static void cubieboard_setup_gpios(void)
{
/* Mux Status LED pins */
gpio_set_multipin_func(GPH, GPH_STATUS_LEDS, GPIO_PIN_FUNC_OUTPUT);
/* Turn on green LED to let user know we're executing coreboot code */
gpio_set(GPH, GPH_LED2_PIN_NO);
/* Mux UART pins */
gpio_set_multipin_func(GPB, GPB_UART0_PINS, GPB_UART0_FUNC);
/* Mux SD pins */
gpio_set_multipin_func(GPF, GPF_SD0_PINS, GPF_SD0_FUNC);
gpio_set_pin_func(GPH, 1, GPH1_SD0_DET_FUNC);
}
static enum cb_err cubieboard_setup_power(void)
{
enum cb_err err;
const struct device * pmu;
const struct drivers_xpowers_axp209_config *cfg;
/* Find the AXP209 in devicetree */
pmu = dev_find_slot_on_smbus(AXP209_BUS, AXP209_I2C_ADDR);
if (!pmu) {
printk(BIOS_ERR, "AXP209 not found in devicetree.cb\n");
return CB_ERR;
}
cfg = pmu->chip_info;
/* Mux TWI0 pins */
gpio_set_multipin_func(GPB, GPB_TWI0_PINS, GPB_TWI0_FUNC);
/* Enable TWI0 */
a1x_periph_clock_enable(A1X_CLKEN_TWI0);
a1x_twi_init(AXP209_BUS, 400000);
if ((err = axp209_init(AXP209_BUS)) != CB_SUCCESS) {
printk(BIOS_ERR, "PMU initialization failed\n");
return err;
}
if ((err = axp209_set_voltages(AXP209_BUS, cfg)) != CB_SUCCESS) {
printk(BIOS_WARNING, "Power setup incomplete: "
"CPU may hang when increasing clock\n");
return err;
}
printk(BIOS_SPEW, "VDD CPU (DCDC2): %imv\n", cfg->dcdc2_voltage_mv);
printk(BIOS_SPEW, "VDD DLL (DCDC3): %imv\n", cfg->dcdc3_voltage_mv);
printk(BIOS_SPEW, "AVCC (LDO2) : %imv\n", cfg->ldo2_voltage_mv);
printk(BIOS_SPEW, "CSI1-IO (LDO4) : %imv\n", cfg->ldo4_voltage_mv);
printk(BIOS_SPEW, "(LDO3) : %imv\n", cfg->ldo3_voltage_mv);
return CB_SUCCESS;
}
