C++ (Cpp) USB_OTG_BSP_DriveVBUS Examples

Example #1

File: usbh_core.c Project: bleuelotus/SweepRobot_Testing_Host_STemWin

uint8_t USBH_Disconnected (USB_OTG_CORE_HANDLE *pdev)
{
  USB_OTG_BSP_DriveVBUS(pdev,0);
  /* Disable all interrupts. */
  USB_OTG_WRITE_REG32(&pdev->regs.GREGS->GINTMSK, 0);
  
  /* Clear any pending interrupts. */
  USB_OTG_WRITE_REG32(&pdev->regs.GREGS->GINTSTS, 0xFFFFFFFF);
  USB_OTG_DisableGlobalInt(pdev);
  pdev->host.ConnSts = 0;
  return 0;  
}

Example #2

File: usb_bsp.c Project: denisweir/STM32F40X

void  USB_OTG_BSP_ConfigVBUS(USB_OTG_CORE_HANDLE *pdev)
{
  GPIO_InitTypeDef GPIO_InitStructure; 

  RCC_AHB1PeriphClockCmd( RCC_AHB1Periph_GPIOH , ENABLE);

  GPIO_InitStructure.GPIO_Pin = HOST_POWERSW_VBUS;
  GPIO_InitStructure.GPIO_Speed = GPIO_Speed_2MHz;
  GPIO_InitStructure.GPIO_Mode = GPIO_Mode_OUT;
  GPIO_InitStructure.GPIO_OType = GPIO_OType_OD;
  GPIO_InitStructure.GPIO_PuPd = GPIO_PuPd_UP ;
  GPIO_Init(HOST_POWERSW_PORT,&GPIO_InitStructure);

  /* By Default, DISABLE is needed on output of the Power Switch */
  USB_OTG_BSP_DriveVBUS (pdev, 0);

  USB_OTG_BSP_mDelay(200);   /* Delay is need for stabilising the Vbus Low 
  in Reset Condition, when Vbus=1 and Reset-button is pressed by user */
}

Example #3

File: usb_core.c Project: m4th3u5/USB-HID--host-keyboard-anbt2-final-com-acento--repete--limites---menu-e-correcoes

//--------------------------------------------------------------
void USB_OTG_DriveVbus (USB_OTG_CORE_HANDLE *pdev, uint8_t state)
{
  USB_OTG_HPRT0_TypeDef     hprt0;
  
  hprt0.d32 = 0;
  
  /* enable disable the external charge pump */
  USB_OTG_BSP_DriveVBUS(pdev, state);
  
  /* Turn on the Host port power. */
  hprt0.d32 = USB_OTG_ReadHPRT0(pdev);
  if ((hprt0.b.prtpwr == 0 ) && (state == 1 ))
  {
    hprt0.b.prtpwr = 1;
    USB_OTG_WRITE_REG32(pdev->regs.HPRT0, hprt0.d32);
  }
  if ((hprt0.b.prtpwr == 1 ) && (state == 0 ))
  {
    hprt0.b.prtpwr = 0;
    USB_OTG_WRITE_REG32(pdev->regs.HPRT0, hprt0.d32);
  }
  
  USB_OTG_BSP_mDelay(200);
}