/* hcd->hub_irq_enable() */
static void admhc_rhsc_enable(struct usb_hcd *hcd)
{
struct admhcd *ahcd = hcd_to_admhcd(hcd);
spin_lock_irq(&ahcd->lock);
if (!ahcd->autostop)
del_timer(&hcd->rh_timer); /* Prevent next poll */
admhc_intr_enable(ahcd, ADMHC_INTR_INSM);
spin_unlock_irq(&ahcd->lock);
}
static irqreturn_t admhc_irq(struct usb_hcd *hcd)
{
struct admhcd *ahcd = hcd_to_admhcd(hcd);
struct admhcd_regs __iomem *regs = ahcd->regs;
u32 ints;
ints = admhc_readl(ahcd, ®s->int_status);
if ((ints & ADMHC_INTR_INTA) == 0) {
/* no unmasked interrupt status is set */
return IRQ_NONE;
}
ints &= admhc_readl(ahcd, ®s->int_enable);
if (ints & ADMHC_INTR_FATI) {
/* e.g. due to PCI Master/Target Abort */
admhc_disable(ahcd);
admhc_err(ahcd, "Fatal Error, controller disabled\n");
admhc_dump(ahcd, 1);
admhc_usb_reset(ahcd);
}
if (ints & ADMHC_INTR_BABI) {
admhc_intr_disable(ahcd, ADMHC_INTR_BABI);
admhc_intr_ack(ahcd, ADMHC_INTR_BABI);
admhc_err(ahcd, "Babble Detected\n");
}
if (ints & ADMHC_INTR_INSM) {
admhc_vdbg(ahcd, "Root Hub Status Change\n");
ahcd->next_statechange = jiffies + STATECHANGE_DELAY;
admhc_intr_ack(ahcd, ADMHC_INTR_RESI | ADMHC_INTR_INSM);
/* NOTE: Vendors didn't always make the same implementation
* choices for RHSC. Many followed the spec; RHSC triggers
* on an edge, like setting and maybe clearing a port status
* change bit. With others it's level-triggered, active
* until khubd clears all the port status change bits. We'll
* always disable it here and rely on polling until khubd
* re-enables it.
*/
admhc_intr_disable(ahcd, ADMHC_INTR_INSM);
usb_hcd_poll_rh_status(hcd);
} else if (ints & ADMHC_INTR_RESI) {
/* For connect and disconnect events, we expect the controller
* to turn on RHSC along with RD. But for remote wakeup events
* this might not happen.
*/
admhc_vdbg(ahcd, "Resume Detect\n");
admhc_intr_ack(ahcd, ADMHC_INTR_RESI);
hcd->poll_rh = 1;
if (ahcd->autostop) {
spin_lock(&ahcd->lock);
admhc_rh_resume(ahcd);
spin_unlock(&ahcd->lock);
} else
usb_hcd_resume_root_hub(hcd);
}
if (ints & ADMHC_INTR_TDC) {
admhc_vdbg(ahcd, "Transfer Descriptor Complete\n");
admhc_intr_ack(ahcd, ADMHC_INTR_TDC);
if (HC_IS_RUNNING(hcd->state))
admhc_intr_disable(ahcd, ADMHC_INTR_TDC);
spin_lock(&ahcd->lock);
admhc_td_complete(ahcd);
spin_unlock(&ahcd->lock);
if (HC_IS_RUNNING(hcd->state))
admhc_intr_enable(ahcd, ADMHC_INTR_TDC);
}
if (ints & ADMHC_INTR_SO) {
/* could track INTR_SO to reduce available PCI/... bandwidth */
admhc_vdbg(ahcd, "Schedule Overrun\n");
}
#if 1
spin_lock(&ahcd->lock);
if (ahcd->ed_rm_list)
finish_unlinks(ahcd, admhc_frame_no(ahcd));
if ((ints & ADMHC_INTR_SOFI) != 0 && !ahcd->ed_rm_list
&& HC_IS_RUNNING(hcd->state))
admhc_intr_disable(ahcd, ADMHC_INTR_SOFI);
spin_unlock(&ahcd->lock);
#else
if (ints & ADMHC_INTR_SOFI) {
admhc_vdbg(ahcd, "Start Of Frame\n");
spin_lock(&ahcd->lock);
/* handle any pending ED removes */
finish_unlinks(ahcd, admhc_frameno(ahcd));
/* leaving INTR_SOFI enabled when there's still unlinking
* to be done in the (next frame).
*/
if ((ahcd->ed_rm_list == NULL) ||
HC_IS_RUNNING(hcd->state) == 0)
/*
* disable INTR_SOFI if there are no unlinking to be
* done (in the next frame)
*/
admhc_intr_disable(ahcd, ADMHC_INTR_SOFI);
spin_unlock(&ahcd->lock);
}
#endif
if (HC_IS_RUNNING(hcd->state)) {
admhc_intr_ack(ahcd, ints);
admhc_intr_enable(ahcd, ADMHC_INTR_MIE);
admhc_writel_flush(ahcd);
}
return IRQ_HANDLED;
}
/* Start an OHCI controller, set the BUS operational
* resets USB and controller
* enable interrupts
*/
static int admhc_run(struct admhcd *ahcd)
{
u32 temp;
int first = ahcd->fminterval == 0;
struct usb_hcd *hcd = admhcd_to_hcd(ahcd);
admhc_disable(ahcd);
/* boot firmware should have set this up (5.1.1.3.1) */
if (first) {
temp = admhc_readl(ahcd, &ahcd->regs->fminterval);
ahcd->fminterval = temp & ADMHC_SFI_FI_MASK;
if (ahcd->fminterval != FI)
admhc_dbg(ahcd, "fminterval delta %d\n",
ahcd->fminterval - FI);
ahcd->fminterval |=
(FSLDP(ahcd->fminterval) << ADMHC_SFI_FSLDP_SHIFT);
/* also: power/overcurrent flags in rhdesc */
}
#if 0 /* TODO: not applicable */
/* Reset USB nearly "by the book". RemoteWakeupConnected was
* saved if boot firmware (BIOS/SMM/...) told us it's connected,
* or if bus glue did the same (e.g. for PCI add-in cards with
* PCI PM support).
*/
if ((ahcd->hc_control & OHCI_CTRL_RWC) != 0
&& !device_may_wakeup(hcd->self.controller))
device_init_wakeup(hcd->self.controller, 1);
#endif
switch (ahcd->host_control & ADMHC_HC_BUSS) {
case ADMHC_BUSS_OPER:
temp = 0;
break;
case ADMHC_BUSS_SUSPEND:
/* FALLTHROUGH ? */
case ADMHC_BUSS_RESUME:
ahcd->host_control = ADMHC_BUSS_RESUME;
temp = 10 /* msec wait */;
break;
/* case ADMHC_BUSS_RESET: */
default:
ahcd->host_control = ADMHC_BUSS_RESET;
temp = 50 /* msec wait */;
break;
}
admhc_writel(ahcd, ahcd->host_control, &ahcd->regs->host_control);
/* flush the writes */
admhc_writel_flush(ahcd);
msleep(temp);
temp = admhc_read_rhdesc(ahcd);
if (!(temp & ADMHC_RH_NPS)) {
/* power down each port */
for (temp = 0; temp < ahcd->num_ports; temp++)
admhc_write_portstatus(ahcd, temp, ADMHC_PS_CPP);
}
/* flush those writes */
admhc_writel_flush(ahcd);
/* 2msec timelimit here means no irqs/preempt */
spin_lock_irq(&ahcd->lock);
admhc_writel(ahcd, ADMHC_CTRL_SR, &ahcd->regs->gencontrol);
temp = 30; /* ... allow extra time */
while ((admhc_readl(ahcd, &ahcd->regs->gencontrol) & ADMHC_CTRL_SR) != 0) {
if (--temp == 0) {
spin_unlock_irq(&ahcd->lock);
admhc_err(ahcd, "USB HC reset timed out!\n");
return -1;
}
udelay(1);
}
/* enable HOST mode, before access any host specific register */
admhc_writel(ahcd, ADMHC_CTRL_UHFE, &ahcd->regs->gencontrol);
/* Tell the controller where the descriptor list is */
admhc_writel(ahcd, (u32)ahcd->ed_head->dma, &ahcd->regs->hosthead);
periodic_reinit(ahcd);
/* use rhsc irqs after khubd is fully initialized */
hcd->poll_rh = 1;
hcd->uses_new_polling = 1;
#if 0
/* wake on ConnectStatusChange, matching external hubs */
admhc_writel(ahcd, RH_HS_DRWE, &ahcd->regs->roothub.status);
#else
/* FIXME roothub_write_status (ahcd, ADMHC_RH_DRWE); */
#endif
/* Choose the interrupts we care about now, others later on demand */
admhc_intr_ack(ahcd, ~0);
admhc_intr_enable(ahcd, ADMHC_INTR_INIT);
admhc_writel(ahcd, ADMHC_RH_NPS | ADMHC_RH_LPSC, &ahcd->regs->rhdesc);
/* flush those writes */
admhc_writel_flush(ahcd);
/* start controller operations */
ahcd->host_control = ADMHC_BUSS_OPER;
admhc_writel(ahcd, ahcd->host_control, &ahcd->regs->host_control);
temp = 20;
while ((admhc_readl(ahcd, &ahcd->regs->host_control)
& ADMHC_HC_BUSS) != ADMHC_BUSS_OPER) {
if (--temp == 0) {
spin_unlock_irq(&ahcd->lock);
admhc_err(ahcd, "unable to setup operational mode!\n");
return -1;
}
mdelay(1);
}
hcd->state = HC_STATE_RUNNING;
ahcd->next_statechange = jiffies + STATECHANGE_DELAY;
#if 0
/* FIXME: enabling DMA is always failed here for an unknown reason */
admhc_dma_enable(ahcd);
temp = 200;
while ((admhc_readl(ahcd, &ahcd->regs->host_control)
& ADMHC_HC_DMAE) != ADMHC_HC_DMAE) {
if (--temp == 0) {
spin_unlock_irq(&ahcd->lock);
admhc_err(ahcd, "unable to enable DMA!\n");
admhc_dump(ahcd, 1);
return -1;
}
mdelay(1);
}
#endif
spin_unlock_irq(&ahcd->lock);
mdelay(ADMHC_POTPGT);
return 0;
}
