/*
* Helper for ASPM support.
*
* Disable PLL when in L0s as well as receiver clock when in L1.
* This power saving option must be enabled through the SerDes.
*
* Programming the SerDes must go through the same 288 bit serial shift
* register as the other analog registers. Hence the 9 writes.
*/
static void ar9003_hw_configpcipowersave(struct ath_hw *ah,
bool power_off)
{
/* Nothing to do on restore for 11N */
if (!power_off /* !restore */) {
/* set bit 19 to allow forcing of pcie core into L1 state */
REG_SET_BIT(ah, AR_PCIE_PM_CTRL, AR_PCIE_PM_CTRL_ENA);
/* Several PCIe massages to ensure proper behaviour */
if (ah->config.pcie_waen)
REG_WRITE(ah, AR_WA, ah->config.pcie_waen);
else
REG_WRITE(ah, AR_WA, ah->WARegVal);
}
/*
* Configire PCIE after Ini init. SERDES values now come from ini file
* This enables PCIe low power mode.
*/
if (ah->config.pcieSerDesWrite) {
unsigned int i;
struct ar5416IniArray *array;
array = power_off ? &ah->iniPcieSerdes :
&ah->iniPcieSerdesLowPower;
for (i = 0; i < array->ia_rows; i++) {
REG_WRITE(ah,
INI_RA(array, i, 0),
INI_RA(array, i, 1));
}
}
}
static void ar9003_hw_prog_ini(struct ath_hw *ah,
struct ar5416IniArray *iniArr,
int column)
{
unsigned int i, regWrites = 0;
/* New INI format: Array may be undefined (pre, core, post arrays) */
if (!iniArr->ia_array)
return;
/*
* New INI format: Pre, core, and post arrays for a given subsystem
* may be modal (> 2 columns) or non-modal (2 columns). Determine if
* the array is non-modal and force the column to 1.
*/
if (column >= iniArr->ia_columns)
column = 1;
for (i = 0; i < iniArr->ia_rows; i++) {
u32 reg = INI_RA(iniArr, i, 0);
u32 val = INI_RA(iniArr, i, column);
if (reg >= 0x16000 && reg < 0x17000)
ath9k_hw_analog_shift_regwrite(ah, reg, val);
else
REG_WRITE(ah, reg, val);
DO_DELAY(regWrites);
}
}
/*
* This routine is called to configure the SerDes register for the
* Merlin 2.0 and above chip during WOW sleep.
*/
static void
ar928xConfigSerDes_WowSleep(struct ath_hal *ah)
{
int i;
struct ath_hal_5416 *ahp = AH5416(ah);
/*
* For WOW sleep, we reprogram the SerDes so that the PLL and CHK REQ
* are both enabled. This uses more power but the Maverick team reported
* that otherwise, WOW sleep is unstable and chip may disappears.
*/
for (i = 0; i < ahp->ah_iniPcieSerdesWow.ia_rows; i++) {
OS_REG_WRITE(ah, INI_RA(&ahp->ah_iniPcieSerdesWow, i, 0), INI_RA(&ahp->ah_iniPcieSerdesWow, i, 1));
}
OS_DELAY(1000);
}
