static int spi_dw_release(struct device *dev, const struct spi_config *config)
{
struct spi_dw_data *spi = dev->driver_data;
if (!spi_context_configured(&spi->ctx, config)) {
return -EINVAL;
}
spi_context_unlock_unconditionally(&spi->ctx);
return 0;
}
static int spi_nrfx_release(struct device *dev,
const struct spi_config *spi_cfg)
{
struct spi_nrfx_data *dev_data = get_dev_data(dev);
if (!spi_context_configured(&dev_data->ctx, spi_cfg)) {
return -EINVAL;
}
spi_context_unlock_unconditionally(&dev_data->ctx);
return 0;
}
static int configure(struct device *dev,
const struct spi_config *spi_cfg)
{
struct spi_context *ctx = &get_dev_data(dev)->ctx;
if (spi_context_configured(ctx, spi_cfg)) {
/* Already configured. No need to do it again. */
return 0;
}
if (SPI_OP_MODE_GET(spi_cfg->operation) == SPI_OP_MODE_MASTER) {
LOG_ERR("Master mode is not supported on %s",
dev->config->name);
return -EINVAL;
}
if (spi_cfg->operation & SPI_MODE_LOOP) {
LOG_ERR("Loopback mode is not supported");
return -EINVAL;
}
if ((spi_cfg->operation & SPI_LINES_MASK) != SPI_LINES_SINGLE) {
LOG_ERR("Only single line mode is supported");
return -EINVAL;
}
if (SPI_WORD_SIZE_GET(spi_cfg->operation) != 8) {
LOG_ERR("Word sizes other than 8 bits"
" are not supported");
return -EINVAL;
}
if (spi_cfg->cs) {
LOG_ERR("CS control via GPIO is not supported");
return -EINVAL;
}
ctx->config = spi_cfg;
nrf_spis_configure(get_dev_config(dev)->spis.p_reg,
get_nrf_spis_mode(spi_cfg->operation),
get_nrf_spis_bit_order(spi_cfg->operation));
return 0;
}
static int spi_stm32_configure(struct spi_config *config)
{
const struct spi_stm32_config *cfg = CONFIG_CFG(config);
struct spi_stm32_data *data = CONFIG_DATA(config);
const u32_t scaler[] = {
LL_SPI_BAUDRATEPRESCALER_DIV2,
LL_SPI_BAUDRATEPRESCALER_DIV4,
LL_SPI_BAUDRATEPRESCALER_DIV8,
LL_SPI_BAUDRATEPRESCALER_DIV16,
LL_SPI_BAUDRATEPRESCALER_DIV32,
LL_SPI_BAUDRATEPRESCALER_DIV64,
LL_SPI_BAUDRATEPRESCALER_DIV128,
LL_SPI_BAUDRATEPRESCALER_DIV256
};
SPI_TypeDef *spi = cfg->spi;
u32_t clock;
int br;
if (spi_context_configured(&data->ctx, config)) {
/* Nothing to do */
return 0;
}
if (SPI_WORD_SIZE_GET(config->operation) != 8) {
return -ENOTSUP;
}
clock_control_get_rate(device_get_binding(STM32_CLOCK_CONTROL_NAME),
(clock_control_subsys_t) &cfg->pclken, &clock);
for (br = 1 ; br <= ARRAY_SIZE(scaler) ; ++br) {
u32_t clk = clock >> br;
if (clk < config->frequency) {
break;
}
}
if (br > ARRAY_SIZE(scaler)) {
SYS_LOG_ERR("Unsupported frequency %uHz, max %uHz, min %uHz",
config->frequency,
clock >> 1,
clock >> ARRAY_SIZE(scaler));
return -EINVAL;
}
static int spi_dw_configure(const struct spi_dw_config *info,
struct spi_dw_data *spi,
const struct spi_config *config)
{
u32_t ctrlr0 = 0U;
LOG_DBG("%p (prev %p)", config, spi->ctx.config);
if (spi_context_configured(&spi->ctx, config)) {
/* Nothing to do */
return 0;
}
/* Verify if requested op mode is relevant to this controller */
if (config->operation & SPI_OP_MODE_SLAVE) {
if (!(info->op_modes & SPI_CTX_RUNTIME_OP_MODE_SLAVE)) {
LOG_ERR("Slave mode not supported");
return -ENOTSUP;
}
} else {
if (!(info->op_modes & SPI_CTX_RUNTIME_OP_MODE_MASTER)) {
LOG_ERR("Master mode not supported");
return -ENOTSUP;
}
}
if (config->operation & (SPI_TRANSFER_LSB |
SPI_LINES_DUAL | SPI_LINES_QUAD)) {
LOG_ERR("Unsupported configuration");
return -EINVAL;
}
/* Word size */
ctrlr0 |= DW_SPI_CTRLR0_DFS(SPI_WORD_SIZE_GET(config->operation));
/* Determine how many bytes are required per-frame */
spi->dfs = SPI_WS_TO_DFS(SPI_WORD_SIZE_GET(config->operation));
/* SPI mode */
if (SPI_MODE_GET(config->operation) & SPI_MODE_CPOL) {
ctrlr0 |= DW_SPI_CTRLR0_SCPOL;
}
if (SPI_MODE_GET(config->operation) & SPI_MODE_CPHA) {
ctrlr0 |= DW_SPI_CTRLR0_SCPH;
}
if (SPI_MODE_GET(config->operation) & SPI_MODE_LOOP) {
ctrlr0 |= DW_SPI_CTRLR0_SRL;
}
/* Installing the configuration */
write_ctrlr0(ctrlr0, info->regs);
/* At this point, it's mandatory to set this on the context! */
spi->ctx.config = config;
if (!spi_dw_is_slave(spi)) {
/* Baud rate and Slave select, for master only */
write_baudr(SPI_DW_CLK_DIVIDER(config->frequency), info->regs);
write_ser(1 << config->slave, info->regs);
}
spi_context_cs_configure(&spi->ctx);
if (spi_dw_is_slave(spi)) {
LOG_DBG("Installed slave config %p:"
" ws/dfs %u/%u, mode %u/%u/%u",
config,
SPI_WORD_SIZE_GET(config->operation), spi->dfs,
(SPI_MODE_GET(config->operation) &
SPI_MODE_CPOL) ? 1 : 0,
(SPI_MODE_GET(config->operation) &
SPI_MODE_CPHA) ? 1 : 0,
(SPI_MODE_GET(config->operation) &
SPI_MODE_LOOP) ? 1 : 0);
} else {
LOG_DBG("Installed master config %p: freq %uHz (div = %u),"
" ws/dfs %u/%u, mode %u/%u/%u, slave %u",
config, config->frequency,
SPI_DW_CLK_DIVIDER(config->frequency),
SPI_WORD_SIZE_GET(config->operation), spi->dfs,
(SPI_MODE_GET(config->operation) &
SPI_MODE_CPOL) ? 1 : 0,
(SPI_MODE_GET(config->operation) &
SPI_MODE_CPHA) ? 1 : 0,
(SPI_MODE_GET(config->operation) &
SPI_MODE_LOOP) ? 1 : 0,
config->slave);
}
return 0;
}