static int __init bcm63xx_pci_init(void)
{
unsigned int mem_size;
u32 val;
if (!BCMCPU_IS_6348() && !BCMCPU_IS_6358() && !BCMCPU_IS_6368())
return -ENODEV;
if (!bcm63xx_pci_enabled)
return -ENODEV;
pci_iospace_start = ioremap_nocache(BCM_PCI_IO_BASE_PA, 4);
if (!pci_iospace_start)
return -ENOMEM;
val = BCM_PCI_MEM_BASE_PA & MPI_L2P_BASE_MASK;
bcm_mpi_writel(val, MPI_L2PMEMBASE1_REG);
bcm_mpi_writel(~(BCM_PCI_MEM_SIZE - 1), MPI_L2PMEMRANGE1_REG);
bcm_mpi_writel(val | MPI_L2PREMAP_ENABLED_MASK, MPI_L2PMEMREMAP1_REG);
val = bcm_pcmcia_readl(PCMCIA_C1_REG);
val &= ~PCMCIA_C1_CBIDSEL_MASK;
val |= (CARDBUS_PCI_IDSEL << PCMCIA_C1_CBIDSEL_SHIFT);
bcm_pcmcia_writel(val, PCMCIA_C1_REG);
#ifdef CONFIG_CARDBUS
val = BCM_CB_MEM_BASE_PA & MPI_L2P_BASE_MASK;
bcm_mpi_writel(val, MPI_L2PMEMBASE2_REG);
bcm_mpi_writel(~(BCM_CB_MEM_SIZE - 1), MPI_L2PMEMRANGE2_REG);
val |= MPI_L2PREMAP_ENABLED_MASK | MPI_L2PREMAP_IS_CARDBUS_MASK;
bcm_mpi_writel(val, MPI_L2PMEMREMAP2_REG);
#else
bcm_mpi_writel(0, MPI_L2PMEMREMAP2_REG);
#endif
val = BCM_PCI_IO_BASE_PA & MPI_L2P_BASE_MASK;
bcm_mpi_writel(val, MPI_L2PIOBASE_REG);
bcm_mpi_writel(~(BCM_PCI_IO_SIZE - 1), MPI_L2PIORANGE_REG);
bcm_mpi_writel(val | MPI_L2PREMAP_ENABLED_MASK, MPI_L2PIOREMAP_REG);
bcm_mpi_writel(MPI_LOCBUSCTL_EN_PCI_GPIO_MASK, MPI_LOCBUSCTL_REG);
bcm63xx_int_cfg_writel(0, PCI_BASE_ADDRESS_3);
if (BCMCPU_IS_6358() || BCMCPU_IS_6368())
val = MPI_SP0_REMAP_ENABLE_MASK;
else
val = 0;
bcm_mpi_writel(val, MPI_SP0_REMAP_REG);
bcm63xx_int_cfg_writel(0x0, PCI_BASE_ADDRESS_4);
bcm_mpi_writel(0, MPI_SP1_REMAP_REG);
mem_size = bcm63xx_get_memory_size();
if (BCMCPU_IS_6348() && (bcm63xx_get_cpu_rev() & 0xf0) == 0xa0) {
if (mem_size > (16 * 1024 * 1024))
printk(KERN_WARNING "bcm63xx: this CPU "
"revision cannot handle more than 16MB "
"of RAM for PCI bus mastering\n");
} else {
bcm_mpi_writel(~(mem_size - 1), MPI_SP0_RANGE_REG);
bcm_mpi_writel(0, MPI_SP1_RANGE_REG);
}
val = bcm63xx_int_cfg_readl(BCMPCI_REG_TIMERS);
val &= ~REG_TIMER_RETRY_MASK;
bcm63xx_int_cfg_writel(val, BCMPCI_REG_TIMERS);
val = bcm63xx_int_cfg_readl(PCI_COMMAND);
val |= (PCI_COMMAND_MEMORY | PCI_COMMAND_MASTER);
bcm63xx_int_cfg_writel(val, PCI_COMMAND);
val = bcm_mpi_readl(MPI_PCIMODESEL_REG);
val &= ~MPI_PCIMODESEL_BAR1_NOSWAP_MASK;
val &= ~MPI_PCIMODESEL_BAR2_NOSWAP_MASK;
val &= ~MPI_PCIMODESEL_PREFETCH_MASK;
val |= (8 << MPI_PCIMODESEL_PREFETCH_SHIFT);
bcm_mpi_writel(val, MPI_PCIMODESEL_REG);
val = bcm_mpi_readl(MPI_LOCINT_REG);
val |= MPI_LOCINT_MASK(MPI_LOCINT_EXT_PCI_INT);
bcm_mpi_writel(val, MPI_LOCINT_REG);
register_pci_controller(&bcm63xx_controller);
#ifdef CONFIG_CARDBUS
register_pci_controller(&bcm63xx_cb_controller);
#endif
request_mem_region(BCM_PCI_IO_BASE_PA, BCM_PCI_IO_SIZE,
"bcm63xx PCI IO space");
return 0;
}
static int __init bcm63xx_pci_init(void)
{
unsigned int mem_size;
u32 val;
if (!BCMCPU_IS_6348() && !BCMCPU_IS_6358())
return -ENODEV;
if (!bcm63xx_pci_enabled)
return -ENODEV;
/*
* configuration access are done through IO space, remap 4
* first bytes to access it from CPU.
*
* this means that no io access from CPU should happen while
* we do a configuration cycle, but there's no way we can add
* a spinlock for each io access, so this is currently kind of
* broken on SMP.
*/
pci_iospace_start = ioremap_nocache(BCM_PCI_IO_BASE_PA, 4);
if (!pci_iospace_start)
return -ENOMEM;
/* setup local bus to PCI access (PCI memory) */
val = BCM_PCI_MEM_BASE_PA & MPI_L2P_BASE_MASK;
bcm_mpi_writel(val, MPI_L2PMEMBASE1_REG);
bcm_mpi_writel(~(BCM_PCI_MEM_SIZE - 1), MPI_L2PMEMRANGE1_REG);
bcm_mpi_writel(val | MPI_L2PREMAP_ENABLED_MASK, MPI_L2PMEMREMAP1_REG);
/* set Cardbus IDSEL (type 0 cfg access on primary bus for
* this IDSEL will be done on Cardbus instead) */
val = bcm_pcmcia_readl(PCMCIA_C1_REG);
val &= ~PCMCIA_C1_CBIDSEL_MASK;
val |= (CARDBUS_PCI_IDSEL << PCMCIA_C1_CBIDSEL_SHIFT);
bcm_pcmcia_writel(val, PCMCIA_C1_REG);
#ifdef CONFIG_CARDBUS
/* setup local bus to PCI access (Cardbus memory) */
val = BCM_CB_MEM_BASE_PA & MPI_L2P_BASE_MASK;
bcm_mpi_writel(val, MPI_L2PMEMBASE2_REG);
bcm_mpi_writel(~(BCM_CB_MEM_SIZE - 1), MPI_L2PMEMRANGE2_REG);
val |= MPI_L2PREMAP_ENABLED_MASK | MPI_L2PREMAP_IS_CARDBUS_MASK;
bcm_mpi_writel(val, MPI_L2PMEMREMAP2_REG);
#else
/* disable second access windows */
bcm_mpi_writel(0, MPI_L2PMEMREMAP2_REG);
#endif
/* setup local bus to PCI access (IO memory), we have only 1
* IO window for both PCI and cardbus, but it cannot handle
* both at the same time, assume standard PCI for now, if
* cardbus card has IO zone, PCI fixup will change window to
* cardbus */
val = BCM_PCI_IO_BASE_PA & MPI_L2P_BASE_MASK;
bcm_mpi_writel(val, MPI_L2PIOBASE_REG);
bcm_mpi_writel(~(BCM_PCI_IO_SIZE - 1), MPI_L2PIORANGE_REG);
bcm_mpi_writel(val | MPI_L2PREMAP_ENABLED_MASK, MPI_L2PIOREMAP_REG);
/* enable PCI related GPIO pins */
bcm_mpi_writel(MPI_LOCBUSCTL_EN_PCI_GPIO_MASK, MPI_LOCBUSCTL_REG);
/* setup PCI to local bus access, used by PCI device to target
* local RAM while bus mastering */
bcm63xx_int_cfg_writel(0, PCI_BASE_ADDRESS_3);
if (BCMCPU_IS_6358())
val = MPI_SP0_REMAP_ENABLE_MASK;
else
val = 0;
bcm_mpi_writel(val, MPI_SP0_REMAP_REG);
bcm63xx_int_cfg_writel(0x0, PCI_BASE_ADDRESS_4);
bcm_mpi_writel(0, MPI_SP1_REMAP_REG);
mem_size = bcm63xx_get_memory_size();
/* 6348 before rev b0 exposes only 16 MB of RAM memory through
* PCI, throw a warning if we have more memory */
if (BCMCPU_IS_6348() && (bcm63xx_get_cpu_rev() & 0xf0) == 0xa0) {
if (mem_size > (16 * 1024 * 1024))
printk(KERN_WARNING "bcm63xx: this CPU "
"revision cannot handle more than 16MB "
"of RAM for PCI bus mastering\n");
} else {
/* setup sp0 range to local RAM size */
bcm_mpi_writel(~(mem_size - 1), MPI_SP0_RANGE_REG);
bcm_mpi_writel(0, MPI_SP1_RANGE_REG);
}
/* change host bridge retry counter to infinite number of
* retry, needed for some broadcom wifi cards with Silicon
* Backplane bus where access to srom seems very slow */
val = bcm63xx_int_cfg_readl(BCMPCI_REG_TIMERS);
val &= ~REG_TIMER_RETRY_MASK;
bcm63xx_int_cfg_writel(val, BCMPCI_REG_TIMERS);
/* enable memory decoder and bus mastering */
val = bcm63xx_int_cfg_readl(PCI_COMMAND);
val |= (PCI_COMMAND_MEMORY | PCI_COMMAND_MASTER);
bcm63xx_int_cfg_writel(val, PCI_COMMAND);
/* enable read prefetching & disable byte swapping for bus
* mastering transfers */
val = bcm_mpi_readl(MPI_PCIMODESEL_REG);
val &= ~MPI_PCIMODESEL_BAR1_NOSWAP_MASK;
val &= ~MPI_PCIMODESEL_BAR2_NOSWAP_MASK;
val &= ~MPI_PCIMODESEL_PREFETCH_MASK;
val |= (8 << MPI_PCIMODESEL_PREFETCH_SHIFT);
bcm_mpi_writel(val, MPI_PCIMODESEL_REG);
/* enable pci interrupt */
val = bcm_mpi_readl(MPI_LOCINT_REG);
val |= MPI_LOCINT_MASK(MPI_LOCINT_EXT_PCI_INT);
bcm_mpi_writel(val, MPI_LOCINT_REG);
register_pci_controller(&bcm63xx_controller);
#ifdef CONFIG_CARDBUS
register_pci_controller(&bcm63xx_cb_controller);
#endif
/* mark memory space used for IO mapping as reserved */
request_mem_region(BCM_PCI_IO_BASE_PA, BCM_PCI_IO_SIZE,
"bcm63xx PCI IO space");
return 0;
}
