static void __init msm_device_i2c_init(void)
{
msm_i2c_gpio_init();
if(tp_type == 1)
msm_i2c_pdata.reset_slave = marvel_ts_cy8c_reset;
msm_device_i2c.dev.platform_data = &msm_i2c_pdata;
}
static void __init heroc_init(void)
{
int rc;
printk(KERN_INFO "heroc_init() revision=%d\n", system_rev);
config_gpios();
// gpio_request(HEROC_GPIO_H2W_POWER, "heroc_gpio_h2w_power");
// gpio_request(HEROC_GPIO_CABLE_IN2, "heroc_gpio_cable_in2");
gpio_request(HEROC_GPIO_AUD_EXTMIC_SEL, "heroc_gpio_aud_extmic_sel");
msm_hw_reset_hook = heroc_reset;
msm_acpu_clock_init(&heroc_clock_data);
perflock_init(&heroc_perflock_data);
#if defined(CONFIG_MSM_SERIAL_DEBUGGER)
if (!opt_disable_uart3)
msm_serial_debug_init(MSM_UART3_PHYS, INT_UART3,
&msm_device_uart3.dev, 1, INT_UART3_RX);
#endif
#ifdef CONFIG_SERIAL_MSM_HS
msm_device_uart_dm1.dev.platform_data = &msm_uart_dm1_pdata;
#endif
msm_device_hsusb.dev.platform_data = &msm_hsusb_pdata;
msm_init_pmic_vibrator(3000);
rc = heroc_init_mmc(system_rev);
if (rc)
printk(KERN_CRIT "%s: MMC init failure (%d)\n", __func__, rc);
msm_i2c_gpio_init();
msm_device_i2c.dev.platform_data = &heroc_i2c_device_data;
/* for (rc=0;rc<ARRAY_SIZE(i2c_devices);rc++){
if (!strcmp(i2c_devices[rc].type,AKM8973_I2C_NAME)){
if (!system_rev)
i2c_devices[rc].irq = 0x1E; //XA
else
i2c_devices[rc].irq = 0x1C;
}
}
if(system_rev < 2) {
microp_data.num_pins = ARRAY_SIZE(microp_pins_0);
microp_data.pin_config = microp_pins_0;
} */
i2c_register_board_info(0, i2c_devices, ARRAY_SIZE(i2c_devices));
platform_add_devices(devices, ARRAY_SIZE(devices));
clear_bluetooth_rx_irq_status();
// heroc_init_panel();
}
static void __init msm_device_i2c_init(void)
{
msm_i2c_gpio_init();
msm_device_i2c.dev.platform_data = &msm_i2c_pdata;
}
static void __init hero_init(void)
{
int rc;
printk("hero_init() revision = 0x%X\n", system_rev);
android_usb_pdata.serial_number = board_serialno();
/*
* Setup common MSM GPIOS
*/
config_gpios();
msm_hw_reset_hook = hero_reset;
gpio_request(HERO_TP_LS_EN, "tp_ls_en");
gpio_direction_output(HERO_TP_LS_EN, 0);
gpio_request(HERO_GPIO_EXT_3V_EN, "hero_gpio_ext_3v_en");
gpio_request(HERO_GPIO_CABLE_IN2, "hero_gpio_cable_in2");
gpio_request(HERO_GPIO_AUD_EXTMIC_SEL, "hero_gpio_aud_extmic_sel");
msm_acpu_clock_init(&hero_clock_data);
perflock_init(&hero_perflock_data);
#if defined(CONFIG_MSM_SERIAL_DEBUGGER)
if (!opt_disable_uart3)
msm_serial_debug_init(MSM_UART3_PHYS, INT_UART3,
&msm_device_uart3.dev, 1, INT_UART3_RX);
#endif
#ifdef CONFIG_SERIAL_MSM_HS
msm_device_uart_dm1.dev.platform_data = &msm_uart_dm1_pdata;
#endif
msm_device_hsusb.dev.platform_data = &msm_hsusb_pdata;
msm_init_pmic_vibrator(3000);
rc = hero_init_mmc(system_rev);
if (rc)
printk(KERN_CRIT "%s: MMC init failure (%d)\n", __func__, rc);
msm_i2c_gpio_init();
msm_device_i2c.dev.platform_data = &hero_i2c_device_data;
if (system_rev == 0 || system_rev == 1) {
for (rc = 0; rc < ARRAY_SIZE(i2c_devices); rc++) {
if (!strcmp(i2c_devices[rc].type, MICROP_I2C_NAME))
i2c_devices[rc].irq = MSM_GPIO_TO_INT(HERO_GPIO_UP_INT_N_XAXB);
if (!strcmp(i2c_devices[rc].type, AKM8973_I2C_NAME))
i2c_devices[rc].irq = MSM_GPIO_TO_INT(HERO_GPIO_COMPASS_INT_N_XAXB);
}
} else if (system_rev == 2 || system_rev == 3) /*XC and XD*/
hero_h2w.dev.platform_data = &hero_h2w_data_xc;
else /*above XE*/
hero_h2w.dev.platform_data = &hero_h2w_data_xe;
if (hero_engineerid() || system_rev > 2) {
if (system_rev >= 4) {
microp_data.num_pins = ARRAY_SIZE(microp_pins_skuid_3);
microp_data.pin_config = microp_pins_skuid_3;
} else if (system_rev == 3) {
microp_data.num_pins = ARRAY_SIZE(microp_pins_skuid_2);
microp_data.pin_config = microp_pins_skuid_2;
} else {
microp_data.num_pins = ARRAY_SIZE(microp_pins_skuid_1);
microp_data.pin_config = microp_pins_skuid_1;
}
microp_data.cabc_backlight_enable = 1;
}
i2c_register_board_info(0, i2c_devices, ARRAY_SIZE(i2c_devices));
platform_add_devices(devices, ARRAY_SIZE(devices));
hero_init_panel();
}
