C++ (Cpp) omap1_map_common_io Examples

Example #1

File: board-htcherald.c Project: Bdaman80/BDA-ACTV

static void __init htcherald_map_io(void)
{
	omap1_map_common_io();

	/*
	 * The LCD panel must be disabled and DMA turned off here, as doing
	 * it later causes the LCD never to reinitialize.
	 */
	htcherald_lcd_init();

	printk(KERN_INFO "htcherald_map_io done.\n");
}

Example #2

File: board-htcoxygen.c Project: nandra/omap_850_kernel

/*
 * Init functions from here on
 */
static void __init htcoxygen_map_io(void)
{
	omap1_map_common_io();
	printk("htcoxygen_map_io done.\n");

#ifdef CONFIG_EFB_DEBUG
	efb_enable();
#endif
	htcoxygen_lcd_init();

	/* Reserve GSM Memory */
	reserve_bootmem(WIZARD_GSM_PHYS_START, WIZARD_GSM_PHYS_SIZE, 0);
}

Example #3

File: board-innovator.c Project: egonalter/R-Link_kernel

static void __init innovator_map_io(void)
{
	omap1_map_common_io();

#ifdef CONFIG_ARCH_OMAP15XX
	if (cpu_is_omap1510()) {
		iotable_init(innovator1510_io_desc, ARRAY_SIZE(innovator1510_io_desc));
		udelay(10);	/* Delay needed for FPGA */

		/* Dump the Innovator FPGA rev early - useful info for support. */
		printk("Innovator FPGA Rev %d.%d Board Rev %d\n",
		       fpga_read(OMAP1510_FPGA_REV_HIGH),
		       fpga_read(OMAP1510_FPGA_REV_LOW),
		       fpga_read(OMAP1510_FPGA_BOARD_REV));
	}
#endif
}

Example #4

static void __init innovator_map_io(void)
{
	omap1_map_common_io();

#ifdef CONFIG_ARCH_OMAP15XX
	if (cpu_is_omap1510()) {
		iotable_init(innovator1510_io_desc, ARRAY_SIZE(innovator1510_io_desc));
		udelay(10);	

		
		printk("Innovator FPGA Rev %d.%d Board Rev %d\n",
		       fpga_read(OMAP1510_FPGA_REV_HIGH),
		       fpga_read(OMAP1510_FPGA_REV_LOW),
		       fpga_read(OMAP1510_FPGA_BOARD_REV));
	}
#endif
}

Example #5

File: board-perseus2.c Project: Broadcom/stblinux-2.6.18

static void __init omap_perseus2_map_io(void)
{
	omap1_map_common_io();
	iotable_init(omap_perseus2_io_desc,
		     ARRAY_SIZE(omap_perseus2_io_desc));

	/* Early, board-dependent init */

	/*
	 * Hold GSM Reset until needed
	 */
	omap_writew(omap_readw(OMAP730_DSP_M_CTL) & ~1, OMAP730_DSP_M_CTL);

	/*
	 * UARTs -> done automagically by 8250 driver
	 */

	/*
	 * CSx timings, GPIO Mux ... setup
	 */

	/* Flash: CS0 timings setup */
	omap_writel(0x0000fff3, OMAP730_FLASH_CFG_0);
	omap_writel(0x00000088, OMAP730_FLASH_ACFG_0);

	/*
	 * Ethernet support through the debug board
	 * CS1 timings setup
	 */
	omap_writel(0x0000fff3, OMAP730_FLASH_CFG_1);
	omap_writel(0x00000000, OMAP730_FLASH_ACFG_1);

	/*
	 * Configure MPU_EXT_NIRQ IO in IO_CONF9 register,
	 * It is used as the Ethernet controller interrupt
	 */
	omap_writel(omap_readl(OMAP730_IO_CONF_9) & 0x1FFFFFFF, OMAP730_IO_CONF_9);
}

Example #6

File: io.c Project: ClarkChen633/am335x-linux

void __init omap7xx_map_io(void)
{
	omap1_map_common_io();
	iotable_init(omap7xx_io_desc, ARRAY_SIZE(omap7xx_io_desc));
}

Example #7

File: board-palmte.c Project: AppEngine/linux-2.6

static void __init omap_palmte_map_io(void)
{
	omap1_map_common_io();
}

Example #8

File: board-osk.c Project: ForayJones/iods

static void __init osk_map_io(void)
{
	omap1_map_common_io();
}

Example #9

File: board-ams-delta.c Project: PennPanda/linux-repo

static void __init ams_delta_map_io(void)
{
	omap1_map_common_io();
}

Example #10

File: board-nokia770.c Project: GerardGarcia/linux

static void __init omap_nokia770_map_io(void)
{
	omap1_map_common_io();
}

Example #11

File: board-voiceblue.c Project: PennPanda/linux-repo

static void __init voiceblue_map_io(void)
{
	omap1_map_common_io();
}

Example #12

File: board-generic.c Project: JudeBake/linux-am33x

static void __init omap_generic_map_io(void)
{
	omap1_map_common_io();
}