static int at91_aic_set_type(struct irq_data *d, unsigned type)
{
unsigned int smr, srctype;
switch (type) {
case IRQ_TYPE_LEVEL_HIGH:
srctype = AT91_AIC_SRCTYPE_HIGH;
break;
case IRQ_TYPE_EDGE_RISING:
srctype = AT91_AIC_SRCTYPE_RISING;
break;
case IRQ_TYPE_LEVEL_LOW:
if ((d->hwirq == AT91_ID_FIQ) || is_extern_irq(d->hwirq)) /* only supported on external interrupts */
srctype = AT91_AIC_SRCTYPE_LOW;
else
return -EINVAL;
break;
case IRQ_TYPE_EDGE_FALLING:
if ((d->hwirq == AT91_ID_FIQ) || is_extern_irq(d->hwirq)) /* only supported on external interrupts */
srctype = AT91_AIC_SRCTYPE_FALLING;
else
return -EINVAL;
break;
default:
return -EINVAL;
}
smr = at91_aic_read(AT91_AIC_SMR(d->hwirq)) & ~AT91_AIC_SRCTYPE;
at91_aic_write(AT91_AIC_SMR(d->hwirq), smr | srctype);
return 0;
}
static int at91_pm_enter(suspend_state_t state)
{
if (of_have_populated_dt())
at91_pinctrl_gpio_suspend();
else
at91_gpio_suspend();
at91_irq_suspend();
pr_debug("AT91: PM - wake mask %08x, pm state %d\n",
/* remember all the always-wake irqs */
(at91_pmc_read(AT91_PMC_PCSR)
| (1 << AT91_ID_FIQ)
| (1 << AT91_ID_SYS)
| (at91_get_extern_irq()))
& at91_aic_read(AT91_AIC_IMR),
state);
switch (state) {
/*
* Suspend-to-RAM is like STANDBY plus slow clock mode, so
* drivers must suspend more deeply: only the master clock
* controller may be using the main oscillator.
*/
case PM_SUSPEND_MEM:
/*
* Ensure that clocks are in a valid state.
*/
if (!at91_pm_verify_clocks())
goto error;
/*
* Enter slow clock mode by switching over to clk32k and
* turning off the main oscillator; reverse on wakeup.
*/
if (slow_clock) {
int memctrl = AT91_MEMCTRL_SDRAMC;
if (cpu_is_at91rm9200())
memctrl = AT91_MEMCTRL_MC;
else if (cpu_is_at91sam9g45())
memctrl = AT91_MEMCTRL_DDRSDR;
#ifdef CONFIG_AT91_SLOW_CLOCK
/* copy slow_clock handler to SRAM, and call it */
memcpy(slow_clock, at91_slow_clock, at91_slow_clock_sz);
#endif
slow_clock(at91_pmc_base, at91_ramc_base[0],
at91_ramc_base[1], memctrl);
break;
} else {
pr_info("AT91: PM - no slow clock mode enabled ...\n");
/* FALLTHROUGH leaving master clock alone */
}
/*
* STANDBY mode has *all* drivers suspended; ignores irqs not
* marked as 'wakeup' event sources; and reduces DRAM power.
* But otherwise it's identical to PM_SUSPEND_ON: cpu idle, and
* nothing fancy done with main or cpu clocks.
*/
case PM_SUSPEND_STANDBY:
/*
* NOTE: the Wait-for-Interrupt instruction needs to be
* in icache so no SDRAM accesses are needed until the
* wakeup IRQ occurs and self-refresh is terminated.
* For ARM 926 based chips, this requirement is weaker
* as at91sam9 can access a RAM in self-refresh mode.
*/
if (at91_pm_standby)
at91_pm_standby();
break;
case PM_SUSPEND_ON:
cpu_do_idle();
break;
default:
pr_debug("AT91: PM - bogus suspend state %d\n", state);
goto error;
}
pr_debug("AT91: PM - wakeup %08x\n",
at91_aic_read(AT91_AIC_IPR) & at91_aic_read(AT91_AIC_IMR));
error:
target_state = PM_SUSPEND_ON;
at91_irq_resume();
if (of_have_populated_dt())
at91_pinctrl_gpio_resume();
else
at91_gpio_resume();
return 0;
}
void at91_irq_suspend(void)
{
backups = at91_aic_read(AT91_AIC_IMR);
at91_aic_write(AT91_AIC_IDCR, backups);
at91_aic_write(AT91_AIC_IECR, wakeups);
}
static int at91_pm_enter(suspend_state_t state)
{
at91_gpio_suspend();
at91_irq_suspend();
pr_debug("AT91: PM - wake mask %08x, pm state %d\n",
/* */
(at91_pmc_read(AT91_PMC_PCSR)
| (1 << AT91_ID_FIQ)
| (1 << AT91_ID_SYS)
| (at91_extern_irq))
& at91_aic_read(AT91_AIC_IMR),
state);
switch (state) {
/*
*/
case PM_SUSPEND_MEM:
/*
*/
if (!at91_pm_verify_clocks())
goto error;
/*
*/
if (slow_clock) {
int memctrl = AT91_MEMCTRL_SDRAMC;
if (cpu_is_at91rm9200())
memctrl = AT91_MEMCTRL_MC;
else if (cpu_is_at91sam9g45())
memctrl = AT91_MEMCTRL_DDRSDR;
#ifdef CONFIG_AT91_SLOW_CLOCK
/* */
memcpy(slow_clock, at91_slow_clock, at91_slow_clock_sz);
#endif
slow_clock(at91_pmc_base, at91_ramc_base[0],
at91_ramc_base[1], memctrl);
break;
} else {
pr_info("AT91: PM - no slow clock mode enabled ...\n");
/* */
}
/*
*/
case PM_SUSPEND_STANDBY:
/*
*/
at91_standby();
break;
case PM_SUSPEND_ON:
cpu_do_idle();
break;
default:
pr_debug("AT91: PM - bogus suspend state %d\n", state);
goto error;
}
pr_debug("AT91: PM - wakeup %08x\n",
at91_aic_read(AT91_AIC_IPR) & at91_aic_read(AT91_AIC_IMR));
error:
target_state = PM_SUSPEND_ON;
at91_irq_resume();
at91_gpio_resume();
return 0;
}