static void __init innovator_map_io(void)
{
omap_map_io();
#ifdef CONFIG_ARCH_OMAP1510
if (cpu_is_omap1510()) {
iotable_init(innovator1510_io_desc, ARRAY_SIZE(innovator1510_io_desc));
udelay(10); /* Delay needed for FPGA */
/* Dump the Innovator FPGA rev early - useful info for support. */
printk("Innovator FPGA Rev %d.%d Board Rev %d\n",
fpga_read(OMAP1510_FPGA_REV_HIGH),
fpga_read(OMAP1510_FPGA_REV_LOW),
fpga_read(OMAP1510_FPGA_BOARD_REV));
}
#endif
omap_serial_init(innovator_serial_ports);
}
static void __init omap_perseus2_map_io(void)
{
omap_map_io();
iotable_init(omap_perseus2_io_desc,
ARRAY_SIZE(omap_perseus2_io_desc));
/* Early, board-dependent init */
/*
* Hold GSM Reset until needed
*/
omap_writew(omap_readw(OMAP730_DSP_M_CTL) & ~1, OMAP730_DSP_M_CTL);
/*
* UARTs -> done automagically by 8250 driver
*/
/*
* CSx timings, GPIO Mux ... setup
*/
/* Flash: CS0 timings setup */
omap_writel(0x0000fff3, OMAP730_FLASH_CFG_0);
omap_writel(0x00000088, OMAP730_FLASH_ACFG_0);
/*
* Ethernet support trough the debug board
* CS1 timings setup
*/
omap_writel(0x0000fff3, OMAP730_FLASH_CFG_1);
omap_writel(0x00000000, OMAP730_FLASH_ACFG_1);
/*
* Configure MPU_EXT_NIRQ IO in IO_CONF9 register,
* It is used as the Ethernet controller interrupt
*/
omap_writel(omap_readl(OMAP730_IO_CONF_9) & 0x1FFFFFFF, OMAP730_IO_CONF_9);
omap_serial_init(p2_serial_ports);
}
static void __init omap_generic_map_io(void)
{
omap_map_io();
}
static void __init h3_map_io(void)
{
omap_map_io();
omap_serial_init(h3_serial_ports);
}
