/*
* TODO(crbug.com/505480): Setting muxes often involves I2C transcations,
* which can block. Consider implementing an asynchronous task.
*/
void usb_mux_set(int port, enum typec_mux mux_mode,
enum usb_switch usb_mode, int polarity)
{
const struct usb_mux *mux = &usb_muxes[port];
int res;
mux_state_t mux_state;
#ifdef CONFIG_USB_CHARGER
/* Configure USB2.0 */
usb_charger_set_switches(port, usb_mode);
#endif
/* Configure superspeed lanes */
mux_state = polarity ? mux_mode | MUX_POLARITY_INVERTED : mux_mode;
res = mux->driver->set(mux->port_addr, mux_state);
if (res) {
CPRINTS("Error setting mux port(%d): %d", port, res);
return;
}
if (enable_debug_prints)
CPRINTS(
"usb/dp mux: port(%d) typec_mux(%d) usb2(%d) polarity(%d)",
port, mux_mode, usb_mode, polarity);
}
static void usb_charger_bc12_detect(int port)
{
int device_type, charger_status;
struct charge_port_info charge;
int type;
charge.voltage = USB_CHARGER_VOLTAGE_MV;
/* Read interrupt register to clear on chip */
pi3usb9281_get_interrupts(port);
if (usb_charger_port_is_sourcing_vbus(port)) {
/* If we're sourcing VBUS then we're not charging */
device_type = charger_status = 0;
} else {
/* Set device type */
device_type = pi3usb9281_get_device_type(port);
charger_status = pi3usb9281_get_charger_status(port);
}
/* Debounce pin plug order if we detect a charger */
if (device_type || PI3USB9281_CHG_STATUS_ANY(charger_status)) {
msleep(USB_CHG_DEBOUNCE_DELAY_MS);
/* next operation might trigger a detach interrupt */
pi3usb9281_disable_interrupts(port);
/* Ensure D+/D- are open before resetting */
pi3usb9281_set_switch_manual(port, 1);
pi3usb9281_set_pins(port, 0);
/* Let D+/D- relax to their idle state */
msleep(40);
/*
* Trigger chip reset to refresh detection registers.
* WARNING: This reset is acceptable for samus_pd,
* but may not be acceptable for devices that have
* an OTG / device mode, as we may be interrupting
* the connection.
*/
pi3usb9281_reset(port);
/*
* Restore data switch settings - switches return to
* closed on reset until restored.
*/
usb_charger_set_switches(port, USB_SWITCH_RESTORE);
/* Clear possible disconnect interrupt */
pi3usb9281_get_interrupts(port);
/* Mask attach interrupt */
pi3usb9281_set_interrupt_mask(port,
0xff &
~PI3USB9281_INT_ATTACH);
/* Re-enable interrupts */
pi3usb9281_enable_interrupts(port);
msleep(USB_CHG_RESET_DELAY_MS);
/* Clear possible attach interrupt */
pi3usb9281_get_interrupts(port);
/* Re-enable attach interrupt */
pi3usb9281_set_interrupt_mask(port, 0xff);
/* Re-read ID registers */
device_type = pi3usb9281_get_device_type(port);
charger_status = pi3usb9281_get_charger_status(port);
}
/* Attachment: decode + update available charge */
if (device_type || PI3USB9281_CHG_STATUS_ANY(charger_status)) {
if (PI3USB9281_CHG_STATUS_ANY(charger_status))
type = CHARGE_SUPPLIER_PROPRIETARY;
else if (device_type & PI3USB9281_TYPE_CDP)
type = CHARGE_SUPPLIER_BC12_CDP;
else if (device_type & PI3USB9281_TYPE_DCP)
type = CHARGE_SUPPLIER_BC12_DCP;
else if (device_type & PI3USB9281_TYPE_SDP)
type = CHARGE_SUPPLIER_BC12_SDP;
else
type = CHARGE_SUPPLIER_OTHER;
charge.current = pi3usb9281_get_ilim(device_type,
charger_status);
charge_manager_update_charge(type, port, &charge);
} else { /* Detachment: update available charge to 0 */
charge.current = 0;
charge_manager_update_charge(
CHARGE_SUPPLIER_PROPRIETARY,
port,
&charge);
charge_manager_update_charge(
CHARGE_SUPPLIER_BC12_CDP,
port,
&charge);
charge_manager_update_charge(
CHARGE_SUPPLIER_BC12_DCP,
port,
&charge);
charge_manager_update_charge(
CHARGE_SUPPLIER_BC12_SDP,
port,
&charge);
charge_manager_update_charge(
CHARGE_SUPPLIER_OTHER,
port,
&charge);
}
/* notify host of power info change */
pd_send_host_event(PD_EVENT_POWER_CHANGE);
}
