/* Runs on IST stack */
dotraplinkage void do_stack_segment(struct pt_regs *regs, long error_code)
{
if (notify_die(DIE_TRAP, "stack segment", regs, error_code,
12, SIGBUS) == NOTIFY_STOP)
return;
preempt_conditional_sti(regs);
do_trap(12, SIGBUS, "stack segment", regs, error_code, NULL);
preempt_conditional_cli(regs);
}
/*
* Our handling of the processor debug registers is non-trivial.
* We do not clear them on entry and exit from the kernel. Therefore
* it is possible to get a watchpoint trap here from inside the kernel.
* However, the code in ./ptrace.c has ensured that the user can
* only set watchpoints on userspace addresses. Therefore the in-kernel
* watchpoint trap can only occur in code which is reading/writing
* from user space. Such code must not hold kernel locks (since it
* can equally take a page fault), therefore it is safe to call
* force_sig_info even though that claims and releases locks.
*
* Code in ./signal.c ensures that the debug control register
* is restored before we deliver any signal, and therefore that
* user code runs with the correct debug control register even though
* we clear it here.
*
* Being careful here means that we don't have to be as careful in a
* lot of more complicated places (task switching can be a bit lazy
* about restoring all the debug state, and ptrace doesn't have to
* find every occurrence of the TF bit that could be saved away even
* by user code)
*
* May run on IST stack.
*/
dotraplinkage void __kprobes do_debug(struct pt_regs *regs, long error_code)
{
struct task_struct *tsk = current;
unsigned long dr6;
int si_code;
get_debugreg(dr6, 6);
/* Catch kmemcheck conditions first of all! */
if ((dr6 & DR_STEP) && kmemcheck_trap(regs))
return;
/* DR6 may or may not be cleared by the CPU */
set_debugreg(0, 6);
/*
* The processor cleared BTF, so don't mark that we need it set.
*/
clear_tsk_thread_flag(tsk, TIF_DEBUGCTLMSR);
tsk->thread.debugctlmsr = 0;
/* Store the virtualized DR6 value */
tsk->thread.debugreg6 = dr6;
if (notify_die(DIE_DEBUG, "debug", regs, PTR_ERR(&dr6), error_code,
SIGTRAP) == NOTIFY_STOP)
return;
/* It's safe to allow irq's after DR6 has been saved */
preempt_conditional_sti(regs);
if (regs->flags & X86_VM_MASK) {
handle_vm86_trap((struct kernel_vm86_regs *) regs,
error_code, 1);
return;
}
/*
* Single-stepping through system calls: ignore any exceptions in
* kernel space, but re-enable TF when returning to user mode.
*
* We already checked v86 mode above, so we can check for kernel mode
* by just checking the CPL of CS.
*/
if ((dr6 & DR_STEP) && !user_mode(regs)) {
tsk->thread.debugreg6 &= ~DR_STEP;
set_tsk_thread_flag(tsk, TIF_SINGLESTEP);
regs->flags &= ~X86_EFLAGS_TF;
}
si_code = get_si_code(tsk->thread.debugreg6);
if (tsk->thread.debugreg6 & (DR_STEP | DR_TRAP_BITS))
send_sigtrap(tsk, regs, error_code, si_code);
preempt_conditional_cli(regs);
return;
}
/* May run on IST stack. */
dotraplinkage void __kprobes do_int3(struct pt_regs *regs, long error_code)
{
#ifdef CONFIG_KPROBES
if (notify_die(DIE_INT3, "int3", regs, error_code, 3, SIGTRAP)
== NOTIFY_STOP)
return;
#else
if (notify_die(DIE_TRAP, "int3", regs, error_code, 3, SIGTRAP)
== NOTIFY_STOP)
return;
#endif
preempt_conditional_sti(regs);
do_trap(3, SIGTRAP, "int3", regs, error_code, NULL);
preempt_conditional_cli(regs);
}
/*
* Our handling of the processor debug registers is non-trivial.
* We do not clear them on entry and exit from the kernel. Therefore
* it is possible to get a watchpoint trap here from inside the kernel.
* However, the code in ./ptrace.c has ensured that the user can
* only set watchpoints on userspace addresses. Therefore the in-kernel
* watchpoint trap can only occur in code which is reading/writing
* from user space. Such code must not hold kernel locks (since it
* can equally take a page fault), therefore it is safe to call
* force_sig_info even though that claims and releases locks.
*
* Code in ./signal.c ensures that the debug control register
* is restored before we deliver any signal, and therefore that
* user code runs with the correct debug control register even though
* we clear it here.
*
* Being careful here means that we don't have to be as careful in a
* lot of more complicated places (task switching can be a bit lazy
* about restoring all the debug state, and ptrace doesn't have to
* find every occurrence of the TF bit that could be saved away even
* by user code)
*
* May run on IST stack.
*/
dotraplinkage void __kprobes do_debug(struct pt_regs *regs, long error_code)
{
struct task_struct *tsk = current;
unsigned long condition;
int si_code;
get_debugreg(condition, 6);
/*
* The processor cleared BTF, so don't mark that we need it set.
*/
clear_tsk_thread_flag(tsk, TIF_DEBUGCTLMSR);
tsk->thread.debugctlmsr = 0;
if (notify_die(DIE_DEBUG, "debug", regs, condition, error_code,
SIGTRAP) == NOTIFY_STOP)
return;
/* It's safe to allow irq's after DR6 has been saved */
preempt_conditional_sti(regs);
/* Mask out spurious debug traps due to lazy DR7 setting */
if (condition & (DR_TRAP0|DR_TRAP1|DR_TRAP2|DR_TRAP3)) {
if (!tsk->thread.debugreg7)
goto clear_dr7;
}
#ifdef CONFIG_X86_32
if (regs->flags & X86_VM_MASK)
goto debug_vm86;
#endif
/* Save debug status register where ptrace can see it */
tsk->thread.debugreg6 = condition;
/*
* Single-stepping through TF: make sure we ignore any events in
* kernel space (but re-enable TF when returning to user mode).
*/
if (condition & DR_STEP) {
if (!user_mode(regs))
goto clear_TF_reenable;
}
si_code = get_si_code(condition);
/* Ok, finally something we can handle */
send_sigtrap(tsk, regs, error_code, si_code);
/*
* Disable additional traps. They'll be re-enabled when
* the signal is delivered.
*/
clear_dr7:
set_debugreg(0, 7);
preempt_conditional_cli(regs);
return;
#ifdef CONFIG_X86_32
debug_vm86:
/* reenable preemption: handle_vm86_trap() might sleep */
dec_preempt_count();
handle_vm86_trap((struct kernel_vm86_regs *) regs, error_code, 1);
conditional_cli(regs);
return;
#endif
clear_TF_reenable:
set_tsk_thread_flag(tsk, TIF_SINGLESTEP);
regs->flags &= ~X86_EFLAGS_TF;
preempt_conditional_cli(regs);
return;
}
