int board_late_init(void)
{
#ifdef CONFIG_ENV_VARS_UBOOT_RUNTIME_CONFIG
char *name = "unknown";
if (is_dra72x()) {
if (board_is_dra72x_revc_or_later())
name = "dra72x-revc";
else if (board_is_dra71x_evm())
name = "dra71x";
else
name = "dra72x";
} else {
name = "dra7xx";
}
set_board_info_env(name);
/*
* Default FIT boot on HS devices. Non FIT images are not allowed
* on HS devices.
*/
if (get_device_type() == HS_DEVICE)
env_set("boot_fit", "1");
omap_die_id_serial();
omap_set_fastboot_vars();
#endif
return 0;
}
int board_eth_init(bd_t *bis)
{
int ret;
uint8_t mac_addr[6];
uint32_t mac_hi, mac_lo;
uint32_t ctrl_val;
/* try reading mac address from efuse */
mac_lo = readl((*ctrl)->control_core_mac_id_0_lo);
mac_hi = readl((*ctrl)->control_core_mac_id_0_hi);
mac_addr[0] = (mac_hi & 0xFF0000) >> 16;
mac_addr[1] = (mac_hi & 0xFF00) >> 8;
mac_addr[2] = mac_hi & 0xFF;
mac_addr[3] = (mac_lo & 0xFF0000) >> 16;
mac_addr[4] = (mac_lo & 0xFF00) >> 8;
mac_addr[5] = mac_lo & 0xFF;
if (!getenv("ethaddr")) {
printf("<ethaddr> not set. Validating first E-fuse MAC\n");
if (is_valid_ethaddr(mac_addr))
eth_setenv_enetaddr("ethaddr", mac_addr);
}
mac_lo = readl((*ctrl)->control_core_mac_id_1_lo);
mac_hi = readl((*ctrl)->control_core_mac_id_1_hi);
mac_addr[0] = (mac_hi & 0xFF0000) >> 16;
mac_addr[1] = (mac_hi & 0xFF00) >> 8;
mac_addr[2] = mac_hi & 0xFF;
mac_addr[3] = (mac_lo & 0xFF0000) >> 16;
mac_addr[4] = (mac_lo & 0xFF00) >> 8;
mac_addr[5] = mac_lo & 0xFF;
if (!getenv("eth1addr")) {
if (is_valid_ethaddr(mac_addr))
eth_setenv_enetaddr("eth1addr", mac_addr);
}
ctrl_val = readl((*ctrl)->control_core_control_io1) & (~0x33);
ctrl_val |= 0x22;
writel(ctrl_val, (*ctrl)->control_core_control_io1);
if (*omap_si_rev == DRA722_ES1_0)
cpsw_data.active_slave = 1;
if (board_is_dra72x_revc_or_later()) {
cpsw_slaves[0].phy_if = PHY_INTERFACE_MODE_RGMII_ID;
cpsw_slaves[1].phy_if = PHY_INTERFACE_MODE_RGMII_ID;
}
ret = cpsw_register(&cpsw_data);
if (ret < 0)
printf("Error %d registering CPSW switch\n", ret);
return ret;
}
int board_fit_config_name_match(const char *name)
{
if (is_dra72x()) {
if (board_is_dra72x_revc_or_later()) {
if (!strcmp(name, "dra72-evm-revc"))
return 0;
} else if (!strcmp(name, "dra72-evm")) {
return 0;
}
} else if (!is_dra72x() && !strcmp(name, "dra7-evm")) {
return 0;
}
return -1;
}
int board_late_init(void)
{
#ifdef CONFIG_ENV_VARS_UBOOT_RUNTIME_CONFIG
char *name = "unknown";
if (is_dra72x()) {
if (board_is_dra72x_revc_or_later())
name = "dra72x-revc";
else if (board_is_dra71x_evm())
name = "dra71x";
else
name = "dra72x";
} else if (is_dra76x_abz()) {
name = "dra76x_abz";
} else if (is_dra76x_acd()) {
name = "dra76x_acd";
} else {
name = "dra7xx";
}
set_board_info_env(name);
/*
* Default FIT boot on HS devices. Non FIT images are not allowed
* on HS devices.
*/
if (get_device_type() == HS_DEVICE)
env_set("boot_fit", "1");
omap_die_id_serial();
omap_set_fastboot_vars();
/*
* Hook the LDO1 regulator to EN pin. This applies only to LP8733
* Rest all regulators are hooked to EN Pin at reset.
*/
if (board_is_dra71x_evm())
palmas_i2c_write_u8(LP873X_I2C_SLAVE_ADDR, 0x9, 0x7);
#endif
#if CONFIG_IS_ENABLED(DM_USB) && CONFIG_IS_ENABLED(OF_CONTROL)
if (device_okay("/ocp/omap_dwc3_1@48880000"))
enable_usb_clocks(0);
if (device_okay("/ocp/omap_dwc3_2@488c0000"))
enable_usb_clocks(1);
#endif
return 0;
}
int board_late_init(void)
{
#ifdef CONFIG_ENV_VARS_UBOOT_RUNTIME_CONFIG
char *name = "unknown";
if (is_dra72x()) {
if (board_is_dra72x_revc_or_later())
name = "dra72x-revc";
else
name = "dra72x";
} else {
name = "dra7xx";
}
set_board_info_env(name);
omap_die_id_serial();
#endif
return 0;
}
void recalibrate_iodelay(void)
{
struct pad_conf_entry const *pads, *delta_pads = NULL;
struct iodelay_cfg_entry const *iodelay;
int npads, niodelays, delta_npads = 0;
int ret;
switch (omap_revision()) {
case DRA722_ES1_0:
case DRA722_ES2_0:
pads = dra72x_core_padconf_array_common;
npads = ARRAY_SIZE(dra72x_core_padconf_array_common);
if (board_is_dra72x_revc_or_later()) {
delta_pads = dra72x_rgmii_padconf_array_revc;
delta_npads =
ARRAY_SIZE(dra72x_rgmii_padconf_array_revc);
iodelay = dra72_iodelay_cfg_array_revc;
niodelays = ARRAY_SIZE(dra72_iodelay_cfg_array_revc);
} else {
delta_pads = dra72x_rgmii_padconf_array_revb;
delta_npads =
ARRAY_SIZE(dra72x_rgmii_padconf_array_revb);
iodelay = dra72_iodelay_cfg_array_revb;
niodelays = ARRAY_SIZE(dra72_iodelay_cfg_array_revb);
}
break;
case DRA752_ES1_0:
case DRA752_ES1_1:
pads = dra74x_core_padconf_array;
npads = ARRAY_SIZE(dra74x_core_padconf_array);
iodelay = dra742_es1_1_iodelay_cfg_array;
niodelays = ARRAY_SIZE(dra742_es1_1_iodelay_cfg_array);
break;
default:
case DRA752_ES2_0:
pads = dra74x_core_padconf_array;
npads = ARRAY_SIZE(dra74x_core_padconf_array);
iodelay = dra742_es2_0_iodelay_cfg_array;
niodelays = ARRAY_SIZE(dra742_es2_0_iodelay_cfg_array);
/* Setup port1 and port2 for rgmii with 'no-id' mode */
clrset_spare_register(1, 0, RGMII2_ID_MODE_N_MASK |
RGMII1_ID_MODE_N_MASK);
break;
}
/* Setup I/O isolation */
ret = __recalibrate_iodelay_start();
if (ret)
goto err;
/* Do the muxing here */
do_set_mux32((*ctrl)->control_padconf_core_base, pads, npads);
/* Now do the weird minor deltas that should be safe */
if (delta_npads)
do_set_mux32((*ctrl)->control_padconf_core_base,
delta_pads, delta_npads);
/* Setup IOdelay configuration */
ret = do_set_iodelay((*ctrl)->iodelay_config_base, iodelay, niodelays);
err:
/* Closeup.. remove isolation */
__recalibrate_iodelay_end(ret);
}
void recalibrate_iodelay(void)
{
struct pad_conf_entry const *pads, *delta_pads = NULL;
struct iodelay_cfg_entry const *iodelay;
int npads, niodelays, delta_npads = 0;
int ret;
switch (omap_revision()) {
case DRA722_ES1_0:
case DRA722_ES2_0:
case DRA722_ES2_1:
pads = dra72x_core_padconf_array_common;
npads = ARRAY_SIZE(dra72x_core_padconf_array_common);
if (board_is_dra71x_evm()) {
pads = dra71x_core_padconf_array;
npads = ARRAY_SIZE(dra71x_core_padconf_array);
iodelay = dra71_iodelay_cfg_array;
niodelays = ARRAY_SIZE(dra71_iodelay_cfg_array);
/* If SW8 on the EVM is set to enable NAND then
* overwrite the pins used by VOUT3 with NAND.
*/
if (!nand_sw_detect()) {
delta_pads = dra71x_nand_padconf_array;
delta_npads =
ARRAY_SIZE(dra71x_nand_padconf_array);
} else {
delta_pads = dra71x_vout3_padconf_array;
delta_npads =
ARRAY_SIZE(dra71x_vout3_padconf_array);
}
} else if (board_is_dra72x_revc_or_later()) {
delta_pads = dra72x_rgmii_padconf_array_revc;
delta_npads =
ARRAY_SIZE(dra72x_rgmii_padconf_array_revc);
iodelay = dra72_iodelay_cfg_array_revc;
niodelays = ARRAY_SIZE(dra72_iodelay_cfg_array_revc);
} else {
delta_pads = dra72x_rgmii_padconf_array_revb;
delta_npads =
ARRAY_SIZE(dra72x_rgmii_padconf_array_revb);
iodelay = dra72_iodelay_cfg_array_revb;
niodelays = ARRAY_SIZE(dra72_iodelay_cfg_array_revb);
}
break;
case DRA752_ES1_0:
case DRA752_ES1_1:
pads = dra74x_core_padconf_array;
npads = ARRAY_SIZE(dra74x_core_padconf_array);
iodelay = dra742_es1_1_iodelay_cfg_array;
niodelays = ARRAY_SIZE(dra742_es1_1_iodelay_cfg_array);
break;
case DRA762_ACD_ES1_0:
case DRA762_ES1_0:
pads = dra76x_core_padconf_array;
npads = ARRAY_SIZE(dra76x_core_padconf_array);
iodelay = dra76x_es1_0_iodelay_cfg_array;
niodelays = ARRAY_SIZE(dra76x_es1_0_iodelay_cfg_array);
break;
default:
case DRA752_ES2_0:
case DRA762_ABZ_ES1_0:
pads = dra74x_core_padconf_array;
npads = ARRAY_SIZE(dra74x_core_padconf_array);
iodelay = dra742_es2_0_iodelay_cfg_array;
niodelays = ARRAY_SIZE(dra742_es2_0_iodelay_cfg_array);
/* Setup port1 and port2 for rgmii with 'no-id' mode */
clrset_spare_register(1, 0, RGMII2_ID_MODE_N_MASK |
RGMII1_ID_MODE_N_MASK);
break;
}
/* Setup I/O isolation */
ret = __recalibrate_iodelay_start();
if (ret)
goto err;
/* Do the muxing here */
do_set_mux32((*ctrl)->control_padconf_core_base, pads, npads);
/* Now do the weird minor deltas that should be safe */
if (delta_npads)
do_set_mux32((*ctrl)->control_padconf_core_base,
delta_pads, delta_npads);
if (is_dra76x())
/* Set mux for MCAN instead of DCAN1 */
clrsetbits_le32((*ctrl)->control_core_control_spare_rw,
MCAN_SEL_ALT_MASK, MCAN_SEL);
/* Setup IOdelay configuration */
ret = do_set_iodelay((*ctrl)->iodelay_config_base, iodelay, niodelays);
err:
/* Closeup.. remove isolation */
__recalibrate_iodelay_end(ret);
}
