int s5p_mfc_wakeup(struct s5p_mfc_dev *dev)
{
int ret;
mfc_debug_enter();
/* 0. MFC reset */
mfc_debug(2, "MFC reset...\n");
s5p_mfc_clock_on();
ret = s5p_mfc_reset(dev);
if (ret) {
mfc_err("Failed to reset MFC - timeout.\n");
return ret;
}
mfc_debug(2, "Done MFC reset...\n");
/* 1. Set DRAM base Addr */
s5p_mfc_init_memctrl(dev);
/* 2. Initialize registers of channel I/F */
s5p_mfc_clear_cmds(dev);
s5p_mfc_clean_dev_int_flags(dev);
/* 3. Initialize firmware */
ret = s5p_mfc_wakeup_cmd(dev);
if (ret) {
mfc_err("Failed to send command to MFC - timeout.\n");
return ret;
}
/* 4. Release reset signal to the RISC */
if (IS_MFCV6(dev))
s5p_mfc_write_reg(0x1, S5P_FIMV_RISC_ON);
else
s5p_mfc_write_reg(0x3ff, S5P_FIMV_SW_RESET);
mfc_debug(2, "Ok, now will write a command to wakeup the system\n");
if (s5p_mfc_wait_for_done_dev(dev, S5P_FIMV_R2H_CMD_WAKEUP_RET)) {
mfc_err("Failed to load firmware\n");
return -EIO;
}
s5p_mfc_clock_off();
dev->int_cond = 0;
if (dev->int_err != 0 || dev->int_type !=
S5P_FIMV_R2H_CMD_WAKEUP_RET) {
/* Failure. */
mfc_err("Failed to wakeup - error: %d"
" int: %d.\n",dev->int_err, dev->int_type);
return -EIO;
}
mfc_debug_leave();
return 0;
}
int s5p_mfc_wakeup(struct s5p_mfc_dev *dev)
{
int ret;
mfc_debug_enter();
mfc_debug(2, "MFC reset..\n");
s5p_mfc_clock_on();
ret = s5p_mfc_reset(dev);
if (ret) {
mfc_err("Failed to reset MFC - timeout\n");
return ret;
}
mfc_debug(2, "Done MFC reset..\n");
s5p_mfc_init_memctrl(dev);
s5p_mfc_clear_cmds(dev);
s5p_mfc_clean_dev_int_flags(dev);
ret = s5p_mfc_wakeup_cmd(dev);
if (ret) {
mfc_err("Failed to send command to MFC - timeout\n");
return ret;
}
mfc_write(dev, 0x3ff, S5P_FIMV_SW_RESET);
mfc_debug(2, "Ok, now will write a command to wakeup the system\n");
if (s5p_mfc_wait_for_done_dev(dev, S5P_FIMV_R2H_CMD_WAKEUP_RET)) {
mfc_err("Failed to load firmware\n");
return -EIO;
}
s5p_mfc_clock_off();
dev->int_cond = 0;
if (dev->int_err != 0 || dev->int_type !=
S5P_FIMV_R2H_CMD_WAKEUP_RET) {
mfc_err("Failed to wakeup - error: %d int: %d\n", dev->int_err,
dev->int_type);
return -EIO;
}
mfc_debug_leave();
return 0;
}
int s5p_mfc_wakeup(struct s5p_mfc_dev *dev)
{
enum mfc_buf_usage_type buf_type;
int ret;
mfc_debug_enter();
if (!dev) {
mfc_err("no mfc device to run\n");
return -EINVAL;
}
mfc_info_dev("curr_ctx_drm:%d\n", dev->curr_ctx_drm);
dev->wakeup_status = 1;
/* Set clock source again after wake up */
s5p_mfc_set_clock_parent(dev);
/* 0. MFC reset */
mfc_debug(2, "MFC reset...\n");
s5p_mfc_clock_on(dev);
dev->wakeup_status = 0;
/* SYSMMU default block mode (not enalble/disable) */
if (dev->curr_ctx_drm) {
ret = s5p_mfc_mem_resume(dev->alloc_ctx[0]);
if (ret < 0)
mfc_err_dev("Failed to attach iommu\n");
s5p_mfc_mem_suspend(dev->alloc_ctx[0]);
}
ret = s5p_mfc_reset(dev);
if (ret) {
mfc_err_dev("Failed to reset MFC - timeout.\n");
goto err_mfc_wakeup;
}
mfc_debug(2, "Done MFC reset...\n");
if (dev->curr_ctx_drm)
buf_type = MFCBUF_DRM;
else
buf_type = MFCBUF_NORMAL;
/* 1. Set DRAM base Addr */
s5p_mfc_init_memctrl(dev, buf_type);
/* 2. Initialize registers of channel I/F */
s5p_mfc_clear_cmds(dev);
s5p_mfc_clean_dev_int_flags(dev);
/* 3. Initialize firmware */
if (!FW_WAKEUP_AFTER_RISC_ON(dev))
ret = s5p_mfc_wakeup_cmd(dev);
if (ret) {
mfc_err_dev("Failed to send command to MFC - timeout.\n");
goto err_mfc_wakeup;
}
/* 4. Release reset signal to the RISC */
if (IS_MFCV6(dev))
s5p_mfc_write_reg(dev, 0x1, S5P_FIMV_RISC_ON);
else
s5p_mfc_write_reg(dev, 0x3ff, S5P_FIMV_SW_RESET);
mfc_debug(2, "Will now wait for completion of firmware transfer.\n");
if (FW_WAKEUP_AFTER_RISC_ON(dev)) {
if (s5p_mfc_wait_for_done_dev(dev, S5P_FIMV_R2H_CMD_FW_STATUS_RET)) {
mfc_err_dev("Failed to load firmware.\n");
s5p_mfc_clean_dev_int_flags(dev);
ret = -EIO;
goto err_mfc_wakeup;
}
}
if (FW_WAKEUP_AFTER_RISC_ON(dev))
ret = s5p_mfc_wakeup_cmd(dev);
mfc_debug(2, "Ok, now will write a command to wakeup the system\n");
if (s5p_mfc_wait_for_done_dev(dev, S5P_FIMV_R2H_CMD_WAKEUP_RET)) {
mfc_err_dev("Failed to load firmware\n");
ret = -EIO;
goto err_mfc_wakeup;
}
dev->int_cond = 0;
if (dev->int_err != 0 || dev->int_type !=
S5P_FIMV_R2H_CMD_WAKEUP_RET) {
/* Failure. */
mfc_err_dev("Failed to wakeup - error: %d"
" int: %d.\n", dev->int_err, dev->int_type);
ret = -EIO;
goto err_mfc_wakeup;
}
err_mfc_wakeup:
s5p_mfc_clock_off(dev);
mfc_debug_leave();
return 0;
}
int s5p_mfc_wakeup(struct s5p_mfc_dev *dev)
{
int ret;
mfc_debug_enter();
if (!dev) {
mfc_err("no mfc device to run\n");
return -EINVAL;
}
/* 0. MFC reset */
mfc_debug(2, "MFC reset...\n");
s5p_mfc_clock_on(dev);
ret = s5p_mfc_reset(dev);
if (ret) {
mfc_err_dev("Failed to reset MFC - timeout.\n");
goto err_mfc_wakeup;
}
mfc_debug(2, "Done MFC reset...\n");
/* 1. Set DRAM base Addr */
s5p_mfc_init_memctrl(dev, MFCBUF_NORMAL);
/* 2. Initialize registers of channel I/F */
s5p_mfc_clear_cmds(dev);
s5p_mfc_clean_dev_int_flags(dev);
/* 3. Initialize firmware */
if (!IS_OVER_MFCv78(dev))
ret = s5p_mfc_wakeup_cmd(dev);
if (ret) {
mfc_err_dev("Failed to send command to MFC - timeout.\n");
goto err_mfc_wakeup;
}
/* 4. Release reset signal to the RISC */
if (IS_MFCV6(dev))
s5p_mfc_write_reg(dev, 0x1, S5P_FIMV_RISC_ON);
else
s5p_mfc_write_reg(dev, 0x3ff, S5P_FIMV_SW_RESET);
mfc_debug(2, "Will now wait for completion of firmware transfer.\n");
if (s5p_mfc_wait_for_done_dev(dev, S5P_FIMV_R2H_CMD_FW_STATUS_RET)) {
mfc_err_dev("Failed to load firmware.\n");
s5p_mfc_clean_dev_int_flags(dev);
ret = -EIO;
goto err_mfc_wakeup;
}
if (IS_OVER_MFCv78(dev))
ret = s5p_mfc_wakeup_cmd(dev);
mfc_debug(2, "Ok, now will write a command to wakeup the system\n");
if (s5p_mfc_wait_for_done_dev(dev, S5P_FIMV_R2H_CMD_WAKEUP_RET)) {
mfc_err_dev("Failed to load firmware\n");
ret = -EIO;
goto err_mfc_wakeup;
}
dev->int_cond = 0;
if (dev->int_err != 0 || dev->int_type !=
S5P_FIMV_R2H_CMD_WAKEUP_RET) {
/* Failure. */
mfc_err_dev("Failed to wakeup - error: %d"
" int: %d.\n", dev->int_err, dev->int_type);
ret = -EIO;
goto err_mfc_wakeup;
}
err_mfc_wakeup:
s5p_mfc_clock_off(dev);
mfc_debug_leave();
return 0;
}
