void setup_system_regs(struct net_device *dev)
{
unsigned short sysctl;
/*
* Odd word alignment for Receive Frame DMA word
* Configure checksum support and rcve frame word alignment
*/
sysctl = bfin_read_EMAC_SYSCTL();
#if defined(BFIN_MAC_CSUM_OFFLOAD)
sysctl |= RXDWA | RXCKS;
#else
sysctl |= RXDWA;
#endif
bfin_write_EMAC_SYSCTL(sysctl);
bfin_write_EMAC_MMC_CTL(RSTC | CROLL);
/* Initialize the TX DMA channel registers */
bfin_write_DMA2_X_COUNT(0);
bfin_write_DMA2_X_MODIFY(4);
bfin_write_DMA2_Y_COUNT(0);
bfin_write_DMA2_Y_MODIFY(0);
/* Initialize the RX DMA channel registers */
bfin_write_DMA1_X_COUNT(0);
bfin_write_DMA1_X_MODIFY(4);
bfin_write_DMA1_Y_COUNT(0);
bfin_write_DMA1_Y_MODIFY(0);
}
void setup_system_regs(struct net_device *dev)
{
unsigned short sysctl;
sysctl = bfin_read_EMAC_SYSCTL();
#if defined(BFIN_MAC_CSUM_OFFLOAD)
sysctl |= RXDWA | RXCKS;
#else
sysctl |= RXDWA;
#endif
bfin_write_EMAC_SYSCTL(sysctl);
bfin_write_EMAC_MMC_CTL(RSTC | CROLL);
bfin_write_DMA2_X_COUNT(0);
bfin_write_DMA2_X_MODIFY(4);
bfin_write_DMA2_Y_COUNT(0);
bfin_write_DMA2_Y_MODIFY(0);
bfin_write_DMA1_X_COUNT(0);
bfin_write_DMA1_X_MODIFY(4);
bfin_write_DMA1_Y_COUNT(0);
bfin_write_DMA1_Y_MODIFY(0);
}
static int bfin_miiphy_init(struct eth_device *dev, int *opmode)
{
const unsigned short pins[] = CONFIG_BFIN_MAC_PINS;
u16 phydat;
size_t count;
/* Enable PHY output */
bfin_write_VR_CTL(bfin_read_VR_CTL() | CLKBUFOE);
/* Set all the pins to peripheral mode */
peripheral_request_list(pins, "bfin_mac");
/* Odd word alignment for Receive Frame DMA word */
/* Configure checksum support and rcve frame word alignment */
bfin_write_EMAC_SYSCTL(RXDWA | RXCKS | SET_MDCDIV(MDC_FREQ_TO_DIV(CONFIG_PHY_CLOCK_FREQ)));
/* turn on auto-negotiation and wait for link to come up */
bfin_miiphy_write(dev->name, CONFIG_PHY_ADDR, MII_BMCR, BMCR_ANENABLE);
count = 0;
while (1) {
++count;
if (bfin_miiphy_read(dev->name, CONFIG_PHY_ADDR, MII_BMSR, &phydat))
return -1;
if (phydat & BMSR_LSTATUS)
break;
if (count > 30000) {
printf("%s: link down, check cable\n", dev->name);
return -1;
}
udelay(100);
}
/* see what kind of link we have */
if (bfin_miiphy_read(dev->name, CONFIG_PHY_ADDR, MII_LPA, &phydat))
return -1;
if (phydat & LPA_DUPLEX)
*opmode = FDMODE;
else
*opmode = 0;
bfin_write_EMAC_MMC_CTL(RSTC | CROLL);
/* Initialize the TX DMA channel registers */
bfin_write_DMA2_X_COUNT(0);
bfin_write_DMA2_X_MODIFY(4);
bfin_write_DMA2_Y_COUNT(0);
bfin_write_DMA2_Y_MODIFY(0);
/* Initialize the RX DMA channel registers */
bfin_write_DMA1_X_COUNT(0);
bfin_write_DMA1_X_MODIFY(4);
bfin_write_DMA1_Y_COUNT(0);
bfin_write_DMA1_Y_MODIFY(0);
return 0;
}
static void setup_system_regs(struct net_device *dev)
{
struct bfin_mac_local *lp = netdev_priv(dev);
int i;
unsigned short sysctl;
/*
* Odd word alignment for Receive Frame DMA word
* Configure checksum support and rcve frame word alignment
*/
sysctl = bfin_read_EMAC_SYSCTL();
/*
* check if interrupt is requested for any PHY,
* enable PHY interrupt only if needed
*/
for (i = 0; i < PHY_MAX_ADDR; ++i)
if (lp->mii_bus->irq[i] != PHY_POLL)
break;
if (i < PHY_MAX_ADDR)
sysctl |= PHYIE;
sysctl |= RXDWA;
#if defined(BFIN_MAC_CSUM_OFFLOAD)
sysctl |= RXCKS;
#else
sysctl &= ~RXCKS;
#endif
bfin_write_EMAC_SYSCTL(sysctl);
bfin_write_EMAC_MMC_CTL(RSTC | CROLL);
/* Set vlan regs to let 1522 bytes long packets pass through */
bfin_write_EMAC_VLAN1(lp->vlan1_mask);
bfin_write_EMAC_VLAN2(lp->vlan2_mask);
/* Initialize the TX DMA channel registers */
bfin_write_DMA2_X_COUNT(0);
bfin_write_DMA2_X_MODIFY(4);
bfin_write_DMA2_Y_COUNT(0);
bfin_write_DMA2_Y_MODIFY(0);
/* Initialize the RX DMA channel registers */
bfin_write_DMA1_X_COUNT(0);
bfin_write_DMA1_X_MODIFY(4);
bfin_write_DMA1_Y_COUNT(0);
bfin_write_DMA1_Y_MODIFY(0);
}
static void setup_system_regs(struct net_device *dev)
{
struct bfin_mac_local *lp = netdev_priv(dev);
int i;
unsigned short sysctl;
sysctl = bfin_read_EMAC_SYSCTL();
for (i = 0; i < PHY_MAX_ADDR; ++i)
if (lp->mii_bus->irq[i] != PHY_POLL)
break;
if (i < PHY_MAX_ADDR)
sysctl |= PHYIE;
sysctl |= RXDWA;
#if defined(BFIN_MAC_CSUM_OFFLOAD)
sysctl |= RXCKS;
#else
sysctl &= ~RXCKS;
#endif
bfin_write_EMAC_SYSCTL(sysctl);
bfin_write_EMAC_MMC_CTL(RSTC | CROLL);
bfin_write_EMAC_VLAN1(lp->vlan1_mask);
bfin_write_EMAC_VLAN2(lp->vlan2_mask);
bfin_write_DMA2_X_COUNT(0);
bfin_write_DMA2_X_MODIFY(4);
bfin_write_DMA2_Y_COUNT(0);
bfin_write_DMA2_Y_MODIFY(0);
bfin_write_DMA1_X_COUNT(0);
bfin_write_DMA1_X_MODIFY(4);
bfin_write_DMA1_Y_COUNT(0);
bfin_write_DMA1_Y_MODIFY(0);
}
