/* LCD power controller */
static void smdk6440_lte480_reset_power(struct plat_lcd_data *pd,
unsigned int power)
{
int err;
if (power) {
err = gpio_request(S5P6440_GPN(5), "GPN");
if (err) {
printk(KERN_ERR "failed to request GPN for lcd reset\n");
return;
}
gpio_direction_output(S5P6440_GPN(5), 1);
gpio_set_value(S5P6440_GPN(5), 0);
gpio_set_value(S5P6440_GPN(5), 1);
gpio_free(S5P6440_GPN(5));
}
}
static int s5p64x0_irq_eint_set_type(struct irq_data *data, unsigned int type)
{
int offs = eint_offset(data->irq);
int shift;
u32 ctrl, mask;
u32 newvalue = 0;
if (offs > 15)
return -EINVAL;
switch (type) {
case IRQ_TYPE_NONE:
printk(KERN_WARNING "No edge setting!\n");
break;
case IRQ_TYPE_EDGE_RISING:
newvalue = S3C2410_EXTINT_RISEEDGE;
break;
case IRQ_TYPE_EDGE_FALLING:
newvalue = S3C2410_EXTINT_FALLEDGE;
break;
case IRQ_TYPE_EDGE_BOTH:
newvalue = S3C2410_EXTINT_BOTHEDGE;
break;
case IRQ_TYPE_LEVEL_LOW:
newvalue = S3C2410_EXTINT_LOWLEV;
break;
case IRQ_TYPE_LEVEL_HIGH:
newvalue = S3C2410_EXTINT_HILEV;
break;
default:
printk(KERN_ERR "No such irq type %d", type);
return -EINVAL;
}
shift = (offs / 2) * 4;
mask = 0x7 << shift;
ctrl = __raw_readl(S5P64X0_EINT0CON0) & ~mask;
ctrl |= newvalue << shift;
__raw_writel(ctrl, S5P64X0_EINT0CON0);
/* Configure the GPIO pin for 6450 or 6440 based on CPU ID */
if (soc_is_s5p6450())
s3c_gpio_cfgpin(S5P6450_GPN(offs), S3C_GPIO_SFN(2));
else
s3c_gpio_cfgpin(S5P6440_GPN(offs), S3C_GPIO_SFN(2));
return 0;
}
.ngpio = S5P6440_GPIO_I_NR,
.label = "GPI",
},
}, {
.base = S5P64X0_GPJ_BASE,
.config = &s5p64x0_gpio_cfgs[3],
.chip = {
.base = S5P6440_GPJ(0),
.ngpio = S5P6440_GPIO_J_NR,
.label = "GPJ",
},
}, {
.base = S5P64X0_GPN_BASE,
.config = &s5p64x0_gpio_cfgs[4],
.chip = {
.base = S5P6440_GPN(0),
.ngpio = S5P6440_GPIO_N_NR,
.label = "GPN",
},
}, {
.base = S5P64X0_GPP_BASE,
.config = &s5p64x0_gpio_cfgs[5],
.chip = {
.base = S5P6440_GPP(0),
.ngpio = S5P6440_GPIO_P_NR,
.label = "GPP",
},
},
};
static struct s3c_gpio_chip s5p6450_gpio_4bit[] = {