/*
* Our handling of the processor debug registers is non-trivial.
* We do not clear them on entry and exit from the kernel. Therefore
* it is possible to get a watchpoint trap here from inside the kernel.
* However, the code in ./ptrace.c has ensured that the user can
* only set watchpoints on userspace addresses. Therefore the in-kernel
* watchpoint trap can only occur in code which is reading/writing
* from user space. Such code must not hold kernel locks (since it
* can equally take a page fault), therefore it is safe to call
* force_sig_info even though that claims and releases locks.
*
* Code in ./signal.c ensures that the debug control register
* is restored before we deliver any signal, and therefore that
* user code runs with the correct debug control register even though
* we clear it here.
*
* Being careful here means that we don't have to be as careful in a
* lot of more complicated places (task switching can be a bit lazy
* about restoring all the debug state, and ptrace doesn't have to
* find every occurrence of the TF bit that could be saved away even
* by user code)
*
* May run on IST stack.
*/
dotraplinkage void __kprobes do_debug(struct pt_regs *regs, long error_code)
{
struct task_struct *tsk = current;
unsigned long dr6;
int si_code;
get_debugreg(dr6, 6);
/* Catch kmemcheck conditions first of all! */
if ((dr6 & DR_STEP) && kmemcheck_trap(regs))
return;
/* DR6 may or may not be cleared by the CPU */
set_debugreg(0, 6);
/*
* The processor cleared BTF, so don't mark that we need it set.
*/
clear_tsk_thread_flag(tsk, TIF_DEBUGCTLMSR);
tsk->thread.debugctlmsr = 0;
/* Store the virtualized DR6 value */
tsk->thread.debugreg6 = dr6;
if (notify_die(DIE_DEBUG, "debug", regs, PTR_ERR(&dr6), error_code,
SIGTRAP) == NOTIFY_STOP)
return;
/* It's safe to allow irq's after DR6 has been saved */
preempt_conditional_sti(regs);
if (regs->flags & X86_VM_MASK) {
handle_vm86_trap((struct kernel_vm86_regs *) regs,
error_code, 1);
return;
}
/*
* Single-stepping through system calls: ignore any exceptions in
* kernel space, but re-enable TF when returning to user mode.
*
* We already checked v86 mode above, so we can check for kernel mode
* by just checking the CPL of CS.
*/
if ((dr6 & DR_STEP) && !user_mode(regs)) {
tsk->thread.debugreg6 &= ~DR_STEP;
set_tsk_thread_flag(tsk, TIF_SINGLESTEP);
regs->flags &= ~X86_EFLAGS_TF;
}
si_code = get_si_code(tsk->thread.debugreg6);
if (tsk->thread.debugreg6 & (DR_STEP | DR_TRAP_BITS))
send_sigtrap(tsk, regs, error_code, si_code);
preempt_conditional_cli(regs);
return;
}
/*
* XXX Check PT_DTRACE vs TIF_SINGLESTEP for singlestepping check and
* PT_PTRACED vs TIF_SYSCALL_TRACE for syscall tracing check
*/
void syscall_trace(struct uml_pt_regs *regs, int entryexit)
{
int is_singlestep = (current->ptrace & PT_DTRACE) && entryexit;
int tracesysgood;
if (unlikely(current->audit_context)) {
if (!entryexit)
audit_syscall_entry(HOST_AUDIT_ARCH,
UPT_SYSCALL_NR(regs),
UPT_SYSCALL_ARG1(regs),
UPT_SYSCALL_ARG2(regs),
UPT_SYSCALL_ARG3(regs),
UPT_SYSCALL_ARG4(regs));
else audit_syscall_exit(AUDITSC_RESULT(UPT_SYSCALL_RET(regs)),
UPT_SYSCALL_RET(regs));
}
/* Fake a debug trap */
if (is_singlestep)
send_sigtrap(current, regs, 0);
if (!test_thread_flag(TIF_SYSCALL_TRACE))
return;
if (!(current->ptrace & PT_PTRACED))
return;
/*
* the 0x80 provides a way for the tracing parent to distinguish
* between a syscall stop and SIGTRAP delivery
*/
tracesysgood = (current->ptrace & PT_TRACESYSGOOD);
ptrace_notify(SIGTRAP | (tracesysgood ? 0x80 : 0));
if (entryexit) /* force do_signal() --> is_syscall() */
set_thread_flag(TIF_SIGPENDING);
/*
* this isn't the same as continuing with a signal, but it will do
* for normal use. strace only continues with a signal if the
* stopping signal is not SIGTRAP. -brl
*/
if (current->exit_code) {
send_sig(current->exit_code, current, 1);
current->exit_code = 0;
}
}
void syscall_trace_leave(struct pt_regs *regs)
{
int ptraced = current->ptrace;
audit_syscall_exit(regs);
/* Fake a debug trap */
if (ptraced & PT_DTRACE)
send_sigtrap(current, ®s->regs, 0);
if (!test_thread_flag(TIF_SYSCALL_TRACE))
return;
tracehook_report_syscall_exit(regs, 0);
/* force do_signal() --> is_syscall() */
if (ptraced & PT_PTRACED)
set_thread_flag(TIF_SIGPENDING);
}
void __kprobes do_breakpoint(struct pt_regs* regs, int fault_num)
{
send_sigtrap(current, regs, fault_num);
}
/*
* Our handling of the processor debug registers is non-trivial.
* We do not clear them on entry and exit from the kernel. Therefore
* it is possible to get a watchpoint trap here from inside the kernel.
* However, the code in ./ptrace.c has ensured that the user can
* only set watchpoints on userspace addresses. Therefore the in-kernel
* watchpoint trap can only occur in code which is reading/writing
* from user space. Such code must not hold kernel locks (since it
* can equally take a page fault), therefore it is safe to call
* force_sig_info even though that claims and releases locks.
*
* Code in ./signal.c ensures that the debug control register
* is restored before we deliver any signal, and therefore that
* user code runs with the correct debug control register even though
* we clear it here.
*
* Being careful here means that we don't have to be as careful in a
* lot of more complicated places (task switching can be a bit lazy
* about restoring all the debug state, and ptrace doesn't have to
* find every occurrence of the TF bit that could be saved away even
* by user code)
*
* May run on IST stack.
*/
dotraplinkage void __kprobes do_debug(struct pt_regs *regs, long error_code)
{
struct task_struct *tsk = current;
unsigned long condition;
int si_code;
get_debugreg(condition, 6);
/*
* The processor cleared BTF, so don't mark that we need it set.
*/
clear_tsk_thread_flag(tsk, TIF_DEBUGCTLMSR);
tsk->thread.debugctlmsr = 0;
if (notify_die(DIE_DEBUG, "debug", regs, condition, error_code,
SIGTRAP) == NOTIFY_STOP)
return;
/* It's safe to allow irq's after DR6 has been saved */
preempt_conditional_sti(regs);
/* Mask out spurious debug traps due to lazy DR7 setting */
if (condition & (DR_TRAP0|DR_TRAP1|DR_TRAP2|DR_TRAP3)) {
if (!tsk->thread.debugreg7)
goto clear_dr7;
}
#ifdef CONFIG_X86_32
if (regs->flags & X86_VM_MASK)
goto debug_vm86;
#endif
/* Save debug status register where ptrace can see it */
tsk->thread.debugreg6 = condition;
/*
* Single-stepping through TF: make sure we ignore any events in
* kernel space (but re-enable TF when returning to user mode).
*/
if (condition & DR_STEP) {
if (!user_mode(regs))
goto clear_TF_reenable;
}
si_code = get_si_code(condition);
/* Ok, finally something we can handle */
send_sigtrap(tsk, regs, error_code, si_code);
/*
* Disable additional traps. They'll be re-enabled when
* the signal is delivered.
*/
clear_dr7:
set_debugreg(0, 7);
preempt_conditional_cli(regs);
return;
#ifdef CONFIG_X86_32
debug_vm86:
/* reenable preemption: handle_vm86_trap() might sleep */
dec_preempt_count();
handle_vm86_trap((struct kernel_vm86_regs *) regs, error_code, 1);
conditional_cli(regs);
return;
#endif
clear_TF_reenable:
set_tsk_thread_flag(tsk, TIF_SINGLESTEP);
regs->flags &= ~X86_EFLAGS_TF;
preempt_conditional_cli(regs);
return;
}
/* Handle synthetic interrupt delivered only by the simulator. */
void __kprobes do_breakpoint(struct pt_regs* regs, int fault_num)
{
enum ctx_state prev_state = exception_enter();
send_sigtrap(current, regs);
exception_exit(prev_state);
}
