void
apic_attach(struct elroy_softc *sc)
{
volatile struct elroy_regs *r = sc->sc_regs;
u_int32_t data;
data = apic_read(r, APIC_VERSION);
sc->sc_nints = (data & APIC_VERSION_NENT) >> APIC_VERSION_NENT_SHIFT;
printf(" APIC ver %x, %d pins",
data & APIC_VERSION_MASK, sc->sc_nints);
sc->sc_irq = mallocarray(sc->sc_nints, sizeof(int), M_DEVBUF,
M_NOWAIT | M_ZERO);
if (sc->sc_irq == NULL)
panic("apic_attach: cannot allocate irq table");
apic_get_int_tbl(sc);
#ifdef DEBUG
apic_dump(sc);
#endif
}
void
apic_init (struct cpu * core)
{
struct apic_dev * apic = NULL;
ulong_t base_addr;
uint32_t val;
apic = (struct apic_dev*)malloc(sizeof(struct apic_dev));
if (!apic) {
panic("Could not allocate apic struct\n");
}
memset(apic, 0, sizeof(struct apic_dev));
core->apic = apic;
if (!check_apic_avail()) {
panic("No APIC found on core %u, dying\n", core->id);
}
/* In response to AMD erratum #663
* the damn thing may give us lint interrupts
* even when we have them masked
*/
if (nk_is_amd() && cpuid_get_family() == 0x15) {
APIC_DEBUG("Writing Bridge Ctrl MSR for AMD Errata #663\n");
msr_write(AMD_MSR_NBRIDGE_CTL,
msr_read(AMD_MSR_NBRIDGE_CTL) |
(1ULL<<23) |
(1ULL<<54));
}
base_addr = apic_get_base_addr();
/* idempotent when not compiled as HRT */
apic->base_addr = pa_to_va(base_addr);
#ifndef NAUT_CONFIG_HVM_HRT
if (core->is_bsp) {
/* map in the lapic as uncacheable */
if (nk_map_page_nocache(apic->base_addr, PTE_PRESENT_BIT|PTE_WRITABLE_BIT, PS_4K) == -1) {
panic("Could not map APIC\n");
}
}
#endif
apic->version = apic_get_version(apic);
apic->id = apic_get_id(apic);
#ifndef NAUT_CONFIG_XEON_PHI
if (apic->version < 0x10 || apic->version > 0x15) {
panic("Unsupported APIC version (0x%1x)\n", (unsigned)apic->version);
}
#endif
val = apic_read(apic, APIC_REG_LDR) & ~APIC_LDR_MASK;
val |= SET_APIC_LOGICAL_ID(0);
apic_write(apic, APIC_REG_LDR, val);
apic_write(apic, APIC_REG_TPR, apic_read(apic, APIC_REG_TPR) & 0xffffff00); // accept all interrupts
apic_write(apic, APIC_REG_LVTT, APIC_DEL_MODE_FIXED | APIC_LVT_DISABLED); // disable timer interrupts intially
apic_write(apic, APIC_REG_LVTPC, APIC_DEL_MODE_FIXED | APIC_LVT_DISABLED | APIC_PC_INT_VEC); // disable perf cntr interrupts
apic_write(apic, APIC_REG_LVTTHMR, APIC_DEL_MODE_FIXED | APIC_LVT_DISABLED | APIC_THRML_INT_VEC); // disable thermal interrupts
/* do we have AMD extended LVT entries to deal with */
if (nk_is_amd() && amd_has_ext_lvt(apic)) {
amd_setup_ext_lvt(apic);
}
/* mask 8259a interrupts */
apic_write(apic, APIC_REG_LVT0, APIC_DEL_MODE_EXTINT | APIC_LVT_DISABLED);
/* only BSP takes NMI interrupts */
apic_write(apic, APIC_REG_LVT1,
APIC_DEL_MODE_NMI | (core->is_bsp ? 0 : APIC_LVT_DISABLED));
apic_write(apic, APIC_REG_LVTERR, APIC_DEL_MODE_FIXED | APIC_ERROR_INT_VEC); // allow error interrupts
// clear the ESR
apic_write(apic, APIC_REG_ESR, 0u);
apic_global_enable();
// assign interrupt handlers
if (core->is_bsp) {
if (register_int_handler(APIC_NULL_KICK_VEC, null_kick, apic) != 0) {
panic("Could not register null kick interrupt handler\n");
}
if (register_int_handler(APIC_SPUR_INT_VEC, spur_int_handler, apic) != 0) {
panic("Could not register spurious interrupt handler\n");
}
if (register_int_handler(APIC_ERROR_INT_VEC, error_int_handler, apic) != 0) {
panic("Could not register spurious interrupt handler\n");
return;
}
/* we shouldn't ever get these, but just in case */
if (register_int_handler(APIC_PC_INT_VEC, pc_int_handler, apic) != 0) {
panic("Could not register perf counter interrupt handler\n");
return;
}
if (register_int_handler(APIC_THRML_INT_VEC, thermal_int_handler, apic) != 0) {
panic("Could not register thermal interrupt handler\n");
return;
}
if (register_int_handler(APIC_EXT_LVT_DUMMY_VEC, dummy_int_handler, apic) != 0) {
panic("Could not register dummy ext lvt handler\n");
return;
}
}
apic_assign_spiv(apic, APIC_SPUR_INT_VEC);
/* turn it on */
apic_sw_enable(apic);
/* pass in quantum as milliseconds */
#ifndef NAUT_CONFIG_XEON_PHI
apic_timer_setup(apic, 1000/NAUT_CONFIG_HZ);
#endif
apic_dump(apic);
}
/*
* Enable LAPIC, configure interrupts.
*/
void
lapic_init(boolean_t bsp)
{
uint32_t timer;
u_int temp;
/*
* Install vectors
*
* Since IDT is shared between BSP and APs, these vectors
* only need to be installed once; we do it on BSP.
*/
if (bsp) {
if (cpu_vendor_id == CPU_VENDOR_AMD &&
CPUID_TO_FAMILY(cpu_id) >= 0xf) {
uint32_t tcr;
/*
* Set the LINTEN bit in the HyperTransport
* Transaction Control Register.
*
* This will cause EXTINT and NMI interrupts
* routed over the hypertransport bus to be
* fed into the LAPIC LINT0/LINT1. If the bit
* isn't set, the interrupts will go to the
* general cpu INTR/NMI pins. On a dual-core
* cpu the interrupt winds up going to BOTH cpus.
* The first cpu that does the interrupt ack
* cycle will get the correct interrupt. The
* second cpu that does it will get a spurious
* interrupt vector (typically IRQ 7).
*/
outl(0x0cf8,
(1 << 31) | /* enable */
(0 << 16) | /* bus */
(0x18 << 11) | /* dev (cpu + 0x18) */
(0 << 8) | /* func */
0x68 /* reg */
);
tcr = inl(0xcfc);
if ((tcr & 0x00010000) == 0) {
kprintf("LAPIC: AMD LINTEN on\n");
outl(0xcfc, tcr|0x00010000);
}
outl(0x0cf8, 0);
}
/* Install a 'Spurious INTerrupt' vector */
setidt_global(XSPURIOUSINT_OFFSET, Xspuriousint,
SDT_SYSIGT, SEL_KPL, 0);
/* Install a timer vector */
setidt_global(XTIMER_OFFSET, Xtimer,
SDT_SYSIGT, SEL_KPL, 0);
/* Install an inter-CPU IPI for TLB invalidation */
setidt_global(XINVLTLB_OFFSET, Xinvltlb,
SDT_SYSIGT, SEL_KPL, 0);
/* Install an inter-CPU IPI for IPIQ messaging */
setidt_global(XIPIQ_OFFSET, Xipiq,
SDT_SYSIGT, SEL_KPL, 0);
/* Install an inter-CPU IPI for CPU stop/restart */
setidt_global(XCPUSTOP_OFFSET, Xcpustop,
SDT_SYSIGT, SEL_KPL, 0);
}
/*
* Setup LINT0 as ExtINT on the BSP. This is theoretically an
* aggregate interrupt input from the 8259. The INTA cycle
* will be routed to the external controller (the 8259) which
* is expected to supply the vector.
*
* Must be setup edge triggered, active high.
*
* Disable LINT0 on BSP, if I/O APIC is enabled.
*
* Disable LINT0 on the APs. It doesn't matter what delivery
* mode we use because we leave it masked.
*/
temp = lapic->lvt_lint0;
temp &= ~(APIC_LVT_MASKED | APIC_LVT_TRIG_MASK |
APIC_LVT_POLARITY_MASK | APIC_LVT_DM_MASK);
if (bsp) {
temp |= APIC_LVT_DM_EXTINT;
if (ioapic_enable)
temp |= APIC_LVT_MASKED;
} else {
temp |= APIC_LVT_DM_FIXED | APIC_LVT_MASKED;
}
lapic->lvt_lint0 = temp;
/*
* Setup LINT1 as NMI.
*
* Must be setup edge trigger, active high.
*
* Enable LINT1 on BSP, if I/O APIC is enabled.
*
* Disable LINT1 on the APs.
*/
temp = lapic->lvt_lint1;
temp &= ~(APIC_LVT_MASKED | APIC_LVT_TRIG_MASK |
APIC_LVT_POLARITY_MASK | APIC_LVT_DM_MASK);
temp |= APIC_LVT_MASKED | APIC_LVT_DM_NMI;
if (bsp && ioapic_enable)
temp &= ~APIC_LVT_MASKED;
lapic->lvt_lint1 = temp;
/*
* Mask the LAPIC error interrupt, LAPIC performance counter
* interrupt.
*/
lapic->lvt_error = lapic->lvt_error | APIC_LVT_MASKED;
lapic->lvt_pcint = lapic->lvt_pcint | APIC_LVT_MASKED;
/*
* Set LAPIC timer vector and mask the LAPIC timer interrupt.
*/
timer = lapic->lvt_timer;
timer &= ~APIC_LVTT_VECTOR;
timer |= XTIMER_OFFSET;
timer |= APIC_LVTT_MASKED;
lapic->lvt_timer = timer;
/*
* Set the Task Priority Register as needed. At the moment allow
* interrupts on all cpus (the APs will remain CLId until they are
* ready to deal).
*/
temp = lapic->tpr;
temp &= ~APIC_TPR_PRIO; /* clear priority field */
lapic->tpr = temp;
/*
* Enable the LAPIC
*/
temp = lapic->svr;
temp |= APIC_SVR_ENABLE; /* enable the LAPIC */
temp &= ~APIC_SVR_FOCUS_DISABLE; /* enable lopri focus processor */
/*
* Set the spurious interrupt vector. The low 4 bits of the vector
* must be 1111.
*/
if ((XSPURIOUSINT_OFFSET & 0x0F) != 0x0F)
panic("bad XSPURIOUSINT_OFFSET: 0x%08x", XSPURIOUSINT_OFFSET);
temp &= ~APIC_SVR_VECTOR;
temp |= XSPURIOUSINT_OFFSET;
lapic->svr = temp;
/*
* Pump out a few EOIs to clean out interrupts that got through
* before we were able to set the TPR.
*/
lapic->eoi = 0;
lapic->eoi = 0;
lapic->eoi = 0;
if (bsp) {
lapic_timer_calibrate();
if (lapic_timer_enable) {
cputimer_intr_register(&lapic_cputimer_intr);
cputimer_intr_select(&lapic_cputimer_intr, 0);
}
} else {
lapic_timer_set_divisor(lapic_timer_divisor_idx);
}
if (bootverbose)
apic_dump("apic_initialize()");
}
