static void dsi_config(struct drm_encoder *encoder)
{
struct drm_device *dev = encoder->dev;
struct drm_i915_private *dev_priv = dev->dev_private;
struct intel_dsi *intel_dsi = enc_to_intel_dsi(encoder);
struct intel_crtc *intel_crtc = to_intel_crtc(encoder->crtc);
int pipe = intel_crtc->pipe;
u32 tmp;
DRM_DEBUG_KMS("\n");
/* escape clock divider, 20MHz, shared for A and C. device ready must be
* off when doing this! txclkesc? */
tmp = I915_READ(MIPI_CTRL(0));
tmp &= ~ESCAPE_CLOCK_DIVIDER_MASK;
I915_WRITE(MIPI_CTRL(0), tmp | ESCAPE_CLOCK_DIVIDER_1);
/* read request priority is per pipe */
tmp = I915_READ(MIPI_CTRL(pipe));
tmp &= ~READ_REQUEST_PRIORITY_MASK;
I915_WRITE(MIPI_CTRL(pipe), tmp | READ_REQUEST_PRIORITY_HIGH);
/* XXX: why here, why like this? handling in irq handler?! */
I915_WRITE(MIPI_INTR_EN(pipe), 0xffffffff);
/* why here, was elsewhere... also 2a, 0c, 60, 08 for values */
I915_WRITE(MIPI_DPHY_PARAM(pipe), intel_dsi->dphy_reg);
}
void vlv_dsi_reset_clocks(struct intel_encoder *encoder, enum port port)
{
u32 temp;
struct drm_i915_private *dev_priv = to_i915(encoder->base.dev);
struct intel_dsi *intel_dsi = enc_to_intel_dsi(&encoder->base);
temp = I915_READ(MIPI_CTRL(port));
temp &= ~ESCAPE_CLOCK_DIVIDER_MASK;
I915_WRITE(MIPI_CTRL(port), temp |
intel_dsi->escape_clk_div <<
ESCAPE_CLOCK_DIVIDER_SHIFT);
}
static void intel_dsi_post_disable(struct intel_encoder *encoder)
{
struct drm_i915_private *dev_priv = encoder->base.dev->dev_private;
struct intel_crtc *intel_crtc = to_intel_crtc(encoder->base.crtc);
struct intel_dsi *intel_dsi = enc_to_intel_dsi(&encoder->base);
int pipe = intel_crtc->pipe;
u32 tmp;
int count = 1;
wait_for_dsi_fifo_empty(intel_dsi);
intel_dsi_port_disable(encoder);
/* Panel commands can be sent when clock is in LP11 */
if (intel_dsi->dual_link)
count = 2;
do {
tmp = I915_READ(MIPI_DEVICE_READY(pipe));
tmp &= ~DEVICE_READY;
I915_WRITE(MIPI_DEVICE_READY(pipe), tmp);
tmp = I915_READ(MIPI_CTRL(pipe));
tmp &= ~ESCAPE_CLOCK_DIVIDER_MASK;
I915_WRITE(MIPI_CTRL(pipe), tmp |
intel_dsi->escape_clk_div <<
ESCAPE_CLOCK_DIVIDER_SHIFT);
tmp = I915_READ(MIPI_DSI_FUNC_PRG(pipe));
tmp &= ~VID_MODE_FORMAT_MASK;
I915_WRITE(MIPI_DSI_FUNC_PRG(pipe), tmp);
I915_WRITE(MIPI_EOT_DISABLE(pipe), CLOCKSTOP);
tmp = I915_READ(MIPI_DSI_FUNC_PRG(pipe));
tmp &= ~VID_MODE_FORMAT_MASK;
I915_WRITE(MIPI_DSI_FUNC_PRG(pipe), tmp);
tmp = I915_READ(MIPI_DEVICE_READY(pipe));
tmp &= DEVICE_READY;
I915_WRITE(MIPI_DEVICE_READY(pipe), tmp);
pipe = PIPE_B;
} while (--count > 0);
/* if disable packets are sent before sending shutdown packet then in
* some next enable sequence send turn on packet error is observed */
if (intel_dsi->dev.dev_ops->disable)
intel_dsi->dev.dev_ops->disable(&intel_dsi->dev);
wait_for_dsi_fifo_empty(intel_dsi);
intel_dsi_clear_device_ready(encoder);
}
static void intel_dsi_disable(struct intel_encoder *encoder)
{
struct drm_device *dev = encoder->base.dev;
struct drm_i915_private *dev_priv = dev->dev_private;
struct intel_crtc *intel_crtc = to_intel_crtc(encoder->base.crtc);
struct intel_dsi *intel_dsi = enc_to_intel_dsi(&encoder->base);
int pipe = intel_crtc->pipe;
u32 temp;
DRM_DEBUG_KMS("\n");
if (is_vid_mode(intel_dsi)) {
wait_for_dsi_fifo_empty(intel_dsi);
/* de-assert ip_tg_enable signal */
temp = I915_READ(MIPI_PORT_CTRL(pipe));
I915_WRITE(MIPI_PORT_CTRL(pipe), temp & ~DPI_ENABLE);
POSTING_READ(MIPI_PORT_CTRL(pipe));
msleep(2);
}
/* Panel commands can be sent when clock is in LP11 */
I915_WRITE(MIPI_DEVICE_READY(pipe), 0x0);
temp = I915_READ(MIPI_CTRL(pipe));
temp &= ~ESCAPE_CLOCK_DIVIDER_MASK;
I915_WRITE(MIPI_CTRL(pipe), temp |
intel_dsi->escape_clk_div <<
ESCAPE_CLOCK_DIVIDER_SHIFT);
I915_WRITE(MIPI_EOT_DISABLE(pipe), CLOCKSTOP);
temp = I915_READ(MIPI_DSI_FUNC_PRG(pipe));
temp &= ~VID_MODE_FORMAT_MASK;
I915_WRITE(MIPI_DSI_FUNC_PRG(pipe), temp);
I915_WRITE(MIPI_DEVICE_READY(pipe), 0x1);
/* if disable packets are sent before sending shutdown packet then in
* some next enable sequence send turn on packet error is observed */
if (intel_dsi->dev.dev_ops->disable)
intel_dsi->dev.dev_ops->disable(&intel_dsi->dev);
wait_for_dsi_fifo_empty(intel_dsi);
}
static void intel_dsi_mode_set(struct intel_encoder *intel_encoder)
{
struct drm_encoder *encoder = &intel_encoder->base;
struct drm_device *dev = encoder->dev;
struct drm_i915_private *dev_priv = dev->dev_private;
struct intel_crtc *intel_crtc = to_intel_crtc(encoder->crtc);
struct intel_dsi *intel_dsi = enc_to_intel_dsi(encoder);
struct drm_display_mode *adjusted_mode =
&intel_crtc->config.adjusted_mode;
int pipe = intel_crtc->pipe;
unsigned int bpp = intel_crtc->config.pipe_bpp;
u32 val, tmp;
DRM_DEBUG_KMS("pipe %c\n", pipe_name(pipe));
/* XXX: Location of the call */
band_gap_reset(dev_priv);
/* escape clock divider, 20MHz, shared for A and C. device ready must be
* off when doing this! txclkesc? */
tmp = I915_READ(MIPI_CTRL(0));
tmp &= ~ESCAPE_CLOCK_DIVIDER_MASK;
I915_WRITE(MIPI_CTRL(0), tmp | ESCAPE_CLOCK_DIVIDER_1);
/* read request priority is per pipe */
tmp = I915_READ(MIPI_CTRL(pipe));
tmp &= ~READ_REQUEST_PRIORITY_MASK;
I915_WRITE(MIPI_CTRL(pipe), tmp | READ_REQUEST_PRIORITY_HIGH);
/* XXX: why here, why like this? handling in irq handler?! */
I915_WRITE(MIPI_INTR_STAT(pipe), 0xffffffff);
I915_WRITE(MIPI_INTR_EN(pipe), 0xffffffff);
I915_WRITE(MIPI_DPHY_PARAM(pipe), intel_dsi->dphy_reg);
I915_WRITE(MIPI_DPI_RESOLUTION(pipe),
adjusted_mode->vdisplay << VERTICAL_ADDRESS_SHIFT |
adjusted_mode->hdisplay << HORIZONTAL_ADDRESS_SHIFT);
set_dsi_timings(encoder, adjusted_mode);
val = intel_dsi->lane_count << DATA_LANES_PRG_REG_SHIFT;
if (is_cmd_mode(intel_dsi)) {
val |= intel_dsi->channel << CMD_MODE_CHANNEL_NUMBER_SHIFT;
val |= CMD_MODE_DATA_WIDTH_8_BIT; /* XXX */
} else {
val |= intel_dsi->channel << VID_MODE_CHANNEL_NUMBER_SHIFT;
/* XXX: cross-check bpp vs. pixel format? */
val |= intel_dsi->pixel_format;
}
I915_WRITE(MIPI_DSI_FUNC_PRG(pipe), val);
/* timeouts for recovery. one frame IIUC. if counter expires, EOT and
* stop state. */
/*
* In burst mode, value greater than one DPI line Time in byte clock
* (txbyteclkhs) To timeout this timer 1+ of the above said value is
* recommended.
*
* In non-burst mode, Value greater than one DPI frame time in byte
* clock(txbyteclkhs) To timeout this timer 1+ of the above said value
* is recommended.
*
* In DBI only mode, value greater than one DBI frame time in byte
* clock(txbyteclkhs) To timeout this timer 1+ of the above said value
* is recommended.
*/
if (is_vid_mode(intel_dsi) &&
intel_dsi->video_mode_format == VIDEO_MODE_BURST) {
I915_WRITE(MIPI_HS_TX_TIMEOUT(pipe),
txbyteclkhs(adjusted_mode->htotal, bpp,
intel_dsi->lane_count) + 1);
} else {
I915_WRITE(MIPI_HS_TX_TIMEOUT(pipe),
txbyteclkhs(adjusted_mode->vtotal *
adjusted_mode->htotal,
bpp, intel_dsi->lane_count) + 1);
}
I915_WRITE(MIPI_LP_RX_TIMEOUT(pipe), intel_dsi->lp_rx_timeout);
I915_WRITE(MIPI_TURN_AROUND_TIMEOUT(pipe), intel_dsi->turn_arnd_val);
I915_WRITE(MIPI_DEVICE_RESET_TIMER(pipe), intel_dsi->rst_timer_val);
/* dphy stuff */
/* in terms of low power clock */
I915_WRITE(MIPI_INIT_COUNT(pipe), txclkesc(ESCAPE_CLOCK_DIVIDER_1, 100));
/* recovery disables */
I915_WRITE(MIPI_EOT_DISABLE(pipe), intel_dsi->eot_disable);
/* in terms of txbyteclkhs. actual high to low switch +
* MIPI_STOP_STATE_STALL * MIPI_LP_BYTECLK.
*
* XXX: write MIPI_STOP_STATE_STALL?
*/
I915_WRITE(MIPI_HIGH_LOW_SWITCH_COUNT(pipe),
intel_dsi->hs_to_lp_count);
/* XXX: low power clock equivalence in terms of byte clock. the number
* of byte clocks occupied in one low power clock. based on txbyteclkhs
* and txclkesc. txclkesc time / txbyteclk time * (105 +
* MIPI_STOP_STATE_STALL) / 105.???
*/
I915_WRITE(MIPI_LP_BYTECLK(pipe), intel_dsi->lp_byte_clk);
/* the bw essential for transmitting 16 long packets containing 252
* bytes meant for dcs write memory command is programmed in this
* register in terms of byte clocks. based on dsi transfer rate and the
* number of lanes configured the time taken to transmit 16 long packets
* in a dsi stream varies. */
I915_WRITE(MIPI_DBI_BW_CTRL(pipe), intel_dsi->bw_timer);
I915_WRITE(MIPI_CLK_LANE_SWITCH_TIME_CNT(pipe),
intel_dsi->clk_lp_to_hs_count << LP_HS_SSW_CNT_SHIFT |
intel_dsi->clk_hs_to_lp_count << HS_LP_PWR_SW_CNT_SHIFT);
if (is_vid_mode(intel_dsi))
I915_WRITE(MIPI_VIDEO_MODE_FORMAT(pipe),
intel_dsi->video_frmt_cfg_bits |
intel_dsi->video_mode_format);
}
