Ejemplos de oxygen_reset_uart en C++ (Cpp)

Ejemplo n.º 1

Archivo: xonar_hdmi.c Proyecto: 12rafael/jellytimekernel

static void xonar_hdmi_init_commands(struct oxygen *chip,
				     struct xonar_hdmi *hdmi)
{
	u8 param;

	oxygen_reset_uart(chip);
	param = 0;
	hdmi_write_command(chip, 0x61, 1, &param);
	param = 1;
	hdmi_write_command(chip, 0x74, 1, &param);
	hdmi_write_command(chip, 0x54, 5, hdmi->params);
}

Ejemplo n.º 2

static void xonar_hdav_resume(struct oxygen *chip)
{
    struct xonar_data *data = chip->model_data;
    u8 param;

    oxygen_reset_uart(chip);
    param = 0;
    hdmi_write_command(chip, 0x61, 1, &param);
    param = 1;
    hdmi_write_command(chip, 0x74, 1, &param);
    hdmi_write_command(chip, 0x54, 5, data->hdmi_params);
    pcm1796_init(chip);
    xonar_enable_output(chip);
}

Ejemplo n.º 3

Archivo: virtuoso.c Proyecto: antonywcl/AR-5315u_PLD

static void xonar_hdav_init(struct oxygen *chip)
{
	struct xonar_data *data = chip->model_data;
	u8 param;

	oxygen_write16(chip, OXYGEN_2WIRE_BUS_STATUS,
		       OXYGEN_2WIRE_LENGTH_8 |
		       OXYGEN_2WIRE_INTERRUPT_MASK |
		       OXYGEN_2WIRE_SPEED_FAST);

	data->anti_pop_delay = 100;
	data->dacs = chip->model.private_data == MODEL_HDAV_H6 ? 4 : 1;
	data->output_enable_bit = GPIO_DX_OUTPUT_ENABLE;
	data->ext_power_reg = OXYGEN_GPI_DATA;
	data->ext_power_int_reg = OXYGEN_GPI_INTERRUPT_MASK;
	data->ext_power_bit = GPI_DX_EXT_POWER;
	data->pcm1796_oversampling = PCM1796_OS_64;

	pcm1796_init(chip);

	oxygen_set_bits16(chip, OXYGEN_GPIO_CONTROL, GPIO_DX_INPUT_ROUTE);
	oxygen_clear_bits16(chip, OXYGEN_GPIO_DATA, GPIO_DX_INPUT_ROUTE);

	oxygen_reset_uart(chip);
	param = 0;
	hdmi_write_command(chip, 0x61, 1, &param);
	param = 1;
	hdmi_write_command(chip, 0x74, 1, &param);
	data->hdmi_params[1] = IEC958_AES3_CON_FS_48000;
	data->hdmi_params[4] = 1;
	hdmi_write_command(chip, 0x54, 5, data->hdmi_params);

	xonar_common_init(chip);

	snd_component_add(chip->card, "PCM1796");
	snd_component_add(chip->card, "CS5381");
}