET Pkt)
{
BOOLEAN packetDone;
DBGTRACE(ClassDebugTrace, ("retrying failed transfer (pkt=%ph, op=%s)", Pkt, DBGGETSCSIOPSTR(&Pkt->Srb)));
ASSERT(Pkt->NumRetries > 0);
Pkt->NumRetries--;
/*
* Tone down performance on the retry.
* This increases the chance for success on the retry.
* We've seen instances of drives that fail consistently but then start working
* once this scale-down is applied.
*/
SET_FLAG(Pkt->Srb.SrbFlags, SRB_FLAGS_DISABLE_DISCONNECT);
SET_FLAG(Pkt->Srb.SrbFlags, SRB_FLAGS_DISABLE_SYNCH_TRANSFER);
CLEAR_FLAG(Pkt->Srb.SrbFlags, SRB_FLAGS_QUEUE_ACTION_ENABLE);
Pkt->Srb.QueueTag = SP_UNTAGGED;
if (Pkt->Irp->IoStatus.Status == STATUS_INSUFFICIENT_RESOURCES){
PCDB pCdb = (PCDB)Pkt->Srb.Cdb;
BOOLEAN isReadWrite = ((pCdb->CDB10.OperationCode == SCSIOP_READ) ||
(pCdb->CDB10.OperationCode == SCSIOP_WRITE));
if (Pkt->InLowMemRetry || !isReadWrite){
/*
* This should never happen.
* The memory manager guarantees that at least four pages will
* be available to allow forward progress in the port driver.
* So a one-page transfer should never fail with insufficient resources.
*/
ASSERT(isReadWrite && !Pkt->InLowMemRetry);
packetDone = TRUE;
}
else {
/*
* We are in low-memory stress.
* Start the low-memory retry state machine, which tries to
* resend the packet in little one-page chunks.
*/
InitLowMemRetry( Pkt,
Pkt->BufPtrCopy,
Pkt->BufLenCopy,
Pkt->TargetLocationCopy);
StepLowMemRetry(Pkt);
packetDone = FALSE;
}
}
else {
/*
* Retry the packet by simply resending it after a delay.
* Put the packet back in the pending queue and
* schedule a timer to retry the transfer.
*
* Do not call SetupReadWriteTransferPacket again because:
* (1) The minidriver may have set some bits
* in the SRB that it needs again and
* (2) doing so would reset numRetries.
*
* BECAUSE we do not call SetupReadWriteTransferPacket again,
* we have to reset a couple fields in the SRB that
* some miniports overwrite when they fail an SRB.
*/
Pkt->Srb.DataBuffer = Pkt->BufPtrCopy;
Pkt->Srb.DataTransferLength = Pkt->BufLenCopy;
if (Pkt->RetryIntervalSec == 0){
/*
* Always delay by at least a little when retrying.
* Some problems (e.g. CRC errors) are not recoverable without a slight delay.
*/
LARGE_INTEGER timerPeriod;
timerPeriod.HighPart = -1;
timerPeriod.LowPart = -(LONG)((ULONG)MINIMUM_RETRY_UNITS*KeQueryTimeIncrement());
KeInitializeTimer(&Pkt->RetryTimer);
KeInitializeDpc(&Pkt->RetryTimerDPC, TransferPacketRetryTimerDpc, Pkt);
KeSetTimer(&Pkt->RetryTimer, timerPeriod, &Pkt->RetryTimerDPC);
}
else {
LARGE_INTEGER timerPeriod;
ASSERT(Pkt->RetryIntervalSec < 100); // sanity check
timerPeriod.HighPart = -1;
timerPeriod.LowPart = Pkt->RetryIntervalSec*-10000000;
KeInitializeTimer(&Pkt->RetryTimer);
KeInitializeDpc(&Pkt->RetryTimerDPC, TransferPacketRetryTimerDpc, Pkt);
KeSetTimer(&Pkt->RetryTimer, timerPeriod, &Pkt->RetryTimerDPC);
}
packetDone = FALSE;
}
return packetDone;
}
