static int iwl_trans_rx_stop(struct iwl_priv *priv)
{
/* stop Rx DMA */
iwl_write_direct32(priv, FH_MEM_RCSR_CHNL0_CONFIG_REG, 0);
return iwl_poll_direct_bit(priv, FH_MEM_RSSR_RX_STATUS_REG,
FH_RSSR_CHNL0_RX_STATUS_CHNL_IDLE, 1000);
}
/* FIXME: same implementation as 4965 */
static int iwl5000_apm_stop_master(struct iwl_priv *priv)
{
unsigned long flags;
spin_lock_irqsave(&priv->lock, flags);
/* set stop master bit */
iwl_set_bit(priv, CSR_RESET, CSR_RESET_REG_FLAG_STOP_MASTER);
iwl_poll_direct_bit(priv, CSR_RESET,
CSR_RESET_REG_FLAG_MASTER_DISABLED, 100);
spin_unlock_irqrestore(&priv->lock, flags);
IWL_DEBUG_INFO(priv, "stop master\n");
return 0;
}
static int iwl5000_apm_init(struct iwl_priv *priv)
{
int ret = 0;
iwl_set_bit(priv, CSR_GIO_CHICKEN_BITS,
CSR_GIO_CHICKEN_BITS_REG_BIT_DIS_L0S_EXIT_TIMER);
/* disable L0s without affecting L1 :don't wait for ICH L0s bug W/A) */
iwl_set_bit(priv, CSR_GIO_CHICKEN_BITS,
CSR_GIO_CHICKEN_BITS_REG_BIT_L1A_NO_L0S_RX);
/* Set FH wait threshold to maximum (HW error during stress W/A) */
iwl_set_bit(priv, CSR_DBG_HPET_MEM_REG, CSR_DBG_HPET_MEM_REG_VAL);
/* enable HAP INTA to move device L1a -> L0s */
iwl_set_bit(priv, CSR_HW_IF_CONFIG_REG,
CSR_HW_IF_CONFIG_REG_BIT_HAP_WAKE_L1A);
if (priv->cfg->need_pll_cfg)
iwl_set_bit(priv, CSR_ANA_PLL_CFG, CSR50_ANA_PLL_CFG_VAL);
/* set "initialization complete" bit to move adapter
* D0U* --> D0A* state */
iwl_set_bit(priv, CSR_GP_CNTRL, CSR_GP_CNTRL_REG_FLAG_INIT_DONE);
/* wait for clock stabilization */
ret = iwl_poll_direct_bit(priv, CSR_GP_CNTRL,
CSR_GP_CNTRL_REG_FLAG_MAC_CLOCK_READY, 25000);
if (ret < 0) {
IWL_DEBUG_INFO(priv, "Failed to init the card\n");
return ret;
}
/* enable DMA */
iwl_write_prph(priv, APMG_CLK_EN_REG, APMG_CLK_VAL_DMA_CLK_RQT);
udelay(20);
/* disable L1-Active */
iwl_set_bits_prph(priv, APMG_PCIDEV_STT_REG,
APMG_PCIDEV_STT_VAL_L1_ACT_DIS);
return ret;
}
static int iwl5000_apm_reset(struct iwl_priv *priv)
{
int ret = 0;
iwl5000_apm_stop_master(priv);
iwl_set_bit(priv, CSR_RESET, CSR_RESET_REG_FLAG_SW_RESET);
udelay(10);
/* FIXME: put here L1A -L0S w/a */
if (priv->cfg->need_pll_cfg)
iwl_set_bit(priv, CSR_ANA_PLL_CFG, CSR50_ANA_PLL_CFG_VAL);
/* set "initialization complete" bit to move adapter
* D0U* --> D0A* state */
iwl_set_bit(priv, CSR_GP_CNTRL, CSR_GP_CNTRL_REG_FLAG_INIT_DONE);
/* wait for clock stabilization */
ret = iwl_poll_direct_bit(priv, CSR_GP_CNTRL,
CSR_GP_CNTRL_REG_FLAG_MAC_CLOCK_READY, 25000);
if (ret < 0) {
IWL_DEBUG_INFO(priv, "Failed to init the card\n");
goto out;
}
/* enable DMA */
iwl_write_prph(priv, APMG_CLK_EN_REG, APMG_CLK_VAL_DMA_CLK_RQT);
udelay(20);
/* disable L1-Active */
iwl_set_bits_prph(priv, APMG_PCIDEV_STT_REG,
APMG_PCIDEV_STT_VAL_L1_ACT_DIS);
out:
return ret;
}
/*
* The device's EEPROM semaphore prevents conflicts between driver and uCode
* when accessing the EEPROM; each access is a series of pulses to/from the
* EEPROM chip, not a single event, so even reads could conflict if they
* weren't arbitrated by the semaphore.
*/
int iwlcore_eeprom_acquire_semaphore(struct iwl_priv *priv)
{
u16 count;
int ret;
for (count = 0; count < EEPROM_SEM_RETRY_LIMIT; count++) {
/* Request semaphore */
iwl_set_bit(priv, CSR_HW_IF_CONFIG_REG,
CSR_HW_IF_CONFIG_REG_BIT_EEPROM_OWN_SEM);
/* See if we got it */
ret = iwl_poll_direct_bit(priv, CSR_HW_IF_CONFIG_REG,
CSR_HW_IF_CONFIG_REG_BIT_EEPROM_OWN_SEM,
EEPROM_SEM_TIMEOUT);
if (ret >= 0) {
IWL_DEBUG_IO(priv, "Acquired semaphore after %d tries.\n",
count+1);
return ret;
}
}
return ret;
}
static int iwl_read_otp_word(struct iwl_priv *priv, u16 addr, u16 *eeprom_data)
{
int ret = 0;
u32 r;
u32 otpgp;
_iwl_write32(priv, CSR_EEPROM_REG,
CSR_EEPROM_REG_MSK_ADDR & (addr << 1));
ret = iwl_poll_direct_bit(priv, CSR_EEPROM_REG,
CSR_EEPROM_REG_READ_VALID_MSK,
IWL_EEPROM_ACCESS_TIMEOUT);
if (ret < 0) {
IWL_ERR(priv, "Time out reading OTP[%d]\n", addr);
return ret;
}
r = _iwl_read_direct32(priv, CSR_EEPROM_REG);
/* check for ECC errors: */
otpgp = iwl_read32(priv, CSR_OTP_GP_REG);
if (otpgp & CSR_OTP_GP_REG_ECC_UNCORR_STATUS_MSK) {
/* stop in this case */
/* set the uncorrectable OTP ECC bit for acknowledgement */
iwl_set_bit(priv, CSR_OTP_GP_REG,
CSR_OTP_GP_REG_ECC_UNCORR_STATUS_MSK);
IWL_ERR(priv, "Uncorrectable OTP ECC error, abort OTP read\n");
return -EINVAL;
}
if (otpgp & CSR_OTP_GP_REG_ECC_CORR_STATUS_MSK) {
/* continue in this case */
/* set the correctable OTP ECC bit for acknowledgement */
iwl_set_bit(priv, CSR_OTP_GP_REG,
CSR_OTP_GP_REG_ECC_CORR_STATUS_MSK);
IWL_ERR(priv, "Correctable OTP ECC error, continue read\n");
}
*eeprom_data = le16_to_cpu((__force __le16)(r >> 16));
return 0;
}
static int iwl_init_otp_access(struct iwl_priv *priv)
{
int ret;
/* Enable 40MHz radio clock */
_iwl_write32(priv, CSR_GP_CNTRL,
_iwl_read32(priv, CSR_GP_CNTRL) |
CSR_GP_CNTRL_REG_FLAG_INIT_DONE);
/* wait for clock to be ready */
ret = iwl_poll_direct_bit(priv, CSR_GP_CNTRL,
CSR_GP_CNTRL_REG_FLAG_MAC_CLOCK_READY,
25000);
if (ret < 0)
IWL_ERR(priv, "Time out access OTP\n");
else {
iwl_set_bits_prph(priv, APMG_PS_CTRL_REG,
APMG_PS_CTRL_VAL_RESET_REQ);
udelay(5);
iwl_clear_bits_prph(priv, APMG_PS_CTRL_REG,
APMG_PS_CTRL_VAL_RESET_REQ);
}
return ret;
}
/**
* iwl_eeprom_init - read EEPROM contents
*
* Load the EEPROM contents from adapter into priv->eeprom
*
* NOTE: This routine uses the non-debug IO access functions.
*/
int iwl_eeprom_init(struct iwl_priv *priv)
{
u16 *e;
u32 gp = iwl_read32(priv, CSR_EEPROM_GP);
int sz;
int ret;
u16 addr;
u16 validblockaddr = 0;
u16 cache_addr = 0;
priv->nvm_device_type = iwlcore_get_nvm_type(priv);
/* allocate eeprom */
IWL_DEBUG_INFO(priv, "NVM size = %d\n", priv->cfg->eeprom_size);
sz = priv->cfg->eeprom_size;
priv->eeprom = kzalloc(sz, GFP_KERNEL);
if (!priv->eeprom) {
ret = -ENOMEM;
goto alloc_err;
}
e = (u16 *)priv->eeprom;
ret = priv->cfg->ops->lib->eeprom_ops.verify_signature(priv);
if (ret < 0) {
IWL_ERR(priv, "EEPROM not found, EEPROM_GP=0x%08x\n", gp);
ret = -ENOENT;
goto err;
}
/* Make sure driver (instead of uCode) is allowed to read EEPROM */
ret = priv->cfg->ops->lib->eeprom_ops.acquire_semaphore(priv);
if (ret < 0) {
IWL_ERR(priv, "Failed to acquire EEPROM semaphore.\n");
ret = -ENOENT;
goto err;
}
if (priv->nvm_device_type == NVM_DEVICE_TYPE_OTP) {
ret = iwl_init_otp_access(priv);
if (ret) {
IWL_ERR(priv, "Failed to initialize OTP access.\n");
ret = -ENOENT;
goto done;
}
_iwl_write32(priv, CSR_EEPROM_GP,
iwl_read32(priv, CSR_EEPROM_GP) &
~CSR_EEPROM_GP_IF_OWNER_MSK);
iwl_set_bit(priv, CSR_OTP_GP_REG,
CSR_OTP_GP_REG_ECC_CORR_STATUS_MSK |
CSR_OTP_GP_REG_ECC_UNCORR_STATUS_MSK);
/* traversing the linked list if no shadow ram supported */
if (!priv->cfg->shadow_ram_support) {
if (iwl_find_otp_image(priv, &validblockaddr)) {
ret = -ENOENT;
goto done;
}
}
for (addr = validblockaddr; addr < validblockaddr + sz;
addr += sizeof(u16)) {
u16 eeprom_data;
ret = iwl_read_otp_word(priv, addr, &eeprom_data);
if (ret)
goto done;
e[cache_addr / 2] = eeprom_data;
cache_addr += sizeof(u16);
}
} else {
/* eeprom is an array of 16bit values */
for (addr = 0; addr < sz; addr += sizeof(u16)) {
u32 r;
_iwl_write32(priv, CSR_EEPROM_REG,
CSR_EEPROM_REG_MSK_ADDR & (addr << 1));
ret = iwl_poll_direct_bit(priv, CSR_EEPROM_REG,
CSR_EEPROM_REG_READ_VALID_MSK,
IWL_EEPROM_ACCESS_TIMEOUT);
if (ret < 0) {
IWL_ERR(priv, "Time out reading EEPROM[%d]\n", addr);
goto done;
}
r = _iwl_read_direct32(priv, CSR_EEPROM_REG);
e[addr / 2] = le16_to_cpu((__force __le16)(r >> 16));
}
}
ret = 0;
done:
priv->cfg->ops->lib->eeprom_ops.release_semaphore(priv);
err:
if (ret)
iwl_eeprom_free(priv);
alloc_err:
return ret;
}
/*
* iwl_pcie_rx_stop - stops the Rx DMA
*/
int iwl_pcie_rx_stop(struct iwl_trans *trans)
{
iwl_write_direct32(trans, FH_MEM_RCSR_CHNL0_CONFIG_REG, 0);
return iwl_poll_direct_bit(trans, FH_MEM_RSSR_RX_STATUS_REG,
FH_RSSR_CHNL0_RX_STATUS_CHNL_IDLE, 1000);
}
