int do_fastboot (cmd_tbl_t *cmdtp, int flag, int argc, char *argv[])
{
int ret = 1;
unsigned long val;
/* Initialize the board specific support */
if (0 == fastboot_init(&interface))
{
printf ("Fastboot entered...\n");
run_command("setgreenled 50", 0);
fastboot_countdown = CFG_FASTBOOT_COUNTDOWN;
/* If we got this far, we are a success */
ret = 0;
val = getbootmode();
/* On disconnect or error, polling returns non zero */
/* Always delay for fastboot unless we're in bootmode 4002
* or using the "factory" cable */
if((0x4002 != val) && !(__raw_readl(0x48055138) & 0x00100000)){
while (fastboot_countdown)
{
if (!fastboot_confirmed) {
fastboot_countdown--;
}
if (fastboot_poll())
break;
/* if we're holding down the button to get into
* recovery, don't wait for the fastboot timeout so we don't
* accidentally power off. short circuit 49999/50000 times
* through to keep from overwhelming the twl6030 */
if (!(fastboot_countdown % 50000) &&
(0 == twl6030_get_power_button_status())) {
fastboot_wait_power_button_abort = 1;
break;
}
}
}else{
while (1)
{
if (fastboot_poll())
break;
}
}
}
/* Reset the board specific support */
fastboot_shutdown();
/* If we're in 4003, go on to OMAP boot over USB */
if(0x4003 == val){
printf ("setting boot sequence first to USB.\nreboot...\n");
set_SWBootingCfg();
}
return ret;
}
int do_fastboot (cmd_tbl_t *cmdtp, int flag, int argc, char *argv[])
{
int ret = 1;
unsigned long val;
/* Initialize the board specific support */
if (0 == fastboot_init(&interface))
{
showimage(FASTBOOT);
printf ("Fastboot entered...\n");
fastboot_countdown = CFG_FASTBOOT_COUNTDOWN;
/* If we got this far, we are a success */
ret = 0;
val = idme_get_bootmode();
/* On disconnect or error, polling returns non zero */
if((5 == val) && !(__raw_readl(0x48055138) & 0x00100000)){
while (fastboot_countdown)
{
if (!fastboot_confirmed) {
fastboot_countdown--;
}
if (fastboot_poll())
break;
}
}else{
while (1)
{
if (fastboot_poll())
break;
}
}
}
/* Reset the board specific support */
fastboot_shutdown();
if(5 == val){
printf ("setting boot sequence first to USB.\nreboot...\n");
set_SWBootingCfg();
}
printf ("Fastboot exited...\n");
return ret;
}
int do_fastboot (cmd_tbl_t *cmdtp, int flag, int argc, char *argv[])
{
int ret = 1;
#if defined(CONFIG_MACH_BOWSER_SUBTYPE_TATE)
unsigned long val;
#endif
/* Initialize the board specific support */
if (0 == fastboot_init(&interface))
{
printf ("Fastboot entered...\n");
#if defined(CONFIG_FASTBOOT_COUNTDOWN)
fastboot_countdown = CFG_FASTBOOT_COUNTDOWN;
#endif
/* If we got this far, we are a success */
ret = 0;
#if defined(CONFIG_MACH_BOWSER_SUBTYPE_TATE)
val = getbootmode();
#endif
/* On disconnect or error, polling returns non zero */
#if defined(CONFIG_FASTBOOT_COUNTDOWN)
if((3 == flag) ){
while (fastboot_countdown--)
{
if (fastboot_poll()) break;
if (fastboot_confirmed == 1) {
show_fastboot();
while (1) {
if (fastboot_poll())
break;
}
} else {
if (fastboot_poll()) break;
}
}
}else{
show_fastboot();
while (1)
{
if (fastboot_poll())
break;
}
}
#else
show_fastboot();
while (1)
{
if (fastboot_poll())
break;
}
#endif
}
/* Reset the board specific support */
fastboot_shutdown();
#if defined(CONFIG_MACH_BOWSER_SUBTYPE_TATE)
if(0x5 == val) {
printf ("setting boot sequence first to USB.\nreboot...\n");
set_SWBootingCfg();
}
#endif
return ret;
}
