void h3_init_irq(void)
{
omap1_init_common_hw();
omap_init_irq();
omap_gpio_init();
h3_init_smc91x();
}
static void __init h3_init(void)
{
h3_init_smc91x();
/* Here we assume the NOR boot config: NOR on CS3 (possibly swapped
* to address 0 by a dip switch), NAND on CS2B. The NAND driver will
* notice whether a NAND chip is enabled at probe time.
*
* H3 support NAND-boot, with a dip switch to put NOR on CS2B and NAND
* (which on H2 may be 16bit) on CS3. Try detecting that in code here,
* to avoid probing every possible flash configuration...
*/
nor_resource.end = nor_resource.start = omap_cs3_phys();
nor_resource.end += SZ_32M - 1;
nand_resource.end = nand_resource.start = OMAP_CS2B_PHYS;
nand_resource.end += SZ_4K - 1;
BUG_ON(gpio_request(H3_NAND_RB_GPIO_PIN, "NAND ready") < 0);
gpio_direction_input(H3_NAND_RB_GPIO_PIN);
/* GPIO10 Func_MUX_CTRL reg bit 29:27, Configure V2 to mode1 as GPIO */
/* GPIO10 pullup/down register, Enable pullup on GPIO10 */
omap_cfg_reg(V2_1710_GPIO10);
/* Mux pins for keypad */
omap_cfg_reg(F18_1610_KBC0);
omap_cfg_reg(D20_1610_KBC1);
omap_cfg_reg(D19_1610_KBC2);
omap_cfg_reg(E18_1610_KBC3);
omap_cfg_reg(C21_1610_KBC4);
omap_cfg_reg(G18_1610_KBR0);
omap_cfg_reg(F19_1610_KBR1);
omap_cfg_reg(H14_1610_KBR2);
omap_cfg_reg(E20_1610_KBR3);
omap_cfg_reg(E19_1610_KBR4);
omap_cfg_reg(N19_1610_KBR5);
/* GPIO based LEDs */
omap_cfg_reg(P18_1610_GPIO3);
omap_cfg_reg(MPUIO4);
smc91x_resources[1].start = gpio_to_irq(40);
smc91x_resources[1].end = gpio_to_irq(40);
platform_add_devices(devices, ARRAY_SIZE(devices));
h3_spi_board_info[0].irq = gpio_to_irq(H3_TS_GPIO);
spi_register_board_info(h3_spi_board_info,
ARRAY_SIZE(h3_spi_board_info));
omap_serial_init();
h3_i2c_board_info[1].irq = gpio_to_irq(14);
omap_register_i2c_bus(1, 100, h3_i2c_board_info,
ARRAY_SIZE(h3_i2c_board_info));
omap1_usb_init(&h3_usb_config);
h3_mmc_init();
omapfb_set_lcd_config(&h3_lcd_config);
}
void h3_init_irq(void)
{
omap_init_irq();
omap_gpio_init();
h3_init_smc91x();
}
