};
void omap_4430sdp_display_init(void)
{
sdp4430_hdmi_mux_init();
omap_display_init(&sdp4430_dss_data);
}
#ifdef CONFIG_OMAP_MUX
static struct omap_board_mux board_mux[] __initdata = {
OMAP4_MUX(USBB2_ULPITLL_CLK, OMAP_MUX_MODE4 | OMAP_PIN_OUTPUT),
{ .reg_offset = OMAP_MUX_TERMINATOR },
};
static struct omap_device_pad serial2_pads[] __initdata = {
OMAP_MUX_STATIC("uart2_cts.uart2_cts",
OMAP_PIN_INPUT_PULLUP | OMAP_MUX_MODE0),
OMAP_MUX_STATIC("uart2_rts.uart2_rts",
OMAP_PIN_OUTPUT | OMAP_MUX_MODE0),
OMAP_MUX_STATIC("uart2_rx.uart2_rx",
OMAP_PIN_INPUT_PULLUP | OMAP_MUX_MODE0),
OMAP_MUX_STATIC("uart2_tx.uart2_tx",
OMAP_PIN_OUTPUT | OMAP_MUX_MODE0),
};
static struct omap_device_pad serial3_pads[] __initdata = {
OMAP_MUX_STATIC("uart3_cts_rctx.uart3_cts_rctx",
OMAP_PIN_INPUT_PULLUP | OMAP_MUX_MODE0),
OMAP_MUX_STATIC("uart3_rts_sd.uart3_rts_sd",
OMAP_PIN_OUTPUT | OMAP_MUX_MODE0),
OMAP_MUX_STATIC("uart3_rx_irrx.uart3_rx_irrx",
OMAP_PIN_INPUT | OMAP_MUX_MODE0),
};
#ifdef CONFIG_OMAP_MUX
static struct omap_board_mux board_mux[] __initdata = {
{ .reg_offset = OMAP_MUX_TERMINATOR },
};
static struct omap_device_pad serial1_pads[] __initdata = {
/*
* Note that off output enable is an active low
* signal. So setting this means pin is a
* input enabled in off mode
*/
OMAP_MUX_STATIC("uart1_cts.uart1_cts",
OMAP_PIN_INPUT |
OMAP_PIN_OFF_INPUT_PULLDOWN |
OMAP_OFFOUT_EN |
OMAP_MUX_MODE0),
OMAP_MUX_STATIC("uart1_rts.uart1_rts",
OMAP_PIN_OUTPUT |
OMAP_OFF_EN |
OMAP_MUX_MODE0),
OMAP_MUX_STATIC("uart1_rx.uart1_rx",
OMAP_PIN_INPUT |
OMAP_PIN_OFF_INPUT_PULLDOWN |
OMAP_OFFOUT_EN |
OMAP_MUX_MODE0),
OMAP_MUX_STATIC("uart1_tx.uart1_tx",
OMAP_PIN_OUTPUT |
OMAP_OFF_EN |
OMAP_MUX_MODE0),