static int stmpe811_interrupt(int irq, FAR void *context)
{
FAR struct stmpe811_dev_s *priv;
FAR struct stmpe811_config_s *config;
int ret;
/* Which STMPE811 device caused the interrupt? */
#ifndef CONFIG_STMPE811_MULTIPLE
priv = &g_stmpe811;
#else
for (priv = g_stmpe811list;
priv && priv->config->irq != irq;
priv = priv->flink);
ASSERT(priv != NULL);
#endif
/* Get a pointer the callbacks for convenience (and so the code is not so
* ugly).
*/
config = priv->config;
DEBUGASSERT(config != NULL);
/* Disable further interrupts */
config->enable(config, false);
/* Check if interrupt work is already queue. If it is already busy, then
* we already have interrupt processing in the pipeline and we need to do
* nothing more.
*/
if (work_available(&priv->work))
{
/* Yes.. Transfer processing to the worker thread. Since STMPE811
* interrupts are disabled while the work is pending, no special
* action should be required to protect the work queue.
*/
ret = work_queue(HPWORK, &priv->work, stmpe811_worker, priv, 0);
if (ret != 0)
{
illdbg("Failed to queue work: %d\n", ret);
}
}
/* Clear any pending interrupts and return success */
config->clear(config);
return OK;
}
void stmpe811_gpioworker(FAR struct stmpe811_dev_s *priv)
{
uint8_t regval;
uint8_t pinmask;
int pin;
/* Get the set of pending GPIO interrupts */
regval = stmpe811_getreg8(priv, STMPE811_GPIO_INTSTA);
/* Look at each pin */
for (pin = 0; pin < STMPE811_GPIO_NPINS; pin++)
{
pinmask = GPIO_INT(pin);
if ((regval & pinmask) != 0)
{
/* Check if we have a handler for this interrupt (there should
* be one)
*/
if (priv->handlers[pin])
{
/* Interrupt is pending... dispatch the interrupt to the
* callback
*/
priv->handlers[pin](pin);
}
else
{
illdbg("No handler for PIN%d, GPIO_INTSTA: %02x\n", pin, regval);
}
/* Clear the pending GPIO interrupt by writing a '1' to the
* pin position in the status register.
*/
stmpe811_putreg8(priv, STMPE811_GPIO_INTSTA, pinmask);
}
}
}
static int ads7843e_schedule(FAR struct ads7843e_dev_s *priv)
{
FAR struct ads7843e_config_s *config;
int ret;
/* Get a pointer the callbacks for convenience (and so the code is not so
* ugly).
*/
config = priv->config;
DEBUGASSERT(config != NULL);
/* Disable further interrupts. ADS7843E interrupts will be re-enabled
* after the worker thread executes.
*/
config->enable(config, false);
/* Disable the watchdog timer. It will be re-enabled in the worker thread
* while the pen remains down.
*/
wd_cancel(priv->wdog);
/* Transfer processing to the worker thread. Since ADS7843E interrupts are
* disabled while the work is pending, no special action should be required
* to protected the work queue.
*/
DEBUGASSERT(priv->work.worker == NULL);
ret = work_queue(HPWORK, &priv->work, ads7843e_worker, priv, 0);
if (ret != 0)
{
illdbg("Failed to queue work: %d\n", ret);
}
return OK;
}
