static void __init bravo_init(void)
{
int ret;
printk("bravo_init() revision=%d\n", system_rev);
if (is_cdma_version(system_rev))
smd_set_channel_list(smd_cdma_default_channels,
ARRAY_SIZE(smd_cdma_default_channels));
msm_hw_reset_hook = bravo_reset;
if (is_cdma_version(system_rev))
msm_acpu_clock_init(&bravo_cdma_clock_data);
else
msm_acpu_clock_init(&bravo_clock_data);
msm_serial_debug_init(MSM_UART1_PHYS, INT_UART1,
&msm_device_uart1.dev, 1, MSM_GPIO_TO_INT(139));
config_gpio_table(misc_gpio_table, ARRAY_SIZE(misc_gpio_table));
if (is_cdma_version(system_rev)) {
bcm_bt_lpm_pdata.gpio_wake = BRAVO_CDMA_GPIO_BT_WAKE;
bravo_flashlight_data.torch = BRAVO_CDMA_GPIO_FLASHLIGHT_TORCH;
config_gpio_table(bt_gpio_table_rev_CX, ARRAY_SIZE(bt_gpio_table_rev_CX));
} else {
config_gpio_table(bt_gpio_table, ARRAY_SIZE(bt_gpio_table));
}
gpio_request(BRAVO_GPIO_TP_LS_EN, "tp_ls_en");
gpio_direction_output(BRAVO_GPIO_TP_LS_EN, 0);
gpio_request(BRAVO_GPIO_TP_EN, "tp_en");
gpio_direction_output(BRAVO_GPIO_TP_EN, 0);
// gpio_request(BRAVO_GPIO_PROXIMITY_EN, "proximity_en");
// gpio_direction_output(BRAVO_GPIO_PROXIMITY_EN, 1);
gpio_request(BRAVO_GPIO_LS_EN_N, "ls_en");
gpio_request(BRAVO_GPIO_COMPASS_RST_N, "compass_rst");
gpio_direction_output(BRAVO_GPIO_COMPASS_RST_N, 1);
gpio_request(BRAVO_GPIO_COMPASS_INT_N, "compass_int");
gpio_direction_input(BRAVO_GPIO_COMPASS_INT_N);
gpio_request(BRAVO_GPIO_DS2482_SLP_N, "ds2482_slp_n");
/* set the gpu power rail to manual mode so clk en/dis will not
* turn off gpu power, and hang it on resume */
bravo_kgsl_power_rail_mode(0);
bravo_kgsl_power(true);
msm_device_hsusb.dev.platform_data = &msm_hsusb_pdata;
msm_device_uart_dm1.dev.platform_data = &msm_uart_dm1_pdata;
platform_add_devices(devices, ARRAY_SIZE(devices));
i2c_register_board_info(0, base_i2c_devices,
ARRAY_SIZE(base_i2c_devices));
if (is_cdma_version(system_rev)) {
i2c_register_board_info(0, rev_CX_i2c_devices,
ARRAY_SIZE(rev_CX_i2c_devices));
}
ret = bravo_init_mmc(system_rev, debug_uart);
if (ret != 0)
pr_crit("%s: Unable to initialize MMC\n", __func__);
bravo_audio_init();
bravo_headset_init();
platform_device_register(&bravo_timed_gpios);
ds2784_battery_init();
serialno_setup(board_serialno());
}
static void __init mahimahi_init(void)
{
int ret;
struct kobject *properties_kobj;
printk("mahimahi_init() revision=%d\n", system_rev);
if (is_cdma_version(system_rev))
smd_set_channel_list(smd_cdma_default_channels,
ARRAY_SIZE(smd_cdma_default_channels));
msm_hw_reset_hook = mahimahi_reset;
if (is_cdma_version(system_rev))
msm_acpu_clock_init(&mahimahi_cdma_clock_data);
else
msm_acpu_clock_init(&mahimahi_clock_data);
msm_serial_debug_init(MSM_UART1_PHYS, INT_UART1,
&msm_device_uart1.dev, 1, MSM_GPIO_TO_INT(139));
config_gpio_table(misc_gpio_table, ARRAY_SIZE(misc_gpio_table));
if (is_cdma_version(system_rev)) {
bcm_bt_lpm_pdata.gpio_wake = MAHIMAHI_CDMA_GPIO_BT_WAKE;
mahimahi_flashlight_data.torch = MAHIMAHI_CDMA_GPIO_FLASHLIGHT_TORCH;
config_gpio_table(bt_gpio_table_rev_CX, ARRAY_SIZE(bt_gpio_table_rev_CX));
} else {
config_gpio_table(bt_gpio_table, ARRAY_SIZE(bt_gpio_table));
}
gpio_request(MAHIMAHI_GPIO_TP_LS_EN, "tp_ls_en");
gpio_direction_output(MAHIMAHI_GPIO_TP_LS_EN, 0);
gpio_request(MAHIMAHI_GPIO_TP_EN, "tp_en");
gpio_direction_output(MAHIMAHI_GPIO_TP_EN, 0);
gpio_request(MAHIMAHI_GPIO_PROXIMITY_EN, "proximity_en");
gpio_direction_output(MAHIMAHI_GPIO_PROXIMITY_EN, 1);
gpio_request(MAHIMAHI_GPIO_COMPASS_RST_N, "compass_rst");
gpio_direction_output(MAHIMAHI_GPIO_COMPASS_RST_N, 1);
gpio_request(MAHIMAHI_GPIO_COMPASS_INT_N, "compass_int");
gpio_direction_input(MAHIMAHI_GPIO_COMPASS_INT_N);
gpio_request(MAHIMAHI_GPIO_DS2482_SLP_N, "ds2482_slp_n");
/* set the gpu power rail to manual mode so clk en/dis will not
* turn off gpu power, and hang it on resume */
mahimahi_kgsl_power_rail_mode(0);
mahimahi_kgsl_power(true);
msm_device_hsusb.dev.platform_data = &msm_hsusb_pdata;
msm_device_uart_dm1.dev.platform_data = &msm_uart_dm1_pdata;
platform_add_devices(devices, ARRAY_SIZE(devices));
i2c_register_board_info(0, base_i2c_devices,
ARRAY_SIZE(base_i2c_devices));
if (system_rev == 0) {
/* Only board after XB with Audience A1026 */
i2c_register_board_info(0, rev0_i2c_devices,
ARRAY_SIZE(rev0_i2c_devices));
}
if (system_rev > 0) {
/* Only board after XB with Audience A1026 */
i2c_register_board_info(0, rev1_i2c_devices,
ARRAY_SIZE(rev1_i2c_devices));
}
if (is_cdma_version(system_rev)) {
/* Only CDMA version with TI TPA2018D1 Speaker Amp. */
i2c_register_board_info(0, rev_CX_i2c_devices,
ARRAY_SIZE(rev_CX_i2c_devices));
if ((system_rev & 0x0F) == 0x00) {
a1026_data.gpio_a1026_clk = MAHIMAHI_CDMA_XA_AUD_A1026_CLK;
} else if ((system_rev & 0x0F) >= 0x01) {
a1026_data.gpio_a1026_wakeup = MAHIMAHI_CDMA_XB_AUD_A1026_WAKEUP;
a1026_data.gpio_a1026_reset = MAHIMAHI_CDMA_XB_AUD_A1026_RESET;
a1026_data.gpio_a1026_clk = MAHIMAHI_CDMA_XB_AUD_A1026_CLK;
}
}
ret = mahimahi_init_mmc(system_rev, debug_uart);
if (ret != 0)
pr_crit("%s: Unable to initialize MMC\n", __func__);
properties_kobj = kobject_create_and_add("board_properties", NULL);
if (properties_kobj)
ret = sysfs_create_group(properties_kobj,
&mahimahi_properties_attr_group);
if (!properties_kobj || ret)
pr_err("failed to create board_properties\n");
mahimahi_audio_init();
mahimahi_headset_init();
if (system_rev > 0)
platform_device_register(&mahimahi_timed_gpios);
else
msm_init_pmic_vibrator();
ds2784_battery_init();
}
static void __init htcleo_init(void)
{
#ifdef CONFIG_HTCLEO_BLINK_AT_BOOT
volatile unsigned *bank6_in, *bank6_out;
#endif
printk("htcleo_init()\n");
msm_hw_reset_hook = htcleo_reset;
#ifdef CONFIG_PERFLOCK
perflock_init(&htcleo_perflock_data);
#endif
msm_serial_debug_init(MSM_UART1_PHYS, INT_UART1,
&msm_device_uart1.dev, 1, MSM_GPIO_TO_INT(139));
// config_gpio_table(misc_gpio_table, ARRAY_SIZE(misc_gpio_table));
config_gpio_table(bt_gpio_table, ARRAY_SIZE(bt_gpio_table));
gpio_request(HTCLEO_GPIO_TP_LS_EN, "tp_ls_en");
gpio_direction_output(HTCLEO_GPIO_TP_LS_EN, 0);
gpio_request(HTCLEO_GPIO_TP_EN, "tp_en");
gpio_direction_output(HTCLEO_GPIO_TP_EN, 0);
// gpio_request(HTCLEO_GPIO_PROXIMITY_EN, "proximity_en");
// gpio_direction_output(HTCLEO_GPIO_PROXIMITY_EN, 1);
gpio_request(HTCLEO_GPIO_LS_EN_N, "ls_en");
gpio_request(HTCLEO_GPIO_COMPASS_RST_N, "compass_rst");
gpio_direction_output(HTCLEO_GPIO_COMPASS_RST_N, 1);
gpio_request(HTCLEO_GPIO_COMPASS_INT_N, "compass_int");
gpio_direction_input(HTCLEO_GPIO_COMPASS_INT_N);
gpio_request(HTCLEO_GPIO_DS2482_SLP_N, "ds2482_slp_n");
/* set the gpu power rail to manual mode so clk en/dis will not
* turn off gpu power, and hang it on resume */
htcleo_kgsl_power_rail_mode(0);
htcleo_kgsl_power(true);
msm_device_hsusb.dev.platform_data = &msm_hsusb_pdata;
msm_device_uart_dm1.dev.platform_data = &msm_uart_dm1_pdata;
platform_add_devices(devices, ARRAY_SIZE(devices));
i2c_register_board_info(0, base_i2c_devices,
ARRAY_SIZE(base_i2c_devices));
if (htcleo_init_mmc(system_rev, debug_uart) != 0)
pr_crit("%s: Unable to initialize MMC\n", __func__);
htcleo_audio_init();
htcleo_headset_init();
platform_device_register(&htcleo_timed_gpios);
ds2784_battery_init();
msm_acpu_clock_init(&htcleo_clock_data);
//} what's this??
#ifdef CONFIG_SERIAL_MSM_HS
msm_device_uart_dm1.dev.platform_data = &msm_uart_dm1_pdata;
msm_device_uart_dm1.name = "msm_serial_hs"; /* for bcm */
msm_device_uart_dm1.resource[3].end = 6;
#endif
config_gpio_table(bt_gpio_table, ARRAY_SIZE(bt_gpio_table));
// bt_export_bd_address();
htcleo_audio_init();
// msm_device_i2c_init();
/* set the gpu power rail to manual mode so clk en/dis will not
* turn off gpu power, and hang it on resume */
htcleo_kgsl_power_rail_mode(0);
htcleo_kgsl_power(false);
mdelay(100);
htcleo_kgsl_power(true);
platform_add_devices(devices, ARRAY_SIZE(devices));
htcleo_init_panel();
i2c_register_board_info(0, base_i2c_devices, ARRAY_SIZE(base_i2c_devices));
#ifdef CONFIG_USB_ANDROID
// htcleo_add_usb_devices();
#endif
// htcleo_init_mmc(0);
platform_device_register(&htcleo_timed_gpios);
/* Blink the camera LED shortly to show that we're alive! */
#ifdef CONFIG_HTCLEO_BLINK_AT_BOOT
bank6_in = (unsigned int*)(MSM_GPIO1_BASE + 0x0864);
bank6_out = (unsigned int*)(MSM_GPIO1_BASE + 0x0814);
*bank6_out = *bank6_in ^ 0x200000;
mdelay(50);
*bank6_out = *bank6_in | 0x200000;
mdelay(200);
#endif
}
