void LCD_Init( uint8_t numLines, uint8_t numCols )
{
OSRAMInit( false );
gNumLines = numLines;
gNumCols = numCols;
LCD_Clear();
LCD_DisplayOn();
} // LCD_Init
static void prvSetupHardware( void )
{
/* Setup the PLL. */
SysCtlClockSet( SYSCTL_SYSDIV_10 | SYSCTL_USE_PLL | SYSCTL_OSC_MAIN | SYSCTL_XTAL_6MHZ );
/* Setup the push button. */
SysCtlPeripheralEnable(SYSCTL_PERIPH_GPIOC);
GPIODirModeSet(GPIO_PORTC_BASE, mainPUSH_BUTTON, GPIO_DIR_MODE_IN);
GPIOIntTypeSet( GPIO_PORTC_BASE, mainPUSH_BUTTON,GPIO_FALLING_EDGE );
IntPrioritySet( INT_GPIOC, configKERNEL_INTERRUPT_PRIORITY );
GPIOPinIntEnable( GPIO_PORTC_BASE, mainPUSH_BUTTON );
IntEnable( INT_GPIOC );
/* Enable the UART. */
SysCtlPeripheralEnable(SYSCTL_PERIPH_UART0);
SysCtlPeripheralEnable(SYSCTL_PERIPH_GPIOA);
/* Set GPIO A0 and A1 as peripheral function. They are used to output the
UART signals. */
GPIODirModeSet( GPIO_PORTA_BASE, GPIO_PIN_0 | GPIO_PIN_1, GPIO_DIR_MODE_HW );
/* Configure the UART for 8-N-1 operation. */
UARTConfigSetExpClk( UART0_BASE, SysCtlClockGet(), mainBAUD_RATE, UART_CONFIG_WLEN_8 | UART_CONFIG_PAR_NONE | UART_CONFIG_STOP_ONE );
/* We don't want to use the fifo. This is for test purposes to generate
as many interrupts as possible. */
HWREG( UART0_BASE + UART_O_LCR_H ) &= ~mainFIFO_SET;
/* Enable Tx interrupts. */
HWREG( UART0_BASE + UART_O_IM ) |= UART_INT_TX;
IntPrioritySet( INT_UART0, configKERNEL_INTERRUPT_PRIORITY );
IntEnable( INT_UART0 );
/* Initialise the LCD> */
OSRAMInit( false );
OSRAMStringDraw("www.FreeRTOS.org", 0, 0);
OSRAMStringDraw("LM3S811 demo", 16, 1);
}
